Lake Elsinore, CA

Upon arrival performed diagnostic on ac. Client states that the fan will just keep running after cycle of cooling. Cycled system on and off, ac kicks on good after delay. Fan is shutting off, client replaced thermostat and it might be showing 1 degrees off. Advised system is running fine, if anything weird happens just visualize thermostat screen and take notes on what happens. System was reset tested and fully functional upon departure.

Installation of a Single Stage 16 SEER Air Conditioner with High Performance Coil, and WiFi thermostat.

Tech arrived on site. Found the system to have power and be operational. Found the system almost flat on refrigerant. Unit is 2 years old. Went over repair options with customer. Customer wants to get the builder involved. Will follow up on Monday to see how we can help.

Performed AC maintenance on a condensing unit in lake Elsinore. Systems cooling split is 24 degrees. Indoor blower motor is amping high but spinning ok. Primary start control is in range. Indoor coil does not have a safety switch. Condensate lines are clear. Outdoor unit was chemically cleaned. Fan and compressor amps are in range. Schrader valve was loose and leaking I was able to tighten and fix the leak. Outdoor fan is leaking oil and is amping at max range per the data sheet. Refrigerant levels are ok at this time. System was cycled before leaving.

Upon arrival performed maintenance on hvac system. Outdoor fan motor is beginning to leak oil, has a lot of play on shaft. Secondary & primary motor control are in range. Compressor amperages are running pretty high. Refrigerant levels were down, added 1 lb of r22 refrigerant. Client did not wanna do any other repairs, has done repairs in home not to long ago. Indoor motor is leaking oil, has a very dirty blower wheel. Dusted off electrical connections.Re wrapped clients lineset. Filter was not replaced client just replaced. System is running & cooling, but is over 18 years old, client is fully aware of how system is running, wants to get a couple more years out of it, did minimal repairs. System is operational upon departure.

Upon arrival performed maintenance on hvac system. Outdoor fan motor is beginning to leak oil, has a lot of play on shaft. Secondary & primary motor control are in range. Compressor amperages are running pretty high. Refrigerant levels were down, added 1 lb of r22 refrigerant. Client did not wanna do any other repairs, has done repairs in home not to long ago. Indoor motor is leaking oil, has a very dirty blower wheel. Dusted off electrical connections.Re wrapped clients lineset. Filter was not replaced client just replaced. System is running & cooling, but is over 18 years old, client is fully aware of how system is running, wants to get a couple more years out of it, did minimal repairs. System is operational upon departure.

Upon arrival performed maintenance on hvac system. Outdoor fan motor is beginning to leak oil, has a lot of play on shaft. Secondary & primary motor control are in range. Compressor amperages are running pretty high. Refrigerant levels were down, added 1 lb of r22 refrigerant. Client did not wanna do any other repairs, has done repairs in home not to long ago. Indoor motor is leaking oil, has a very dirty blower wheel. Dusted off electrical connections.Re wrapped clients lineset. Filter was not replaced client just replaced. System is running & cooling, but is over 18 years old, client is fully aware of how system is running, wants to get a couple more years out of it, did minimal repairs. System is operational upon departure.

Upon arrival performed maintenance on hvac system. Outdoor fan motor is beginning to leak oil, has a lot of play on shaft. Secondary & primary motor control are in range. Compressor amperages are running pretty high. Refrigerant levels were down, added 1 lb of r22 refrigerant. Client did not wanna do any other repairs, has done repairs in home not to long ago. Indoor motor is leaking oil, has a very dirty blower wheel. Dusted off electrical connections.Re wrapped clients lineset. Filter was not replaced client just replaced. System is running & cooling, but is over 18 years old, client is fully aware of how system is running, wants to get a couple more years out of it, did minimal repairs. System is operational upon departure.

Replaced mini split indicator board in the upstairs bedroom. Tested equipment on cooling. System is receiving signal from remote controller.

Performed maintenance on 18 year old AC unit. Furnace is older, unsure of age. Cycled system for cooling. Checked indoor and outdoor unit electrical and system components. Refrigerant pressures are in range and system is producing proper temperature split. Removed outdoor condenser motor and thoroughly washed out condenser coil inside and out. Fully inspected unit, concerns are as follows 1. Indoor blower wheel is dirty and has accumulated a lot of dust. 2. Furnace is extremely old, recommend having it safety checked before next winter. 3. Primary motor control at outdoor unit is starting to hum at coil. 4. Compressor is starting up fairly hard and loud, amperage are high on start up. 5. Condenser fan motor has started to leak oil and is over amping. 6. System is inefficient. Went over findings and recommendations with homeowner. Homeowner is fully aware of the condition of the unit and how it’s operating, and is aware of concerns. Wants to hold off on any repairs for today. Signed

Inspected Lennox mini split indoor wall mounted unit for faults and operation. Ordered replacement indicator board from Lennox.

