Lake Elsinore, CA

Upon arrival client stated system is not turning on. Found system to be tripped. Tested secondary motor control found it compellty flat. Replaced & got system going. Tested refrigerant levels, levels are in range. Advised client I can go to furnace to check the motors to make sure they are up to par. Says it’s ok he just got a tune up done to the system not to long ago, declined attic. Declined membership, cause system is old and wants to think about replacement in the future just not yet. Compressor is running at very high amperage’s, added everything up & system is most likely looking at 5-6 kWh. Client has solar. System is operational upon completion.

Upon arrival client stated system is not turning on. Found system to be tripped. Tested secondary motor control found it compellty flat. Replaced & got system going. Tested refrigerant levels, levels are in range. Advised client I can go to furnace to check the motors to make sure they are up to par. Says it’s ok he just got a tune up done to the system not to long ago, declined attic. Declined membership, cause system is old and wants to think about replacement in the future just not yet. Compressor is running at very high amperage’s, added everything up & system is most likely looking at 5-6 kWh. Client has solar. System is operational upon completion.

Repaired low voltage short in the outdoor wiring. Replaced defective thermostat. Tested system on heat and cooling. Measured temperatures and refrigerant pressures.

Performed AC maintenance x2 on 2 2007 units. Homeowners have not had a maintenance done to units since they moved in 4 years ago. Cycled both systems for cooling. Checked indoor and outdoor units electrical and system components. Replaced all 1 inch filters. Systems are producing proper temperature split and refrigerant levels are within range. Pulled off condenser fan motors and thoroughly washed out condenser coils inside and out. Coils were super plugged up and dirty. Performed full evaluation of system, concerns are as follows: 1. No condensation safety switches on drain lines. 2. Both Compressors are starting up loud and hard. 3. Condenser fan motors are over amping. This has caused them to work harder and also have started leaking oil, 4. Secondary motor controls on both units are out of range for compressor side. 5. Condensers were relocated and some point, and refrigerant lines were ran underneath the concrete. This could pose a problem should there ever be a refrigerant issue

Performed an AC tune up on a 2 year old Lennox 5 ton system. Gave the system a chemical wash. Checked electrical components, in which all were in range. Checked pressures and amps all were in range as well. Filter is good for now should be changed next visit. -System is ready for summer

Arrived on site to perform spring tune up on a 9 year old unit. Condenser unit in back yard furnace located in attic. Client stated no issues cycled cooling on. Washed condenser coil inside and out. Checked electrical compartment. Found primary starter pitted on contact points. Secondary as really low rated for 45 and only at 30. Recommended replacing. Fan motor is good and free of oil at this time. Checked start up amps and run amps on compressor. Start up are high and recommended a compressor booster kit to help prevent hard start ups and prolong life of unit. Run amps are good and in range. Checked pressure and found unit to be low. Inspected attic and unit is only cooling at 10 degrees. Advised unit is not cooling good and pressure are low. Drain lines are clear but no safety over flow switches. Found evaporator coil to no have a emergency drain pan and advised client this is not good in case it were to overflow emergency pan would protect ceiling from water damage. Advised would r

Arrived on site to perform spring tune up on a 14 year old unit. Cliystated no issues as he has it running. Put temperature down in home to keep running and good. Washed condenser coil inside and out. Primary starter is Burt up and pitted on contact points from operation and use. Secondary motor control is out of range on both sides and will be failing here soon. Fan motor is leaking oil and is pulling max amps and advised if motor keeps it it will be failing in future. Checked start up amps on compressor. Found them high pulling 118 and max at 135. Run amps are good pulling 10 amps and max rated at 19.8. Checked pressure are good and cooling he at 22 degrees. Unit is cooling hole good but advised unit is not as efficient as it used to be. No protection on either unit. Cycled and went over all findings and areas of concerns with client. He is aware as he’s been told in past. Went over recommendations and repairs needed and he stated he is aware of age and condition but is just goin

