Hemet, CA

Upon arrival performed diagnostic found system to be non operational. Found secondary motor control to be completely flat. Replaced with heavy duty replacement. System is now cooling.

Upon arrival performed diagnostic found system to be non operational. Found secondary motor control to be completely flat. Replaced with heavy duty replacement. System is now cooling.

Arrived on site to diagnose a 2020 lennox system with zones not operational. Upon arrival client showed me zones and master control was only one operational and zones not available. System was operational and cooling. Inspected electrical compartment and circuit boards and connections. Secured all extra wires to a common boards rest both zone thermostat to de-energize. After all connections got secured rest system and thermostat and all zones were displayed on master control cycled system in cooling mode. System was in idle mode eating to stay and then all zones disappear in display and system is operating as one zone only. Fond voltage was good in main control board. zone board was receiving low voltage but zone terminals were not send out power on zone board. Advised client zone board is bad and would have to order a new board and will have to return to install once let come in. Client is aware and understands board is from factory and that system is still operational but only as a c

Upon arrival performed maintenance on system. Clients hvac system was actually frozen from the compressor to the evap coil. De iced system, filter was extremely clogged and needed replacing. Opened up coil and it was an ice box. Check system and refrigerant levels, 20 degree temp split, Refrigerant levels are indicating that i am low on refrigerant. Client will call back if they decide to do refrigerant if happens again. As of now system is cooling, secondary motor control was replaced. And getting a 20 degree split.

Upon arrival performed maintenance on system. Clients hvac system was actually frozen from the compressor to the evap coil. De iced system, filter was extremely clogged and needed replacing. Opened up coil and it was an ice box. Check system and refrigerant levels, 20 degree temp split, Refrigerant levels are indicating that i am low on refrigerant. Client will call back if they decide to do refrigerant if happens again. As of now system is cooling, secondary motor control was replaced. And getting a 20 degree split.

Upon arrival performed maintenance on system. Clients hvac system was actually frozen from the compressor to the evap coil. De iced system, filter was extremely clogged and needed replacing. Opened up coil and it was an ice box. Check system and refrigerant levels, 20 degree temp split, Refrigerant levels are indicating that i am low on refrigerant. Client will call back if they decide to do refrigerant if happens again. As of now system is cooling, secondary motor control was replaced. And getting a 20 degree split.

Upon arrival performed maintenance on system. Clients hvac system was actually frozen from the compressor to the evap coil. De iced system, filter was extremely clogged and needed replacing. Opened up coil and it was an ice box. Check system and refrigerant levels, 20 degree temp split, Refrigerant levels are indicating that i am low on refrigerant. Client will call back if they decide to do refrigerant if happens again. As of now system is cooling, secondary motor control was replaced. And getting a 20 degree split.

Upon arrival performed diagnostic on system, coming back out tomorrow to do repairs and maintenance, signed client up on membership. System is operational, replacing secondary motor control.

Upon arrival performed diagnostic on system, coming back out tomorrow to do repairs and maintenance, signed client up on membership. System is operational, replacing secondary motor control.

Upon arrival performed diagnostic on system, coming back out tomorrow to do repairs and maintenance, signed client up on membership. System is operational, replacing secondary motor control.

Upon arrival performed diagnostic on system, coming back out tomorrow to do repairs and maintenance, signed client up on membership. System is operational, replacing secondary motor control.

Upon arrival found system to be low on refrigerant, there is no pressure inside of system. System is r22 refrigerant, this refrigerant is no longer in use. Advised client we can fix refrigerant leak and add refrigerant and get system going, system is older and is using a lot of power usage. CLient is getting a hold of home warranties before doing any work.

Upon arrival found system to be low on refrigerant, there is no pressure inside of system. System is r22 refrigerant, this refrigerant is no longer in use. Advised client we can fix refrigerant leak and add refrigerant and get system going, system is older and is using a lot of power usage. CLient is getting a hold of home warranties before doing any work.

Upon arrival found system to be low on refrigerant, there is no pressure inside of system. System is r22 refrigerant, this refrigerant is no longer in use. Advised client we can fix refrigerant leak and add refrigerant and get system going, system is older and is using a lot of power usage. CLient is getting a hold of home warranties before doing any work.

Upon arrival found system to be low on refrigerant, there is no pressure inside of system. System is r22 refrigerant, this refrigerant is no longer in use. Advised client we can fix refrigerant leak and add refrigerant and get system going, system is older and is using a lot of power usage. CLient is getting a hold of home warranties before doing any work.

Arrived on site to diagnose a 2002 York system that is freezing over. Cleats te he had just moved in and believes unit is from 2003. Found York unit to be from 2002 and unit dose turn on. Upon cycling system on found out the units return very is covered up by some panty and drawer and is really suffocating unit and after running for a long period of time evaporator coil will freeze over as there is not enough airflow passing by the indoor coil which then will freeze and airflow will be reduced a lot due to restrictions and iced up coil. Removed drawer and had system running. Also found home to have a 3 ton unit which is way over sized for home that is no bigger then 500 sqft. Client is aware of what is going on and why his unit is freezing up. Client did declined signing up for Esa but will talk it over with wife and call us to sign up. System is running and cooling home good with our freezing. System is operational and cooling upon departure.

