Lake Elsinore, CA

Upon arrival performed diagnostic, found transformer to be burnt uo and not sending 24v to circuit board. Primary start was the main short inside of condenser unit, causing fuses to pop and transformer to fail. Replaced all parts and did low voltage repair got system up and running, did not have filters to swap out for client. Verified refrigerant charge in range. Client declined membership, is going through refinance and doesn’t know if they are moving or not. System is operational.

Upon arrival performed diagnostic, found transformer to be burnt uo and not sending 24v to circuit board. Primary start was the main short inside of condenser unit, causing fuses to pop and transformer to fail. Replaced all parts and did low voltage repair got system up and running, did not have filters to swap out for client. Verified refrigerant charge in range. Client declined membership, is going through refinance and doesn’t know if they are moving or not. System is operational.

Upon arrival performed diagnostic, found transformer to be burnt uo and not sending 24v to circuit board. Primary start was the main short inside of condenser unit, causing fuses to pop and transformer to fail. Replaced all parts and did low voltage repair got system up and running, did not have filters to swap out for client. Verified refrigerant charge in range. Client declined membership, is going through refinance and doesn’t know if they are moving or not. System is operational.

Arrived on site to perform spring tune up on a 2011 unit. Condenser located in back yard. Furnace and Evaporator coil in hall closet. cycled unit and replaced dirty filter client supplied. Washed condenser and wiped down unit clean. Found primary starter was burnt up and worn out from use. Secondary motor controls is is weak and out of range of fan terminal. Recommend getting replaced before completely fails. Fan motor is over amping as max is 1.1 and pulling 1.2. Could fails in future due to age and condition. Compressor is pulling 10 amps and max rated for 15.4. Recommend adding compressor booster kit to prolong life of compressor and prevent hard start ups on compressor. Checked refrigerant pressure and were good and cooling at 20 degrees. Unit uses r-22 That is no longer in production. Inspected indoor unit and found it dirty from past years of dirt entering system. Blower is dirty. Filter was replaced. Found one drain line in use and is dirty. No protection on unit. Cycled system

Installation of a 4 ton 16 SEER air conditioning system with high efficiency coil. Basic stripped package with no high flow registers, WiFi thermostat or permits. 1 year maintenance contract is included. Cash Price - $7,236 (cash or check)

Performed AC maintenance on a ACPRO condenser. Systems cooling temperature split is 20 degrees. Indoor blower is amping high and leaking oil. Housing and motor has a heavy amount of dust collected on it. Suggesting replacement. Outdoor coils were chemically cleaned. Compressor and fan amps are ok at this time. Refrigerant levels are ok. System was cycled before leaving.

Arrived on site to perform maintenance on a 2007 lennox unit. Condenser located on side of house. Furnace and Evaporator coil located in attic. Client stated no issues. Cycled unit. Washed condenser coil inside and out. Found primary starter is burnt up and crating loud buzzing noise advised could be starting to go bad. Found secondary motor control completely dead on the compressor terminal and had booster kit added and is the only reason why unit is still starting up. Fan side was good. Run amp on compressor we’re at max due to bad secondary control. Replace to test amp and run amps dropped to 7 amps which is good and in range. Fan motor is operating over max rate and is pulling 1.2 and max rated for 1.1. Advised due to age of unit fan is aware vet working and could fail in future or cause other parts to start to go bad. Checked pressure and found unit to be a tad bit low on charge but ores are still in range just a bit low. Unit is cooling at 24 degrees. Found filter to be dirty

Performed AC maintenance on 28-year-old Lennox condensing unit. Upon my maintenance there were multiple points of concerns that were addressed with Oscar. 1. Measured refrigerant pressures and found that system was extremely low on R22 refrigerant charge. There is a leak somewhere within the refrigeration cycle and system only get lower as time progresses. 2. Outdoor condensing fan motor was beginning to over amp and overheat due to wear and tear of motor 3. Dual secondary motor control is becoming weak due to compressor using more power than needed. This battery will only get weaker as a Compressor continues to run in pull high amperage. 4. Compressor saver kit is completely dead and no longer acting as a steroid booster for the compressor on start up this is also the reason why the compressor keeps locking out on start up After running on a load. 5. Compressor Is it high risk of failing soon due to it locking out on overload because of age and deterioration of winding and valves with