Upon arrival performed AC/leak dye inspection on Goodman air conditioning unit. Upon arrival clients daughter stated that the system has had no issues and they haven’t used it much at all. Performed deep cleaning on outdoor unit and checked all electrical which is in good range at this time. Measured refrigerant pressures and found that it was low on R410a charge for a second time. Conducted full league dying inspection and was unable to locate area of refrigerant leakage. Due to the system not being ran for approximately one month this has Caused an unequal distribution of the dye from not running. Summit system was only producing 66° supply temp air. Charge system up with approximately 1 pound of refrigerant in System came down to 47 degrees. Advise clients that they will need to run it for a full month to fully spread the lite throughout the system and then if they do noticed that it is not cooling properly in the middle of the summer they can give us a call and we will return fo

Technician arrived to perform spring tune up -Condenser was thoroughly cleaned out with water for efficiency and longevity -Fan motor and compressor was over amping drawing a lot of power and working harder than it needs to -Compressor booster kit and a new fan motor is recommended if client plans on keeping system for as long as possible -Refrigerant levels looked good and within range -System is old but it is doing its job and cooling the house down

Performed AC maintenance. Inspected and tightened electrical components. Checked filter. Inspected ducting to ensure proper airflow. Temperature split was at 20degrees.inspected and cleared condensate lines, system ha flood protection drain pan and float switch. Checked outdoor electrical components, measured capacitor- it is within range. Checked contactor. Washed and cleaned outdoor condenser coils. Removed debris from bottom of the condenser and cleaned and removed debris from electrical cabinet. System is cooling and operational upon departure.

Arrived on site to perform condensation diagnostic on 2014 Lennox unit. Upon arrival homeowner stated that the system has leaked over which is located in the closet has flooded into the carpet and the surrounding drywall. Immediately found that secondary float switch was tripped and proceeded to outdoor drainage and found that no water was coming out. Performed clear out the P-trap located at primary on evap coil And system began to drain properly after being cleared. Primed the system drain lines 3 times and water flowed perfectly every time. Signed client up on maintenance plan to keep both indoor and outdoor unit at standard and upon departure system is fully operational and cooling

Technician arrived to perform spring tune up -Condenser was cleaned with coil spray and cleaned off with water to increase efficiency and longevity of the system -Electrical components are functioning properly and are within proper amperage draw range -Refrigerant levels are within range and has a deltaT of 20 degrees difference -Condensation lines were cleared with nitrogen -System is working great and cooling the house efficiently

Performed AC MAINTENANCE ON PACKAGE UNIT. Checked and tightened electrical components. Cleared condensate lines. Tested capacitor it is within range. Temperature split was at 20 degrees. Inspected contactor. System is cooling and operational upon departure.

Upon arrival, system was operational. Charge appeared low. Condenser electrical has been replaced. Client said system would make loud sounds then they would shut it off. Did not observe anything like that on the call. Client said it was intermittent. Airflow was okay. It’s a single stage unit that is zoned. Need to add charge to system to see how it reacts. From there it either has a leak or has a redirection. Or a combination of the 2. System is pulling a lot of power for its age. Informed client. System is operational upon departure.

Technician arrived to perform Spring tune-up for client -Condenser fins were very dirty, they are now thoroughly cleaned completely to increase efficiency and longevity of the system -All electrical components were within range, although the capacitor was a little bit low it is still within range -Condensate line were cleared out with nitrogen -Refrigerant levels were within range and cooling the house properly -Compressor booster kit was recommended to ease start up of compressor and it is recommend to have one of these with a TXV controlled system -System is working great and is ready for summer

Arrived on site to perform diagnostic on 2014 Goodman system. System is blowing air but it is not cold air. Cycled system for Cooling. Unit came on like normal and started blowing air. Unit is not producing any temperature split at all. Gauged up to unit to check refrigerant pressures. Filter was extremely hammered and outdoor condenser coil was extremely dirty. Removed filter. Also pulled condenser motor to wash out condenser coil for accurate readings. Found system to be low on R410A refrigerant, which is what is causing system to not cool. Also found secondary motor control out of range for compressor, and primary motor control is burnt and pitted. This is probably due to unit being low on refrigerant and over working itself. Advised not to run swamp cooler and AC at the same time. Went over findings and recommendations. No decision could be made today, want to hold off until they talk it over. System is not operational upon departure.

