Menifee, CA

Collected $1000 deposit. balance due on the completion of installation

Summer AC Maintenance Performed Upon arrival system is working and operational. I began my maintenance at the outdoor condenser by removing the panels and cleaning with water and coil solutions. I inspected electrical components for wear and tight connections. Tested amp draws on system. Checked and measured refrigerant pressures and charge. Upon inspection of outdoor unit, I found the secondary motor control to be below its rated working values as well as the starter was heavily pitted and showed signs of arcing. Upon recommendation member replaced both pieces of equipment. I then proceeded to the indoor heat pump. I measured temp split. Checked condensates and safety switches for functionality. Changed filter. Inspected blower wheel housing for proper balance and dust. Inspected ducts for leakage. Ensured electrical connections were tight. Upon departure system is working and operational.

Upon arrival perform maintenance on hvac system. Circuit board has burn spots on terminals. Secondary motor controls are both out of range for indoor units. Blower wheels are dirty and need some cleanings. Washed outdoor coils. Condenser fan motors are leaking excessive oil. Secondary outdoor motor controls outside are good. Hardstart kits in working order. Refrigerant levels are in range. 1. Dirty blower wheels 2. Secondary motor controls out of range. 3. Condenser fan motors leaking excessive oil Systems are operational, have a few parts that need attention. Client is aware of how system is operating. Signed client up with ESA CLUB.

Upon arrival perform maintenance on hvac system. Circuit board has burn spots on terminals. Secondary motor controls are both out of range for indoor units. Blower wheels are dirty and need some cleanings. Washed outdoor coils. Condenser fan motors are leaking excessive oil. Secondary outdoor motor controls outside are good. Hardstart kits in working order. Refrigerant levels are in range. 1. Dirty blower wheels 2. Secondary motor controls out of range. 3. Condenser fan motors leaking excessive oil Systems are operational, have a few parts that need attention. Client is aware of how system is operating. Signed client up with ESA CLUB.

Upon arrival perform maintenance on hvac system. Circuit board has burn spots on terminals. Secondary motor controls are both out of range for indoor units. Blower wheels are dirty and need some cleanings. Washed outdoor coils. Condenser fan motors are leaking excessive oil. Secondary outdoor motor controls outside are good. Hardstart kits in working order. Refrigerant levels are in range. 1. Dirty blower wheels 2. Secondary motor controls out of range. 3. Condenser fan motors leaking excessive oil Systems are operational, have a few parts that need attention. Client is aware of how system is operating. Signed client up with ESA CLUB.

Upon arrival perform maintenance on hvac system. Circuit board has burn spots on terminals. Secondary motor controls are both out of range for indoor units. Blower wheels are dirty and need some cleanings. Washed outdoor coils. Condenser fan motors are leaking excessive oil. Secondary outdoor motor controls outside are good. Hardstart kits in working order. Refrigerant levels are in range. 1. Dirty blower wheels 2. Secondary motor controls out of range. 3. Condenser fan motors leaking excessive oil Systems are operational, have a few parts that need attention. Client is aware of how system is operating. Signed client up with ESA CLUB.

Perform condensate leak repair. Upon my diagnostic client stated that he had just recently noticed the secondary drain line from the top of the house was beginning to leak water when the AC was running. Verified the primary drain line was clogged up at P-trap inside of the attic and also the P-trap under the sink in the bathroom. Inspected the primary pan inside evaporator coil and could not find any signs of cracks. Preformed cut and clear and ran dry nitrogen to clear any restrictions within the primary PVC line. Primed line also and verify that it was draining correctly back to the sink. Recommended that they signed up on a maintenance plan to keep system at standard and prevent this from happening again but he will discuss this with his wife whether or not they would like to renew their membership. Upon departure your drain lines are clear.

Cleaned outdoor condenser coil, inspected evaporator coil and replaced filter.

Summer AC Maintenance performed Upon arrival systems are working and operational. I began my maintenance at the outdoor condenser, cleaned with water and coil solution. Inspected all electrical components for wear and tight connections, tested amp draws on systems. Checked and measured refrigerant charge and pressures. Upon inspection of outdoor units both condenser fan motors are leaking oil and close to over amping, both secondary motor controls are well below there rated values. Disconnects are fuseless with no form of protection. Compressors were using high amps on start up. Recommend replacing motor controls and condenser fans, and adding surge protection to ensure longevity of unit as well as a compressor saver kit to lower amps on system. I then proceeded to the indoor furnace unit. Checked electrical to ensure tight connections as well as inspected components. Checked condensates for proper drainage. Inspected blower housing for dust and proper balance. Checked filters, do not

