Lake Elsinore, CA

Blower motor included

Replaced the furnace control board and the downstairs thermostat.

Client stated no cooling, needed a R22 Recharge 2 years ago -Technician arrived and found the refrigerant levels to be very low -Client said the company that recharged the system, charged it with the new refrigerant R410a, which is not compatible with the existing R22 AC system -A recharge and dye kit was offered to temporarily fix the issue -The blower motor has gone out as well, not pushing any air across the coil -Replacement of the blower motor and refrigerant recharge was given as an option -Replacement of the entire system was given as an option, Mateo came out to discuss options

Arrived on site to perform AC diagnostic on 2007 Lennox condensing unit. Upon arrival homeowner son Mike stated that the system recently stopped working and is only blowing hot air out through the vents he mentioned that about 2 1/2 years ago the system was recharged with Freon and that’s all that’s really been done. Began diagnostic at outdoor unit and found that compressor was not on but fan motor was. Inspected all secondary motor control in electrical compartment and found that it was defective on compressor side terminal. Starter is severely burned up on contact points. Compressors drawing high amperage on startup. Found condenser fan motor leaking oil from its bearing and overamping. Measured refrigerant pressures and found that they were in range at this time although It did contain a phase out refrigerant called R22 which is no longer manufactured as of 2020. Measured compressor amprage and it was fairly high at this time. Discussed full diagnostic with Mike and he translat

Upon arrival client said unit would condensate water on the bed. Unit was dirty. Filters recently cleaned. Went to where condensate line terminated and flushed out the line. There was blockage in the drain line. Tested drain by running water in the pan. Unit is draining properly. Cleaned head unit. Unit is operational upon departure.

Owner tried installing thermostat himself and caused fuse to pop at motherboard. He wasn’t able to get a call for cooling when needed. After replacing fuse, system took off and cooled properly. Owner asked if I can re install his nest thermostat that he bought from Costco, for a charge of labor to re install. Unit works great and cools efficiently . Offered maintenance plan and he said not now, but that he’ll call in and set it up before future repairs.

Arrived on site to perform AC diagnostic on 2016 Lennox condenser. Upon arrival john stated that the breaker keeps tripping every time the outdoor unit try’s to turn on. Began diagnostic and found the thermostat was defective and not powering on when 24 V is present. Jump system out and proceeded to outdoor condensing unit and found that compressor was grounded. This explains why the breaker trips instantly every time it is turned back on. Compressor will need to be replaced under manufacture warranty but labor and refrigerant will be charged for. Client is also interested in system replacement for the older 2007 system. Client plans on moving in the next five years and would like a long-term solution and reliable AC put in the house for the meanwhile he’s aware that both heaters are original from 2007 and one outdoor unit is from 2007. Compressor will be ordered tomorrow for the 2016 Lennox upon departure system is non-operational

Finished installation of the evaporator coil. Pressure tested equipment. Vacuumed the system down to 400 microns. Charged system with fresh refrigerant. Installed drain trap and safety switch. Recorded pressures and delta T.

Primary drain was not sloped enough to drain faster than the secondary. Improved the slope of the drain line and tested at the bathroom sink to ensure the water will not drain into the secondary anymore. Taped the lineset at the condenser.

Inspected system and monitored operation of equipment. Tested cooling and electrical. Checked temps and pressures. Inspected low voltage and thermostat for proper connections. Found no occasion between the air conditioning system and the backyard lights.

Checked upstairs system fan and taped lineset at evaporator coil.

Premier secondary control was replaced. Found secondary motor control out. Client did not want to sign up with Memebrship, didn’t know if husband wanted to or not. Did minimum repair. Amperages on start up good, compressor is running really high in power, using about 4 KWh just on outdoor system. System can possibly be running close to $400 a month. System is operational.

Premier secondary control was replaced. Found secondary motor control out. Client did not want to sign up with Memebrship, didn’t know if husband wanted to or not. Did minimum repair. Amperages on start up good, compressor is running really high in power, using about 4 KWh just on outdoor system. System can possibly be running close to $400 a month. System is operational.

Premier secondary control was replaced. Found secondary motor control out. Client did not want to sign up with Memebrship, didn’t know if husband wanted to or not. Did minimum repair. Amperages on start up good, compressor is running really high in power, using about 4 KWh just on outdoor system. System can possibly be running close to $400 a month. System is operational.