Performed heating maintenance on a Lennox furnace. Heating temperature split is 56 degrees. Filter is clean. Combustion motor is over amping. Ignitor is in range. Indoor blower motor is slightly dirty but amping in range. Flame sensor was cleaned. Duct runs are sealed. Customer notes ceiling under the furnace has cracks. Furnace platform is installed correctly on to framing of the attic. System was cycled before leaving.

arrived to diagnose a no cooling or operating 2014 system. Client stated he lived in home for a few years and recently had a dog and the dog had chewed up the line set and the thermostat wires. Upon arrival found outdoor unit thermostat wires to be all chewed up and gone. Line set insulation is gone as as well. Cycled Ac and out door unit did not turn on at all. Inspected electrical thermostat and one low voltage wires was completely ripped apart and the other was chewed up. Found low voltage wires to still be getting low voltage. Advised client of repair. Client just wanted to just get system up and running. Client just wanted to do minimum repair to get system operational. Repaired thermostat wires and insulated line set lines as well. System was operational and cooling after repair. Client did want to hold off on maintenance plan as well.

Arrived back on site to return for repairs. Client is aware repairs done today are just a Bandaid repairs to buy to for now and keep system operating. Mom is aware and system is old and replacement is best long term solution but due to conditions client would like to just rebuild system for now due to the cost of system replacement. Replaced primary and secondary motor controls. Condenser fan motor and added a compressor booster kit and chemically cleaned condenser coil inside and out unit is now clean. Checked pressure and system hold charge of 60/185 and is cooling home at 22 degrees. System is running and operating at the best it can for now due to it’s condition and over age. System is operational and cooling upon departure.

Arrived on site to diagnose a no cooling unit. Melissa is the mom and living in home and son is owner. Client stated unit stopped cooling 2 days ago and she replaced fan motor thinking it would help and Cale’s us out here. She knows unit is old. Inspected unit as it’s extremely dirty she stated systems did cool before. Found primary burnt up and worm out. Secondary motor was popped and bad. Advised client that would be minimum repair and inspected unit. Advised her fan motor is going bad and Compressor is pulling high amps. Would recommend compressor booster kit to help reduce high start up and prolong as much life as she can out of Compressor before it fails. Due to age and over all condition. She is aware system is really old but stated she is planning on moving and dose not want to look at replacement. She stated she would like to buy some time out of system for now as she will be moving and just wants to get through summer. Client wanted to rebuild system as she is aware it’

Returned to perform repairs. Unwelded existing condenser coil. Welded in new condenser coil. Also fixed weld on suction line as best as possible. Pressure tested with nitrogen to 380 psi, let sit for 30 minutes to ensure no leaks. Pulled a vacuum down to 550 psi. Charged unit back up with refrigerant to unit manufacturer specs. Let system run 30 mins, pressure are in range and system is producing proper temperature split. System is operational upon departure.

Arrived on site to diagnose a 2004 system that is not cooling. Client moved in 5 years ago and thought system was from 2010. He also stated he opens up unit as I arrived to unit opened up and top and panel and electrical compartment as he tried to trouble shoot as he knows basic of this and his buddy advised him of a couple thing to check and found breaker was tripped. He would try and trouble shoot and manually pushed in primary control and system would short out. Inspected electrical connections and components. Started isolating components at a t time and found out compressor is bad as it keeps shorting out breaker switch. Advised client due to the high voltage the compressor is the only thing that could Tripp breaker cause of the short and high amount of voltage that is used. Went over all findings and repairs and recommendations with client. Client is aware of what was going on and issues with system. Client stated he had to think it all through as to what he would like to do as

Performed diagnostic on 8 year old Goodman system. Met with Jose the tenant. System is not cooling. Tenant states they had to add refrigerant in September. Cycled system for cooling. Unit kicks on normally , no cold air coming out of the vents. Checked refrigerant levels and refrigerant is nearly flat. Found leak at outdoor condenser coil on bottom corner. Welds on refrigerant lines also look very bad. Called homeowner to go over findings and recommendations. Need to get a price from Goodman for condenser coil. Will be following up with. homeowner tomorrow. Homeowner approved to charge card on file for diagnostic, fee will go towards repair if moved forward.

Performed diagnostic on system. Homeowner moved in a couple months ago. Says his Ac works fine but there are wires in the condenser that are close to the blade and he’s scared the blade is gonna damage the electrical. Zip tied the wires out of the way. Cycled system system is cooling. Condenser fan motor is leaking oil. Also all the electrical components at the condenser are not installed properly, recommended redoing and cleaning up. Homeowner not interested at the moment. System is operational upon departure, no work performed.

Performed diagnostic on 5 year old Lennox system. Homeowner tried replacing thermostat and unit won’t start since. He tried putting old thermostat back and unit still not responsive. Checked for power at thermostat, not receiving voltage. Found a broken use on furnace circuit board. Replaced fuse, system kicked on. Cycled for cooling, system came on and is now cooling normally. Homeowner has really bad asthma that gets triggered with allergies. Recommended to replace filter more frequently than there current 6 month schedule. Also provided information on integrating a whole home air purification System to their unit. Also recommended routine maintenance done to the equipment to keep it in good condition. With homeowner approval went ahead and installed a Phenomenal Air system into unit return. Wired to a separate transformer. Also signed homeowners up on a monthly ESA maintenance program, and performed cooling maintenance on today’s visit. Checked condenser electrical and component