Menifee, CA

Upon arrival performed diagnostic. Found system to be on but no compresssor, found secondary motor control out of range. Replaced and got system running. System is operational .

Upon arrival performed diagnostic. Found system to be on but no compresssor, found secondary motor control out of range. Replaced and got system running. System is operational .

Upon arrival performed diagnostic. Found system to be on but no compresssor, found secondary motor control out of range. Replaced and got system running. System is operational .

Upon arrival performed diagnostic. Found system to be on but no compresssor, found secondary motor control out of range. Replaced and got system running. System is operational .

Preformed Ac diagnostic on 2004 Lennox condenser. Upon my diagnostic client stated the system was no longer cooling home and may be due previous company Working on the system. Begin at outdoor unit and found that compressor and fan are operational. Proceeded to check refrigerant pressures and found that it contained R 22 which was completely banned and phased out January 1, 2020. Pressures we’re completely flat and zero psi was present inside the lines indicating that there is a major leak somewhere within the refrigeration cycle. Contactor was severely burnt and pitted due to it running with no refrigerant. Explained to George that we can repair it although the cost of it Would not be cost effective due to the old age of it. He also had mentioned he did have another company That was supposed to be installing a new system although they failed to confirmed a date to do so. Due to the high heat load in the house and the week only getting hotter We were able to provide options for long-

Quality control check

Tech arrived on site. Unit was having Intermittent issues. It would shut down randomly. Opened furnace up and the door switch came off. Had been rigged by someone else. Bypassed the switch and will order new one. Went into the attic and checked for voltage. Had line power but no control voltage at low voltage terminals. Transformer was good. Checked connections. All were good. Diagnosed the board to be back. Replaced with universal board on van stock. Unit is now cooling and had airflow.

Tech arrived on site. Found the upstairs unit to be providing low airflow to the kids rooms. Discovered the ducts to be undersized. The kids rooms shared about 500 cfm for all of them. Gave quoted for new ducts as well as more cost effective options. Homeowners wanted to explore new equipment pricing before making a decision.

Replaced defective rice secondary control for the compressor. Tested system and recorded voltages, amp draws and indoor temperatures. Inspected filter and monitored operation.

Arrived on site to perform spring tune up on a Unknown age system. Looks to be original to home as it’s really old. Condenser located in back yard. Furnace located in hall closet. Client stated he’s had systems patched up and bandaids on system in past years to get the most of life out of unit. Washed condenser inside and out. Primary was burnt up and needs to be replaced. Secondary motor control was replaced and just held above electrical compartment with tape and left apart as it was found. Fan motor leaking oil and is dried up. Motor could fail at any time in future. Conor start up are high due to old age. Run amps is pulling 13.5 and max rated at 16 and compressor is on borrowed time and could fail at any time advised not to sure of it will last till next year. Client has had many repairs in past as well had unit charged up with R-22 by a guy who used to do repairs. In past. Now is trying to have a company come out and maintenance at a call per need bases. Filter is a cut to f

Arrived on site to perform spring tune up on a 2014 lennox unit. Client stated no issues. Condenser located in back yard furnace and Evaporator coil Located in garage. Found filter dirty and he stated he would order his own and replace once they got here but he is planning on selling home. Washed condenser inside and out. Primary was good secondary control was good. Fan was good and in range of amps. Compressor did have almost max start up amps. Recommend adding compressor booster kit. Run amps are good. System is cooling at 19 degrees. Indoor unit blower assembly and whee dose have dust and debris. Would recommend adding and whole house purifying system to help better the air quality I home and system. No protection on either unit. Went over all findings and recommendations with client. Client is aware of how system is running and conditions client did declined recommended work at this time. Since he plans to sell home. Client did renew for ESA. Cycled wya to ensure operating. System

Performed AC diagnostic on 1988 comfort maker Condenser. Upon my diagnostic client stated that system is operational but was not keeping up like how are used to. He said he recently replaced the filter and had his handyman come out and look at it and fill it up with R22 refrigerant last year. I confirm that the indoor system is operational and thermostat is calling for cooling and then proceeded to the outdoor unit and found that compressor and fan are operational. Measure refrigerant pressures and found that the system was completely flat and has sprung a major leak somewhere within the condenser or evaporator coil. I advised him that R22 was completely phased out January 1, 2020 and that the cost of repair May not be cost effective due to the age of the system. Scheduled for a supervisor to return and go over system options. Upon deparutr system is completely out of R22 refrigerant.

Performed furnace and AC maintenance on a Lennox system. Systems heating temperature split is 30 degrees. Flame sensor and limit switches are in range. Ignitor is in range. Indoor blower is clean, filter is ok. Systems cooling temperature split is 24 degrees. Condensate lines are clear. Duct runs are ok. Outdoor coils was heavily caked in dirt. They were chemically cleaned today. Outdoor compressor needs an assist kit due to the length of the refrigerant lines. Refrigerant levels are ok. System was cycled before leaving.