Upon arrival performed maintenance on hvac system. Indoor blower wheel is completely caked up. Indoor coil is completely restricted and is covered in tons of dirt and debree. Filter was replaced. Outdoor system coils were covered and dirty, cleaned system out. Tested secondary motor control, verified part is weak. Compressor start amps are 112 amperages, compressor has running amps of 20amps consistency. This is running extremely hard, this can cause high energy bills or tripped breakers. Client would like drain re routed to side of home, just did concrete in back yard and doesn’t want water going there. Thermostat is not in the best working condition. Primary drain pan is has lots of rust inside. System is operational upon departure. Jay to come out tomorrow and give replacement options. - secondary motor control weak - evap coil restricted -dirty blower wheel - compressor running extremely hard

Upon arrival performed maintenance on hvac system. Indoor blower wheel is completely caked up. Indoor coil is completely restricted and is covered in tons of dirt and debree. Filter was replaced. Outdoor system coils were covered and dirty, cleaned system out. Tested secondary motor control, verified part is weak. Compressor start amps are 112 amperages, compressor has running amps of 20amps consistency. This is running extremely hard, this can cause high energy bills or tripped breakers. Client would like drain re routed to side of home, just did concrete in back yard and doesn’t want water going there. Thermostat is not in the best working condition. Primary drain pan is has lots of rust inside. System is operational upon departure. Jay to come out tomorrow and give replacement options. - secondary motor control weak - evap coil restricted -dirty blower wheel - compressor running extremely hard

Upon arrival performed maintenance on hvac system. Indoor blower wheel is completely caked up. Indoor coil is completely restricted and is covered in tons of dirt and debree. Filter was replaced. Outdoor system coils were covered and dirty, cleaned system out. Tested secondary motor control, verified part is weak. Compressor start amps are 112 amperages, compressor has running amps of 20amps consistency. This is running extremely hard, this can cause high energy bills or tripped breakers. Client would like drain re routed to side of home, just did concrete in back yard and doesn’t want water going there. Thermostat is not in the best working condition. Primary drain pan is has lots of rust inside. System is operational upon departure. Jay to come out tomorrow and give replacement options. - secondary motor control weak - evap coil restricted -dirty blower wheel - compressor running extremely hard

Upon arrival performed maintenance on hvac system. Indoor blower wheel is completely caked up. Indoor coil is completely restricted and is covered in tons of dirt and debree. Filter was replaced. Outdoor system coils were covered and dirty, cleaned system out. Tested secondary motor control, verified part is weak. Compressor start amps are 112 amperages, compressor has running amps of 20amps consistency. This is running extremely hard, this can cause high energy bills or tripped breakers. Client would like drain re routed to side of home, just did concrete in back yard and doesn’t want water going there. Thermostat is not in the best working condition. Primary drain pan is has lots of rust inside. System is operational upon departure. Jay to come out tomorrow and give replacement options. - secondary motor control weak - evap coil restricted -dirty blower wheel - compressor running extremely hard

Arrived on site to diagnose a no cooling 2000 system. Upon arrival spoke to client and she stated unit is not working but blowing hot air. Cycled unit and found outside no operational. Inspected electrical compartment and components found primary burnt up. Secondary was bad as it was completely bad. Advised I would bend to replace to continue testing unit and provide a full system evaluation. Replaced part and test and checked refrigerant. Found run amps on compressor High but in range. Compressor is starting to go bad. Fan motor is leaking oil and pulling over max amps. Recommend replacing old original worn out parts. Inspected indoor unit found indoor unit secondary control bad and motor is leaking oil. Blower assembly and whee is bad and dirty and recommended cleaning. How. Was extremely hot and heat load is high in home. Filter was dirty. Found only one drain line being used. No protection on unit. Went over all findings and repairs and recommendations needed as well as replacement

Arrived on site to perform spring tune up on 2 2017 carrier units. Condensers located in back yard. Furnace and Evaporator coil is located in attic. Cycled both units and operational. Washed both condenser coils inside and out. Units are clean. Checked electrical compartment and and components. Both primary and secondary motor controls are both good. Fan motor are both good and amping are in range. Found start up amps on compressor for upstairs unit is at max. Downstairs is in range but is increasing. Recommend adding surge protectors on units. To protect from electrical surge and power outages that can damage or even short out systems. Checked pressure and are good and cooling home. Cycled system. Inspected indoor unit and replaced filters. Both systems are cooling at 20 and 22 degrees. Found no safety overflow switches on drain lines. Lines are clear and draining. Black flex ducting is used. No protection on both units. Recommend adding surge protectors to furnace to protect main co

