Lake Elsinore, CA

Upon arrival performed diagnostic. Found compressor to be pulling 37.18 amperages. Added hardstart kit to lower amperages, after kit installed compressor pulling 14.09 amps off start. Noise levels went down. Performed maintenance washed out complete system. Replaced power distributor as old one was pitted and burned at contacts. Amperages are in very good condition. Replaced 20x30x1 & 20x20x1.

Performed diagnostic on 17 year old system. Homeowners stated that ever since we came out to perform a maintenance, the system has not been working correctly. Sometimes it works and sometimes it doesn’t. Stated this was not happening before the maintenance. System was in cool mode when I arrived. Indoor unit is blowing air, Outdoor condenser is not turning on. Found system is wired up to Edison box where they can shut the unit down remotely. System was being shut down remotely, which cuts the cooling command to outdoor system and shuts it off. Did an override on command and system came on and started cooling. Edison box kicked in again shortly after and turned the unit off. Homeowners recently put in solar and want the box removed. Let them know that have to call Edison and have them come take the box off. System was not operational upon departure due to Edison shutting the system off remotely.

Replace existing system with listed equipment. Replace both fiberglass boxes in attic with T-wye fittings.

Tested system on cooling. Measured temperatures. Checked indoor unit and ducting. Measured outdoor electrical loads and components. Cleaned condenser. Replaced defective parts. Replaced service caps. Changed filter.

Dropped off filters in backyard by solar inverter.

PERFORMED WARRANTY CALL. Found system non operational upon arrival. Customer says unit stopped cooling a couple days ago. Checked system and found upstairs unit non operational. Motor control was completely failed. Unit still under full warranty. Replaced and tested. Unit operational and cooling. Customers wife also wanted filter checked and replaced. Replaced with customers, customers wife, and customers daughters approval. Daughters want to think about the other recommendations. They understand manufacturers warranties can be voided with lack of professional maintenance. 1. Recommend adding maintenance program to both units 2. Recommend adding extended warranty to fully cover unit for the 10 year warranty. Once our warranty that came with the unit expires, labor, freon, diagnostics, and warranty processing will not be covered under Lennox parts warranty. 3. Recommend adding surge protection to both ac power and compressor unit to prevent failures.

Found system operational upon arrival. Replaced 20x20x1 and cut to fit 20x30x1. Washed condenser coil. Amperage ok on both start up and run for compressor. Condenser motor is rusting from the outside but amperage within range. Freon range ok. Motor controls in good condition. Unit operational upon departure.

Customer was confused with what he scheduled. He thought the 59 tune up was going to be discounted even further. He was also under the impression we would provide all the filters. The notes only had 1 14x24x1. The house uses 1 20x30x1 and 2 14x24x1. Customer said the only reason why he scheduled the tune up was because it cheaper to do the tune up then to buy the filters himself and clean the unit himself. Customer does not want to move forward with tune up after all.

Found system operational upon arrival. Replaced 20x24x1 filter. Blower motor very dirty and leaking oil in the back. Blower wheel is also dirty and can cause motor to unbalance and damage. Evaporator coil is dirty. Washed condenser coil. Amperage is high on start up and run for compressor. Condenser motor is leaking oil from bearings. Motor controls within range. High voltage line switch starting to burn and pit. Freon levels are high on the head pressure side. Compressor is working harder than it has to and may fail soon. Customer declined recommendations at this time. Unit operational upon departure.

Performed AC maintenance on 2019 carrier system. Cycled system for cooling. Checked indoor and outdoor unit electrical and system components. System is producing proper temperature split and refrigerant levels are in range. Replaced 1 inch filter. Ductwork is properly sealed and strapped. Checked outdoor unit components. Primary motor control is in good condition. Secondary motor control is within range. Pulled off condenser fan motor and thoroughly washed out condenser coil inside and out. Disconnect box does not have any fuses and is not a fused disconnect box. Also recommended adding compressor booster kit to help with compressor longevity. Homeowner wants to hold off on any repairs. Signed homeowner up on monthly ESA maintenance program and used today as AC maintenance visit. Cycled system, system is operational upon departure.