Performed AC diagnostic on 2019 carrier Condenser. Upon my diagnostic client stated that system was refilled approximately a year and a half ago with refrigerant by the builders of the house. She just started using the system again and now the system is no longer cooling upstairs or downstairs. I proceeded to the outdoor unit and found that the system is operational and running on very low amps. I gaged up to the service ports of the condenser and found out the R410a pressures were way below the proper refrigerant charge it is designed to be at. Ultimately there is a leak somewhere within the refrigeration cycle and was addressed The last time they were out there and filled the system with refrigerant. Advised client that a leak dye/sealant needs to be injected into the system to coat the copper line sets in the indoor and outdoor unit to help us pinpoint the location of the refrigerant leak to prevent any further loss. Will be returning in approximately one month to locate leak with U

Preformed Ac diagnostic on 1999 Rheem condenser. Upon my diagnostic Tracy stated that the system was freezing up on suction line of condenser outside. Verified that indoor blower motor is running Although the single secondary motor control that powers it is reading at 11 µF when it should be at 15 µF. Proceeded to outdoor Unit and found that suction line was icing up. Noticed that the suction line insulation was completely stripped while the sun is bearing down on the suction line. Measured refrigerant pressures and found that refrigerant pressures were becoming too cold inside the evaporator coil due to an an air restriction inside the system. Found that the indoor blower motor was completely covered in dust and debris and original filter was completely plugged up and not swapped out enough resulting in dust making it inside evaporator coil and creating a blanket of dirt restricting airflow resulting in colder temperatures inside of the evaporator coil. Client also stated that compr

Performed AC diagnostic on 2016 Lennox Condenser. Upon my diagnostic client stated that system was recharged back in April with 2 pounds of refrigerant and is now apparently no longer cooling the house. Client thought we were associated with home warranty but we do not work with them. Started diagnostic off at Condenser and found that everything is operational. When I measured the refrigerant pressures I found that the system was extremely under charged due to an apparent leak within the system. Also found that duel secondary motor control is becoming week due to compressor running with no refrigerant. Advisor that I leaked I should be injected into the system so that we can pinpoint the location of the leak and repair it for a long term solution. Advised her that any refrigerant dumped into the system right now can’t potential to be lost by the next time I arrive. Recharged System was 6 pounds of refrigerant and injected leak dye into system and will return approximately in one mont

Arrived on site to install and do repairs. Client approved to replace fan motor with a high efficiency motor and adds compressor booster kit and a surge protector on unit. Installed and cycled and system is operational and cooling upon departure. Client is happy with repairs and work done today. System operational upon departure.

Upon arrival system is working and operational, removed fan from condenser to properly clean the coils inside and out removing dirt and debris. Tested electrical on outdoor unit, upon inspection found the capacitor to be weaker then rated values, also found the compressor to be amping high upon start up. Recommended new capacitor and a compressor saver kit. Checked Refrigerant charge in system, system pressure looked good and was within range. Inspected indoor furnace, upon inspection electrical components and control board are functioning properly. Ducts look to be in good condition. Replaced filters and washed washable, noticed filters are heavily impacted with dust and debris, recommended possible filter alternatives increasing the air quality in the home. Upon departure systems are working and operational

Upon arrival system is working and operational, removed fan from condenser to properly clean the coils inside and out removing dirt and debris. Tested electrical on outdoor unit, upon inspection found the capacitor to be weaker then rated values, also found the compressor to be amping high upon start up. Recommended new capacitor and a compressor saver kit. Checked Refrigerant charge in system, system pressure looked good and was within range. Inspected indoor furnace, upon inspection electrical components and control board are functioning properly. Ducts look to be in good condition. Replaced filters and washed washable, noticed filters are heavily impacted with dust and debris, recommended possible filter alternatives increasing the air quality in the home. Upon departure systems are working and operational