Performed maintenance on 2004 units. Performed leak inspection on upstairs unit. Checked indoor unit and outdoor unit, could locate any leak dye at this time. Refrigerant pressures on unit are still within spec and unit is still cooling efficiently. Sealant could have sealed up the leak, we will keep monitoring refrigerant pressures on maintenances. Cycled systems for cooling. Checked systems electrical and components. Pulled condenser fan motors and thoroughly washed out condenser coils inside and out. Noticed that secondary drain like is leaking outdoors. Advised homeowner and recommended clearing primary line, he has a plumber friend that could probably take care of it. Primary motor control for upstairs unit is burnt and pitted. Secondary motor controls are within good range. Condenser fan motors are both leaking oil and starting to over amp. Went over findings and recommendations with Mike. He is fully aware of the condition of the systems and recommendations. Wants to take care o

Performed diagnostic on 2008 Goodman system. Homeowner states system is not cooling, and it is tripping the breaker immediately after it tries to turn on. Daniel, who is the homeowner, is an electrician and thinks it’s a bad condenser fan motor. Unit was opened up on arrival. Tested condenser fan motor and it is still good. Tested compressor and found compressor was grounded and is causing unit to trip breaker immediately. Compressor needs to be replaced. Unfortunately This is an r-22 refrigerant unit, and would need to see if we could find compressor available and all refrigerant in system would have to get reclaimed and new refrigerant added. Went over cost of compressor replacement including refrigerant. Because this is a older unit, homeowner wants to weigh the options out as far as system replacement. Turned call over to Darren to go over replacement options. System is not operational upon departure.

Installed new txv for upstairs system. Replaced o-rings and mounted txv bulb upright. Completely purged and vacuumed system down past 500 microns. Tested system and added 4 additional ounces of refrigerant to get the sub cooling within range. System temperature splits are good and system is operating properly at this time.

Performed diagnostic on 12 year old Carrier unit. Homeowner just moved in a month ago. Found his system is not cooling and he has been spinning the fan manually to get the fan to turn on, but is still not cooling regardless. Checked system electrical and system components. Found a dead/blown up capacitor that was preventing the system from turning on the compressor, even tho the fan was turning on by customer which is why unit was not cooling regardless. Put in a temporary capacitor to get unit running to fully evaluate. System kicked on and starter cooling. Condenser fan motor is leaking oil and is very close to going above the allowed rated maximum amperage, meaning it can start causing some issues. Compressor hard start is a little on the higher side. Condenser is also pretty dirty and unit can use some proper maintenance. Sat down and went over all information with Arnold. He is fully aware of the condition of his system and is aware of all concerns. Because he is still settling in

Arrived on site to perform spring tune up on a 2013 Lennox unit. Condenser located on side of home. Client stated no issues and they just replaced filter them selves. Found condenser hammered and dirty. Cleaned condenser coil inside and out. Primary is a bit worn on out and pitted. Secondary motor control is in range. Fan motor is good and pulling max amps of 1.1. Start up are in range. Run amps are good and pulling 6.8 amps max rated at 13. Checked pressure and are good and cooling home at 19 degrees. No protection on unit recommend adding surge protectors on units due to the age. Indoor unit is really dirty due to area around home. Blower assembly is really dirty. Recommend a blower wheel cleaning. Evaporator coil is dirty from dirt that has entered system. Drain lines are dirty as they do have dirt and debris in drain line. Advised filter should be changed more often to keep amount of dirt from entering system. Clients are aware. System is cooling good at 19 degrees. No protection

Arrived on site to perform spring tune up on a 2005 comfort maker unit. Condenser located on side of home. Furnace and Evaporator coil located in attic. Client stated unit needs maintenance done. As they have lived in hole for 4 years and not have had maintenance. Cycled unit and operational. Washed condenser inside and out. Unit was really dirty. Found primary starter to be burnt up on putting and contacts from age and wear of operation. Secondary control is good as it looks to have been replaced. Fan motor is leaking a lot of oil and has it on shaft and motor. Advised motor leaked so much oil and could fail at any time due to age. Recommend replacing. Checked start up amps and found start up high. Run amps are pulling max amps and over amping as it’s pulling 28.1 amps and max rated at 27.1. Compressor over amping advised could fail at any time as it’s working more then it’s max. Compressor is on a very short time until it completely fails or starts to trip breaker. Client is

Coil has leak in system. Client called other companies to see if they can get coils, but they weren’t able too. Advised i called manager to see if we can get coil we don’t have any in stock. Dave will see if we can get our hands on one. Please call client if we can get our hands on one.

Coil has leak in system. Client called other companies to see if they can get coils, but they weren’t able too. Advised i called manager to see if we can get coil we don’t have any in stock. Dave will see if we can get our hands on one. Please call client if we can get our hands on one.

Coil has leak in system. Client called other companies to see if they can get coils, but they weren’t able too. Advised i called manager to see if we can get coil we don’t have any in stock. Dave will see if we can get our hands on one. Please call client if we can get our hands on one.

Coil has leak in system. Client called other companies to see if they can get coils, but they weren’t able too. Advised i called manager to see if we can get coil we don’t have any in stock. Dave will see if we can get our hands on one. Please call client if we can get our hands on one.