Premier secondary control was replaced. Found secondary motor control out. Client did not want to sign up with Memebrship, didn’t know if husband wanted to or not. Did minimum repair. Amperages on start up good, compressor is running really high in power, using about 4 KWh just on outdoor system. System can possibly be running close to $400 a month. System is operational.

Arrived on site to perform diagnostic on a no cooling 2006 Goodman unit. Client stated unit is just not cooling and thinks it’s low. Had a friend advised him unit low on charge will not cool home so called us out. Cycled unit and condenser as operational but odd or was not. Inspected I for unit and electrical compartment. Found secondary motor control is completely bad and out of range. Put in a tester to operate unit and unit was operational. Blower assembly and wheel really dirty. Motor is going bad as it’s over heating and leaking oil. Drain lines are dirty and have no safety over flow switches. And black flex ducting used. Cycled I for and out door now and unit was operational. Inspected condenser. Found stater burnt up and pitted from age and operation. Second motor control is good and look to have been replaced. Fan motor is okay leaking slight oil but working hard. Compressor is getting hard start up and run amps are high due to condition and age of unit. Checked pressure an

This estimate also includes sending a team to partially remove a package unit and get precise specifications of the existing package unit curb. Once this is done the manufacturer will need a 5 to 6 day lead time to finish production of the curb adapters and have them delivered. Options: - One new 3 Phase 460V Disconnect: add $859

Arrived on site to perform diagnostic. Homeowner states system was leaking water from the top of unit. He removed the drain line and vacuumed it out and cleared it. Wanted me to verify it was good. Poured water down the drain pan and water is flowing freely into condensation line, however there is some water seeping through both connection points at evaporator coil. Found the drain cap as wall as male adapter were not screwed into pan completely, which was causing water to seep through there into the unit. Tightened both back up. Reconnected drain line. Performed maintenance and washed outdoor condenser coil. All components still in working order. Replaced filter. System is operational upon completion.

Upon arrival performed maintenance on AC system. All parts are relatively new on condenser. Tested everything and looked good. Condenser fan motor in range. Refrigerant levels good . Circuit board & electrical connections are in range. Blower wheel is extremely dirty. Client is thinking about doing cleanings in the fall. System has no surge protection on system. System is operational upon completion.

Upon arrival performed maintenance on AC system. All parts are relatively new on condenser. Tested everything and looked good. Condenser fan motor in range. Refrigerant levels good . Circuit board & electrical connections are in range. Blower wheel is extremely dirty. Client is thinking about doing cleanings in the fall. System has no surge protection on system. System is operational upon completion.

Upon arrival performed maintenance on AC system. All parts are relatively new on condenser. Tested everything and looked good. Condenser fan motor in range. Refrigerant levels good . Circuit board & electrical connections are in range. Blower wheel is extremely dirty. Client is thinking about doing cleanings in the fall. System has no surge protection on system. System is operational upon completion.

Upon arrival performed maintenance on AC system. All parts are relatively new on condenser. Tested everything and looked good. Condenser fan motor in range. Refrigerant levels good . Circuit board & electrical connections are in range. Blower wheel is extremely dirty. Client is thinking about doing cleanings in the fall. System has no surge protection on system. System is operational upon completion.

Technician arrived to perform spring tune up -Condenser was throughly cleaned out -System is 33 years old -Compressor and fan motor are really struggling and over amping -Refrigerant levels looked decent and was cooling the house -System isn’t in the best condition, some major repairs are commended, so it replacement

Upon arrival client stated system is not turning on. Found system to be tripped. Tested secondary motor control found it compellty flat. Replaced & got system going. Tested refrigerant levels, levels are in range. Advised client I can go to furnace to check the motors to make sure they are up to par. Says it’s ok he just got a tune up done to the system not to long ago, declined attic. Declined membership, cause system is old and wants to think about replacement in the future just not yet. Compressor is running at very high amperage’s, added everything up & system is most likely looking at 5-6 kWh. Client has solar. System is operational upon completion.

Upon arrival client stated system is not turning on. Found system to be tripped. Tested secondary motor control found it compellty flat. Replaced & got system going. Tested refrigerant levels, levels are in range. Advised client I can go to furnace to check the motors to make sure they are up to par. Says it’s ok he just got a tune up done to the system not to long ago, declined attic. Declined membership, cause system is old and wants to think about replacement in the future just not yet. Compressor is running at very high amperage’s, added everything up & system is most likely looking at 5-6 kWh. Client has solar. System is operational upon completion.