Upon arrival system is working and operational, removed fan from condenser to properly clean the coils inside and out removing dirt and debris. Tested electrical on outdoor unit, upon inspection found the capacitor to be weaker then rated values, also found the compressor to be amping high upon start up. Recommended new capacitor and a compressor saver kit. Checked Refrigerant charge in system, system pressure looked good and was within range. Inspected indoor furnace, upon inspection electrical components and control board are functioning properly. Ducts look to be in good condition. Replaced filters and washed washable, noticed filters are heavily impacted with dust and debris, recommended possible filter alternatives increasing the air quality in the home. Upon departure systems are working and operational

Upon arrival system is working and operational, removed fan from condenser to properly clean the coils inside and out removing dirt and debris. Tested electrical on outdoor unit, upon inspection found the capacitor to be weaker then rated values, also found the compressor to be amping high upon start up. Recommended new capacitor and a compressor saver kit. Checked Refrigerant charge in system, system pressure looked good and was within range. Inspected indoor furnace, upon inspection electrical components and control board are functioning properly. Ducts look to be in good condition. Replaced filters and washed washable, noticed filters are heavily impacted with dust and debris, recommended possible filter alternatives increasing the air quality in the home. Upon departure systems are working and operational

Arrived on site to perform spring tune up on a 2008 Goodman unit. Client stated no issues. Washed condenser inside and out. Unit was dirty. Primary control was good as it was replaced. Secondary motor controls is good. Found fan motor over amping and advised could fail due to over working. Start ups were in range recon compressor booster kit to prolong life of compressor and prevent hard start ups. System pressure are good and cooling hole at 21 degrees. Replaced filter as client supplied his own. Blowers assembly and motor are good. Found surge protection on furnace good and active. Cycled system to ensure system operating. Went over all repairs and recommendations. Client is aware how system is running and condition and would like to go with the premium plan and would be coming back to do repairs due to time today. I will call to get him back on schedule Client is aware how system is running and conditions. System is operational and cooling upon departure.

Performed AC tuneup on a carrier condenser. System is cooling 15 degrees. Condensate lines are clear but have no safety switch. Indoor blower is amping ok. Filter is clean. Evaporator coil is a 410A txv metering device. Outdoor coil is a R22 condenser. This is causing inefficient cooling. Compressor is amping high run and start amps. Fan motor is leaking oil. System was cycled before leaving. Customer wants to discuss options on replacing the R22 condenser to have a correctly running system.

Diagnosed system, Found system to be non operational. Found breakers at disconnect to be bad and not letting power through to condenser. System is non operational, client will replace himself.

Diagnosed system, Found system to be non operational. Found breakers at disconnect to be bad and not letting power through to condenser. System is non operational, client will replace himself.

Diagnosed system, Found system to be non operational. Found breakers at disconnect to be bad and not letting power through to condenser. System is non operational, client will replace himself.

Diagnosed system, Found system to be non operational. Found breakers at disconnect to be bad and not letting power through to condenser. System is non operational, client will replace himself.

Upon arrival performed diagnostic on ac. Client states that the fan will just keep running after cycle of cooling. Cycled system on and off, ac kicks on good after delay. Fan is shutting off, client replaced thermostat and it might be showing 1 degrees off. Advised system is running fine, if anything weird happens just visualize thermostat screen and take notes on what happens. System was reset tested and fully functional upon departure.

Upon arrival performed diagnostic on ac. Client states that the fan will just keep running after cycle of cooling. Cycled system on and off, ac kicks on good after delay. Fan is shutting off, client replaced thermostat and it might be showing 1 degrees off. Advised system is running fine, if anything weird happens just visualize thermostat screen and take notes on what happens. System was reset tested and fully functional upon departure.

Upon arrival performed diagnostic on ac. Client states that the fan will just keep running after cycle of cooling. Cycled system on and off, ac kicks on good after delay. Fan is shutting off, client replaced thermostat and it might be showing 1 degrees off. Advised system is running fine, if anything weird happens just visualize thermostat screen and take notes on what happens. System was reset tested and fully functional upon departure.