Performed AC diagnostic on 30-year-old Condenser. Upon my diagnostic tenant stated that he had a handyman come out and replace parts to get the system running although all the handyman did was just make the system unsafe and have it continuously running 24/7 by pushing the contactor in with putty. Visually inspected unit and found that circuitboard is not sending 24 V to contactor this is why the handyman did this. Circuitboard must be replaced to get 24 V to energize on the high-voltage distributor. Upon explaining what was going on with the system tenant basically blew us off and told us we were never here while we were physically present there and said that he was not going to pay because we didn’t fix anything. I even clarified that $98 is due even if no repairs are done in the beginning and he agreed. Ultimately left System in same condition And upon departure Tammy paid the $98.

Upon arrival found system to be non operational, found system to not spin or turn in compressor. Replaced dual start capacitor and system is operational. Client will call back for membership to take a look at systems.

Upon arrival found system to be non operational, found system to not spin or turn in compressor. Replaced dual start capacitor and system is operational. Client will call back for membership to take a look at systems.

Upon arrival found system to be non operational, found system to not spin or turn in compressor. Replaced dual start capacitor and system is operational. Client will call back for membership to take a look at systems.

Upon arrival found system to be non operational, found system to not spin or turn in compressor. Replaced dual start capacitor and system is operational. Client will call back for membership to take a look at systems.

Arrived on site to diagnose a non operational system. Found unit to be original to home from 1997 condenser in front yard. Upon arrival client stated unit would tune on and fan would not. He inspected and found YouTube and saw some parts could be bad. Instead called us out. Found fan motor not operating. Secondary motor control is bad as well and weak. Primary is burnt up. Advised I would need to replace Fan motor before I can continue. Client stated he was trying to get system up and running and is unable to replace due to cost of new system. Client wanted to rebuild unit to buy more time out of system and is aware there is no guarantee how long systems will operate for but we will warranty out parts used today. Client is aware replacement would be best but unable to do so at this time. So would be rebuild info unit. Replaced primary and secondary and added compressor booster kit and new fan motor. Cycled system to ensure system operating. Client is aware of repairs made and happy

Performed A/C maintenance on a Goodman condenser. Cooling split is 29 degrees. Condensate lines are clear. Primary blower motor is in range. Filter is dirty and changed today. Outdoor coils were chemically cleaned. Outdoor units disconnect has no fuses or surge protection. Compressor and fan motor are amping in range. Refrigerant levels look low and will be monitored moving forward.

Upon arrival performed motor and secondary motor replacement. Programmed motor to correct hp and rpm. Tested system and verified it works.

Upon arrival performed motor and secondary motor replacement. Programmed motor to correct hp and rpm. Tested system and verified it works.

Upon arrival performed motor and secondary motor replacement. Programmed motor to correct hp and rpm. Tested system and verified it works.

Upon arrival performed motor and secondary motor replacement. Programmed motor to correct hp and rpm. Tested system and verified it works.

Performed maintenance on 12 year old system. Cycled system for Cooling. Checked system electrical and components. Amp draws for compressor are in good range. Amp draws for condenser fan motor are close to going over allowed range, and motor has started to leak oil. Refrigerant levels are in range and system is producing proper temperature split. Pulled condenser fan motor and thoroughly washed out condenser coil inside and out. Electrical components have been replaced and they are all in good condition. Went over findings and recommendations with homeowner. Cycled system, system is operational upon departure.

Performed Ac maintenance on 9 year old Lennox system. Cycled system for cooling. Checked indoor unit electrical and system components. Temperature split is within range and system is producing proper temperature. Replaced 1 inch filter. This is a single stage unit with 2 zones, which is not ideal. Checked outdoor unit electrical and system components. Amp draws for compressor and condenser fan motor are within range. Primary motor control is in good condition. Secondary motor control is within range. Cycled system, system is operational upon departure.

Repaired disconnected supply duct coming off of supply Plenum inside of attic. This may have been disconnected when the cable guy was up in the attic and stepped on it or the tension overtime from it being too short pulled it off. Client had mention that energy bill Was a lot higher than usual and this can definitely be the reason why due to all the air leakage occurring in the attic the ductwork is very old and is falling apart and is not sealed in multiple areas. Will be scheduling for a comfort adviser to return to go over ducting options to increase the efficiency and Airflow The System.