Performed AC maintenance x2 on 2 2007 units. Homeowners have not had a maintenance done to units since they moved in 4 years ago. Cycled both systems for cooling. Checked indoor and outdoor units electrical and system components. Replaced all 1 inch filters. Systems are producing proper temperature split and refrigerant levels are within range. Pulled off condenser fan motors and thoroughly washed out condenser coils inside and out. Coils were super plugged up and dirty. Performed full evaluation of system, concerns are as follows: 1. No condensation safety switches on drain lines. 2. Both Compressors are starting up loud and hard. 3. Condenser fan motors are over amping. This has caused them to work harder and also have started leaking oil, 4. Secondary motor controls on both units are out of range for compressor side. 5. Condensers were relocated and some point, and refrigerant lines were ran underneath the concrete. This could pose a problem should there ever be a refrigerant issue

Upon arrival performed maintenance. Completely opened up outdoor system and cleaned off coils inside and out. Condenserr fan motor in very good shape . Refrigerant levels good. Subcool superheat good. Temp splits good. Replaced 20x30x1 filter was replaced. Recommend to replace filter more often or upgrade filtration. Filter was completely dirty causing air restrictions. 22 degree tem split. Circuit board and electrical connections very good. Recommend adding hardstart kit to keep amperages on compressor low off start. Less wear and tear. Customer declined to do any repairs or membership. System was reset tested and fully functional upon departure

Upon arrival performed maintenance. Completely opened up outdoor system and cleaned off coils inside and out. Condenserr fan motor in very good shape . Refrigerant levels good. Subcool superheat good. Temp splits good. Replaced 20x30x1 filter was replaced. Recommend to replace filter more often or upgrade filtration. Filter was completely dirty causing air restrictions. 22 degree tem split. Circuit board and electrical connections very good. Recommend adding hardstart kit to keep amperages on compressor low off start. Less wear and tear. Customer declined to do any repairs or membership. System was reset tested and fully functional upon departure

Upon arrival performed maintenance. Completely opened up outdoor system and cleaned off coils inside and out. Condenserr fan motor in very good shape . Refrigerant levels good. Subcool superheat good. Temp splits good. Replaced 20x30x1 filter was replaced. Recommend to replace filter more often or upgrade filtration. Filter was completely dirty causing air restrictions. 22 degree tem split. Circuit board and electrical connections very good. Recommend adding hardstart kit to keep amperages on compressor low off start. Less wear and tear. Customer declined to do any repairs or membership. System was reset tested and fully functional upon departure

Upon arrival performed maintenance. Completely opened up outdoor system and cleaned off coils inside and out. Condenserr fan motor in very good shape . Refrigerant levels good. Subcool superheat good. Temp splits good. Replaced 20x30x1 filter was replaced. Recommend to replace filter more often or upgrade filtration. Filter was completely dirty causing air restrictions. 22 degree tem split. Circuit board and electrical connections very good. Recommend adding hardstart kit to keep amperages on compressor low off start. Less wear and tear. Customer declined to do any repairs or membership. System was reset tested and fully functional upon departure

Upon arrival performed maintenance on 2016 unit. Outdoor system was completely opened up and washed out. Cleaned coil and inside of condenser caging. Amperages throughout system very good. Refrigerant levels and temp splits very good. Both filters were replaced. Circuit board and electrical connections good. Primary motor control in good condition. Secondary motor control low. Condenser fan motor good. Insulation levels in attic good. Duct work in very good condition. System was reset tested and fully functional upon departure. Please send home owner filtration and purification flyers. Please send customer CC authorization form.

Upon arrival performed maintenance on 2016 unit. Outdoor system was completely opened up and washed out. Cleaned coil and inside of condenser caging. Amperages throughout system very good. Refrigerant levels and temp splits very good. Both filters were replaced. Circuit board and electrical connections good. Primary motor control in good condition. Secondary motor control low. Condenser fan motor good. Insulation levels in attic good. Duct work in very good condition. System was reset tested and fully functional upon departure. Please send home owner filtration and purification flyers. Please send customer CC authorization form.

Upon arrival performed maintenance on 2016 unit. Outdoor system was completely opened up and washed out. Cleaned coil and inside of condenser caging. Amperages throughout system very good. Refrigerant levels and temp splits very good. Both filters were replaced. Circuit board and electrical connections good. Primary motor control in good condition. Secondary motor control low. Condenser fan motor good. Insulation levels in attic good. Duct work in very good condition. System was reset tested and fully functional upon departure. Please send home owner filtration and purification flyers. Please send customer CC authorization form.

Upon arrival performed maintenance on 2016 unit. Outdoor system was completely opened up and washed out. Cleaned coil and inside of condenser caging. Amperages throughout system very good. Refrigerant levels and temp splits very good. Both filters were replaced. Circuit board and electrical connections good. Primary motor control in good condition. Secondary motor control low. Condenser fan motor good. Insulation levels in attic good. Duct work in very good condition. System was reset tested and fully functional upon departure. Please send home owner filtration and purification flyers. Please send customer CC authorization form.