Upon arrival, cleaned condenser coils and checked electrical. Charge is low sub cooling. Could possibly not have been charge right from install. Temp split was low. Further investigation found the filters the client was using was super restrictive. Advise upgrading to a 5 inch filter. Found piece of insulation inside the furnace restricting airflow. Fixed it and temp split was better. Advised client. Client declined maintenance renewal plan and duct recommendations. System is operational upon departure.

Arrived on site To perform AC maintenance on 2021 AC pro unit. Perform deep cleaning on unit. Measured refrigerant pressures and found that they were in range. Compressor and fan amps were also in range. Dual secondary motor control and starter were in good condition at this time. Fan motor showed no signs of oil leakage. Discussed maintenance plan with homeowner but he stated that he will do his own maintenance and give us a call if he considers it in the future although offered it to him and explained to him that this will keep warranty valid. Client declined maintenance plan and system is fully operational upon departure

Replacement of motor and spring maintenance. Replaced outdoor condenser fan motor under parts warranty. Performed Ac spring maintenance. Replaced indoor filter. Cleaned condenser coils. Monitored operation and recorded diagnostics. Measured temperatures and refrigerant charge.

Arrived on site to perform AC maintenance on carrier condensing unit. On arrival homeowner stated that he has had no issues. Performed deep cleaning on outdoor condenser coil. Measured refrigerant pressures and found that they were in range. Electrical was in good condition as well. Surge protection is active at this time. Client will Buy his filters and install. Amperages were in range. At this time there’s no further recommendations for outdoor unit. Temperature split is good and upon departure system is fully operational.

System totals to $10,562, client is only liable for payment of $7,562 as Tech Clean California will cover remaining $3,000 balance.

Diagnosed defective outdoor fan motor. The bearings are bad and the motor needs to be replaced. Ordered replacement part from Lennox and this will be on on Monday.

arrived on site to diagnose a ducting issues in home on a 6 year old unit. Spoke to client and he stated the had some plumbing work done in home and the the work was done in attic. The stated during the repair he had heard a loud noise as if something got crushed and since then he’s had been having airlflow issues the the living room. He did not want them to come look at it and called us out. Inspected attic. Found furnace located in a closet out side of home on the side. All duct ram in attic. Inspected and found the main duct going to living room to be completely smashed down as if they steps or laid on it. Inspected other ducting in attic and connections found the connections to not be good as some are lose and some have a big gaps exposed. Advised client he is losing cold air in attic due to the ducting and for it being metal it’s not as efficient as it should be so can cause unit to run longer. Went over findings and showed client pictures. As well as repairs and recommendatio

Arrived on site to perform maintenance on 9 year old Goodman system. Cycled system for cooling. Checked indoor unit electrical and system components. No condensation switches. Filter is clean. Temperature split is within ok range. Checked outdoor unit electrical and system components. Amp draws on compressor are high and compressor is really overworking itself. Primary motor control is in good condition. Secondary motor control is within range. Refrigerant pressures keep bouncing around between high and low. No fuses in disconnect. This is a single stage unit that is zoned into 2 separate zones, which is not an ideal set up. This has most likely caused the premature wear and tear on the unit and has caused it to work a lot harder than it should. Pulled condenser fan motor and thoroughly washed out condenser coil inside and out. Went over findings and recommendations. Homeowner wants to hold off on any work for today, but is fully aware of system concerns. System is operational upon dep

Total job is 31747. Customer will pay 25747. 6000 will be paid by cal tech California.