Arrived on site to diagnose smell in home in a 2001 unit. Spoke to tenant and they started noticing this funky smell in home about 6 months ago. Tenant stated it’s a plaster smell when using both heating and cooling. Advised home owner I would inspect attic and unit. Found filter to not be the right size and is allowing dirt to enter system. Found correct size and replaced. Found unit to be original to hole and is dirty due to past tenants in past years and the poor filtration the has been used since. Cycled both heating and cooling and did not get a smell just smelled like paint. Advised the summary of findings is as followed. 1. 2001 unit original to home. 2. Wrong size filter and dirt entering unit. 3. Unit is dirty from year of operation as property is a rental. 4. Gray flex ducting used with poor connections and gray flex layer faing part from age. 5. Furnace is not secured and is sitting on bricks. 5. Found evaporator coil to be a slab style coil. There are no longer m

Installation of a Variable Speed Comfort Pro X-Series A/C Only, Including Condenser & Coil.

Arrived fed to perform spring tune up on a 2018 lennox unit. Client has been living in home for 2 years and wanted system serviced. Condenser in back yard. Furnace and Evaporator coil located in attic. Client stated no issues. Just some rooms not cooling as good as other but room both get sun risk and sun set of the heat waves due to locate of home. Client is aware and dose understand. Washed condenser coil inside and out. Primary control and secondary control are both good and in range. Fan motor is good and range. Compressor start up and run amps are good. Recommend adding a compressor booster kit to help prolong life of compressor and run easier. Refrigerant pressures are good. Cycled unit. Replaced filter and system was cooling home at 20 degrees. Went over al finding and recommendations with client. Client did hold off on repairs. But. Did sign up on esa plan. Client is aware of how system is running it’s condition. Cycled system to ensure system operating. System is operational

Performed AC diagnostic on 2011 carrier Condenser. Call my diagnostic client stated that system continuously runs and is operational but does not cool down home. Verified that indoor blower motor and condenser are running. Found that refrigerant levels were very low on R410a condenser. This is due to a leak somewhere within the refrigeration cycle. James would like the system charged up for the meanwhile to get the house cooled down due to the high temperature inside and a leak dye injected so that we may return in about a month to search for it. Charged system up two proper subcool and temperature split of 18°. Advised James that leak is still present and pressures could change next time we return due to it leaking. Once we determine where the leak is a a leak repair cost will be presented to completely stopping this issue. Upon departure system is fully operational and cooling

Tech arrived on site. Suction line and compressor were icing up. Filter was restricted. Evap coil is in accessible at this time. Water was leaking from the coil. Possible cracked drain pan. Refrigerant readings indicated an airflow restriction. Will be sending quotes to pull the heat exchanger and clean the evap coil.

Performed diagnostic on Unit. Homeowner has another company add zoning to his system. System is original to the home and is a single stage unit with a single stage furnace. System is broken down into three separate zones. After fully evaluating unit, system is not designed to be zoned off. There is only one return to the unit, and master bedroom zone is too small for it to be working by itself. A bypass and dump zone were added, but even that is not sufficient enough for it to operate normally. Recommend either downsizing down to only two zones, or do some ducting modifications. Ultimately a single stage unit should never be zoned and will be very difficult for it to ever work properly. Variable speed and two stage equipment is needed in order to design a properly working efficient zoning system.

Customer will not be home. Needs to reschedule.

Pay by Check

arrived on site to perform spring tune up on 2 2006 airflo units. Condenser both in back yard. Furnace and Evaporator coils located in attic. Client stated no issues. Client was no home as it was just his sister there and would be doing tune up with her. She advised she is not the primary decision maker at this time. Washed both condenser coils inside and out as units are really dirty and had dirty in unit. Found primary start control to both be black and burnt up from putting. Found secondary motor control border line bad to upstairs unit. Downstairs are good. Both fan motor have very little oil on shaft. Upstairs is over amping pulling 1.0 and max rated for 0.7. Downstairs is pulling max amps at 1.1. Advised motor are running hard and could fail. Start ups amps are good on upstairs as it also had a compressor booster kit. Downstairs unit dose not and start ups are in range but recommended adding one to unit to prolong life of unit. Found both systems to have good pressure and coolin

Tech arrived on site. Found line wire burnt on the unit. Contractor was melted. Installed new contractor, however compressor wouldn’t kick over. Homeowners decided to replace the system.

Performed combo tune up on 20 year old system. Cycledy system through heating and cooling modes. Checked indoor and outdoor unit electrical and system components. Performed outdoor condenser coil wash as well as indoor unit safety check. Unit is operational in both heating and cooling modes, but system does have some concerns which are as follows: 1. Indoor unit does not have sediment gas trap on gas line. Also condensation safety switches are not present on drain lines, and evaporator coil does not have a emergency drain pan underneath to prevent any water damage if there is ever a restriction in lines. 2. Indoor blower motor has started to leak oil. 3. Safety inspected heat exchanger. Last chamber of heat exchanger on bottom has a crack that is starting to form, has not made it all the way through at this time. 4. Temperature rise across heat exchanger is going above rated maximum. 5. Outdoor condenser fan motor has started to leak oil, and amp draws are above limit 6. Compressor i

Tech arrived on site, unit was operational at this time. Started checking start components. Found the duel cap in the condenser to be within range. But reading over what it’s rated for. All others motor amps were within range. Charge is good. Temp split is good. Blower cap is reading weak. Replaced it with new one. Unit is cooling properly at this time.