Menifee, CA

Performed a leak dye search on 2012 Day and night condenser. on my search Client stated that system has been cooling well ever since my last visit. Started off at outdoor condensing unit to search for any leak dye and found no evidence of it. Verified refrigerant pressures were still in a good range right now. Proceeded to attic to verify that evaporator coil condition. Opened up Plenum coil and found that there were three leaks present inside of it unfortunately. Due to the leaks being present on the aluminum area of the coil, it must be replaced as a whole. A new evaporator coil will include a five year warranty one year labor, full refrigerant charge for system, Pressurization of nitrogen and full vacuum on system. Will be sending over repair information for evaporator coil well client will need some time to prepare for this repair. Advised client There is an evaporator coil shortage at the moment. Ultimately the sooner the better we are notified so that we are able to get a coil th

100% complete. Tested cooling. Grabbed portable AC

Upon arrival performed check up, client was concerned that system didn’t kick on the other night, but kicked on today and perfectly fine. Refrigerant levels are in range. Condenser fan motor was leaking extreme amounts of oil. Replaced with new motor. Found primary start to be pitted extremely bad, replaced with new starter. Added booster kit, compressor is starting off with high amperages. Did a full system cleaning inside of furnace, pulled and sanitized blower wheel. System was reset tested and fully functional upon departure .

Upon arrival performed check up, client was concerned that system didn’t kick on the other night, but kicked on today and perfectly fine. Refrigerant levels are in range. Condenser fan motor was leaking extreme amounts of oil. Replaced with new motor. Found primary start to be pitted extremely bad, replaced with new starter. Added booster kit, compressor is starting off with high amperages. Did a full system cleaning inside of furnace, pulled and sanitized blower wheel. System was reset tested and fully functional upon departure .

Upon arrival performed check up, client was concerned that system didn’t kick on the other night, but kicked on today and perfectly fine. Refrigerant levels are in range. Condenser fan motor was leaking extreme amounts of oil. Replaced with new motor. Found primary start to be pitted extremely bad, replaced with new starter. Added booster kit, compressor is starting off with high amperages. Did a full system cleaning inside of furnace, pulled and sanitized blower wheel. System was reset tested and fully functional upon departure .

Upon arrival performed check up, client was concerned that system didn’t kick on the other night, but kicked on today and perfectly fine. Refrigerant levels are in range. Condenser fan motor was leaking extreme amounts of oil. Replaced with new motor. Found primary start to be pitted extremely bad, replaced with new starter. Added booster kit, compressor is starting off with high amperages. Did a full system cleaning inside of furnace, pulled and sanitized blower wheel. System was reset tested and fully functional upon departure .

Post job walk

Performed AC diagnostic on Lennox system. On my diagnostic client stated that one system was running it was causing power surges through the home that would make the Internet go out along with the cable. Proceeded to main breaker And found that one wire did have a loose connection which can potentially cause power surges in the home. All other wiring was confirmed to be secure and had a proper connection. System Now has 25° split In home and is cooling. Upon departure system is operational and cooling

Upon arrival performed diagnostic on Goodman condenser. Found compressor not kicking on. Found secondary motor control to be out of range. Replaced with a standard part, comes with a 1 year part & labor . Declined membership. Compressor is starting with high amperages on kick. Advised client would be good to add booster kit.

Upon arrival performed diagnostic on Goodman condenser. Found compressor not kicking on. Found secondary motor control to be out of range. Replaced with a standard part, comes with a 1 year part & labor . Declined membership. Compressor is starting with high amperages on kick. Advised client would be good to add booster kit.

Upon arrival performed diagnostic on Goodman condenser. Found compressor not kicking on. Found secondary motor control to be out of range. Replaced with a standard part, comes with a 1 year part & labor . Declined membership. Compressor is starting with high amperages on kick. Advised client would be good to add booster kit.

Upon arrival performed diagnostic on Goodman condenser. Found compressor not kicking on. Found secondary motor control to be out of range. Replaced with a standard part, comes with a 1 year part & labor . Declined membership. Compressor is starting with high amperages on kick. Advised client would be good to add booster kit.

Performed AC diagnostic on 1990 AC system. Upon Emmanuel stated that the system has been non-operational for the past two years ever since he’s moved in. 1. System was flat on one side which was the suction side and the liquid line had about 30 psi inside of it. This is an indication that the system has a huge refrigerant leak somewhere within the refrigeration cycle. 2. System Contained R22 refrigerant which Was completely phased out on January 1, 2020 3. High voltage distributor Contained a major pitting on contact points And low-voltage coil was emitting a very loud buzzing noise from it becoming weak. 4. Thermostat wire is chewed up on the outdoor unit 5. Compressor is showing signs of failure due to it opening and closing on it’s overload. Also creates a loud grinding noise once on. Compressor is pretty much failing at this point. 6. Amperage on fan and compressor Are exceeding manufacture specifications. Discussed full condition of system with client and he understands wha

Performed AC maintenance on a 2017 Carrier condenser. Systems cooling temperature split is 21 degrees. Primary blower is clean and amping ok. Duct runs are sealed. Condensate lines are clear. Outdoor coils were chemically washed. Compressor and fan amperages are in range. Refrigerant levels are ok. System was cycled before leaving.

Cleared primary drain line, removed both lines to ensure they are properly connected. Sealed with pipe mastic. Pressurized primary line to clear to outside drain. Added a zip tie to improve the slope of the primary drain line.

Installation of a 19 SEER Slimline Variable Speed Air Conditioner with Variable Speed Furnace, HEPA Filtration, Dampers, and Registers

Tech arrived on site and came out on a second opinion. Other company quoted them leak dye. Checked charge and found it was good. Pressures were high due to the condenser coils being dirty. Leak dye was already in the system. Compressor amps are high. Cap was reading weak. Couldn’t figure out how to turn thermostat on, and sounded like homeowners were struggling with it also. Bypassed it so it would turn on for testing. Gave quotes for recommended repairs.

Pay by check

Quality control check

Tech arrived on site. Unit was operational. Checked charge. Sub cooling was 9. Data plate called for 10 +- 3. Super heat was 45. Temp split was Added 2 lbs and 5 oz of R410A refrigerant. Sub cooling increased to 13. Super heat dropped to 25. Temp split is 14. Tested txv but dunking the sensing bulb into ice water. The valve would open and close. Could not determine if it’s restricted. Airflow is good. Coils are clean. Getting quality control manager out to check findings.

Performed diagnostic on 10 year old unit. Met with homeowners parents. System is icing over. Found a extremely clogged filter in filter compartment and another filter inside return register. Also found a couple different supply registers closed throughout the home. Removed filter and opened supply registers. Let system run and monitored refrigerant pressures. Refrigerant pressures are in range and system is producing proper temperature split. System is operating normally dirty filter and closed registers were causing it to ice over. Spoke to homeowner over the phone and they would like someone to come out for replacement options to maybe redesign the system because they like to keep it cold inside the home and current unit is never going to reach their comfort levels. Scheduling turnover for next week on Darren. System is operational upon departure.

Tech arrived on site. Unit would shut down randomly. Opened filter cabinet and found it restricted. Checked float switch and found it had water in it. Flushed out condensate line and replaced the filter. Unit is cooling at this time.

Performed post job walk

Complete system replacement.

Furnace qualifies for a $500 clean air rebate