Arrived on site to perform spring tune up on a 2014 system. Condenser located in back yard. Furnace and evaporator coil located in garage. Client stated the other day her system was not cooling and next day later it was so she canceled service appointment and change it to a spring tune up to see how system was running. She cycled cooling mode on. Inspected attic. Found inundated ducting used. Filter was dirty but recently changed out 2 months ago Client stated. Washed out doo unit inside and out. Cleaned, rinsed, and wiped down out door unit. Check fan blades, bearings, and motor. Fan motor is starting to leak slight oil down shaft. Checked electrical compartment and components. Primary and secondary controls are good and in range. Checked amp drawls on compressor and fan motor. Both good and in range. No protection on either units. Refrigerant pressure are good. Cycled system inspected indoor unit. Found filter dirty but client stated her husband is gunna order more and will replace t

Arrived on site to perform spring tune up on a 1993 Lennox system. Condenser located in back yard. Furnace and evaporator coil located in attic. Client stated no issues in system. Just wanted to check on air flow as to why his master isn’t getting good air flow like the rest of the house. Checked and replaced filter. Inspected indoor unit and ducting and insulation. Checked electrical wiring, connections, circuit board and components. Checked blower assembly. Checked evaporator coil and drain lines. Took temperature split. Cycled system to ensure system operating. Inspected out door unit. Washed out door condenser inside and out. Checked electrical compartment and components. Check primary and secondary motor control. Checked amp drawls on compressor and fan motor. Un able to checked refrigerant pressure as service ports caps would not come off and client Said if they Aren’t coming off its okay as he doesn’t want them to break. The summary of findings are as followed. Condense

Cooling Maintenance: (1) Condenser fan motor is operating within manufacturer specifications (18.75). (2) Compressor is operating within manufacturer specifications (1.47). (3) The contactor is okay. (4) The battery cap is operating within manufacturer specifications at [(-1%) + (-4%)]. (5) Refrigerant levels are good. Refrigerant type is R-22. (6) The outdoor coil was cleaned. (7) The internal service compartment was cleaned. (8) Cleaned out the condensate line. (9) Found no damaged wires. (10) Tightened the wire connections. (11) The filter was replaced. Filter sizes are 18x30x1 and 20x24x1 Notes: (1) The battery cap is nearly out of range and should be replaced if it gets worse. (2) The condenser fan motor is starting to leak grease. This means the motor has overheated at least once. This part should be monitored.

Arrived on site to diagnose a 1987 system with air flow issues. Homeowners stated they will not be home and there daughter while be and spoke over with daughter as to what going on. She advised her system dose cool but there are having a air flow issues to some parts of house. Inspected indoor unit and attic. System dose operate and is cooling. Found insulation to be okay and house had insulation on attic ceiling but has fell. Found gray and black flex ducting used and in not the best conditions. Inspected all ducting and all show to have had patched up work done in past. Some ducts having kinks in it restricting air flow to rooms. Found some vents are undersized and Not enough supply to have good air flow. Found all main duct to have a fiberglass insulation box to direct air flow but is not in best condition. All ducting show to have some lose and poor connections and some not sealed properly with tape and cold temperature is being lost in attic. Found master bed rooms vents to hav

Found system non operational upon arrival. Found compressor with over 100amps of LRA. Customer approved condenser rejuvenate. Installed motor and motor controls. Also installed nest thermostat provided by customer. Cycled and tested upon departure. Customer also signed up for 1 year maintenance agreement.

Performed AC maintenance on 7 year old Goodman system. Cycled system for cooling from both thermostats. Checked indoor and outdoor unit electrical and system components. Replaced 20x30x1 filter. Pulled condenser fan motor off outdoor unit and thoroughly washed out condenser coil inside and out. Thoroughly evaluated system, concerns with unit are as follows 1. System is a single stage furnace and condenser zoned off into 2 zones. This is going to eventually wear and tear down the system a lot sooner than normal due to system being under a lot more stress 2. Daughters room feels a lot hotter than the rest of the upstairs 3. No supply plenum, ductwork is coming right off the evap coil plenum 4. Primary motor control is starting to form burning and pitting at the contact points 5. Compressor start up amps are high, and compressor turns on a lot more frequently than a normal unit due to it being zoned Went over findings and recommendations with wife Gladys. Husband was not home. Is goi