Hemet, CA

Upon arrival checked Freon levels, tested temperature inside of home and vents, air is coming at 65.5 degrees, refrigerant levels were found at the same place. Found filter drier to be having an 11 degree split. Client will call in the morning to schedule if she wants to move forward.

Upon arrival checked Freon levels, tested temperature inside of home and vents, air is coming at 65.5 degrees, refrigerant levels were found at the same place. Found filter drier to be having an 11 degree split. Client will call in the morning to schedule if she wants to move forward.

Upon arrival checked Freon levels, tested temperature inside of home and vents, air is coming at 65.5 degrees, refrigerant levels were found at the same place. Found filter drier to be having an 11 degree split. Client will call in the morning to schedule if she wants to move forward.

Client is moving from home. System is old and inefficient. Just wanted to make sure she didn’t need anymore charge, system is cooling, keeping up with 102 degree weather. System operational.

Client is moving from home. System is old and inefficient. Just wanted to make sure she didn’t need anymore charge, system is cooling, keeping up with 102 degree weather. System operational.

Client is moving from home. System is old and inefficient. Just wanted to make sure she didn’t need anymore charge, system is cooling, keeping up with 102 degree weather. System operational.

Client is moving from home. System is old and inefficient. Just wanted to make sure she didn’t need anymore charge, system is cooling, keeping up with 102 degree weather. System operational.

Upon arrival to Diagnose a no cooling unit on a 2018 Colman down flow. Client stated they live in home for a few years and a couple days ago had a tech out and had a bad thermostat. Client then bought his own and replaced it himself and few days later unit stopped working and cooling. Inspected and cycled unit found unit outside not turning on. Found breaker tripped. Inspected electrical compartment. Secondary was good and primary was good as well. Start up on compressor was at max. Recommend adding a compressor booster kit to start up low and in range. Run amps were good and in range. Checked pressure and pressure were good and in range and cooling home at 20 degrees. No protection on unit and advised client electrical surges and power outages that can trip breaker for damage or even short out something. Went over all findings and advised could have been power out the tripped breaker or due to bad condition and lack of maintenance could have cause it to work hard on a hot summer day

Tech arrived on site. Did 2 system tune up. New unit that was installed was good. Charge and temp split were perfect. No issues found. The older York unit was okay. Charge was good. Found minor leak in low side core. Attempted to fix.. added nylock to caps. Start components were okay. All had been replaced. Nothing was over amping. However the condenser fan motor was at max. Recommend replacing before it goes out. Charge and temp split were good. Added stickers for extra cooling capacity.

Arrived on site to diagnose system, Original from 1984, packaged unit on rooftop. Upon arrival customer states air is moving from vents but isn’t cooling. I Upon inspection of unit, diagnosed that the compressor fan is non operable, visibly had signs of heavy oil leakage and was receiving power. Due to the lack of cooling provided by the fan, the compressor is overheating and overamping pulling too much electricity causing the breaker to flip cutting power to the unit. Upon further inspection the secondary motor control has become low due to fan over amping due to lack of oil. Checked blower motor, upon inspection was heavily cover with dust and debris, further inspection shows blower motor secondary motor control to be low as well due to extra weight on motor. Contractor in unit is severely pitted and burned within housing. Was unable to test or read refrigerant levels due to compressor overheating. Recommended repairs to get system up and running, as well as preventative maintenanc

Upon arrival performed diagnostic. Found a nest thermostat to be bad. Still getting power to backboard of thermostat. Client is going to replace thermostat. System is not operational for an hour sign client up for a membership.

Upon arrival performed diagnostic. Found a nest thermostat to be bad. Still getting power to backboard of thermostat. Client is going to replace thermostat. System is not operational for an hour sign client up for a membership.

Upon arrival performed diagnostic. Found a nest thermostat to be bad. Still getting power to backboard of thermostat. Client is going to replace thermostat. System is not operational for an hour sign client up for a membership.

Upon arrival performed diagnostic. Found a nest thermostat to be bad. Still getting power to backboard of thermostat. Client is going to replace thermostat. System is not operational for an hour sign client up for a membership.

Performed diagnostic on 16 year old Goodman system. Homeowners state that the system is not cooling. It is blowing air but the air coming out is not cold. Cycled system for cooling. Indoor and outdoor unit kick on normally. Hooked up gauges to check refrigerant pressures. Found system to be completely flat on r-22 refrigerant, which is causing unit not to cool. Went over findings and recommendations with homeowners. Explained immediate repairs and repairs that possibly will be needed in the future that are related to a refrigerant leak within a system. Spoke about repair vs replacement of the system. Both homeowners agreed that repairing the system is out of the question, and replacing the unit is the better option. Offered to have someone come out and give replacement options. Homeowners stated their schedule at the moment is full with Dr appointments and they do not know when they will be available. Could not set a follow up date or time. System is not operational upon departure.

Replace secondary motor control on unit. NO WARRANTY OR GUARANTEE how long unit will operate as this is a short term repair to get client past the heat waves. Replace and system did operate just very inefficiently due to the age and compressor bad and going out due to age. Client is aware today’s repair just a bandaid and could fail at any time as it could fail next year or in 6 months. Advised replacement is the best for long term and if client calls us back in 2 weeks to replace systems with us we would credit back amount of today repairs. System is operational to the best it can and operate upon departure. Client is aware of all concerns and possibilities that could occur due to bandaid repair.

Customer cancelled appointment and said she didn’t know her schedule for rescheduling

Upon arrival performed diagnostic on hvac system. Found condenser fan motor to not be running. Tested secondary motor control, found system to not be in range. Replaced and got system going, also replaced primary start control that was pitted and burned. Client would like to upsize system to be more efficient. Set an appointment for Tuesday to come back out and give replacement options. System was reset tested and fully functional upon departure.

Upon arrival performed diagnostic on hvac system. Found condenser fan motor to not be running. Tested secondary motor control, found system to not be in range. Replaced and got system going, also replaced primary start control that was pitted and burned. Client would like to upsize system to be more efficient. Set an appointment for Tuesday to come back out and give replacement options. System was reset tested and fully functional upon departure.

Upon arrival performed diagnostic on hvac system. Found condenser fan motor to not be running. Tested secondary motor control, found system to not be in range. Replaced and got system going, also replaced primary start control that was pitted and burned. Client would like to upsize system to be more efficient. Set an appointment for Tuesday to come back out and give replacement options. System was reset tested and fully functional upon departure.

Upon arrival performed diagnostic on hvac system. Found condenser fan motor to not be running. Tested secondary motor control, found system to not be in range. Replaced and got system going, also replaced primary start control that was pitted and burned. Client would like to upsize system to be more efficient. Set an appointment for Tuesday to come back out and give replacement options. System was reset tested and fully functional upon departure.

Tech arrived on site. Found the low voltage wire disconnected. Replaced wiring and new insulation. Replaced contractor as well. Unit is cooling.

Arrived on site to diagnose a no cool unit. Arrived on site and spoke with client and he stated unit was cooling fine and then stopped cooling and had been blowing hot air into home. Inspected unit as it’s on roof and compressor was not operational. Found secondary motor control bad. Compressor un able to operate or cool. Replaced to test unit and compressor would start up and shut off and did it twice and then added a compressor booster kit and got compressor and system operating. Found primary okay slight burnt. Found high voltage distributor old and worn out as hot from heating over in past year from operation. Fan motor almost at max and why fan side is bad. Compressor is pulling max amps at 10 and max rated at 12. Advised compressor is on borrowed time and could fail any any time. Unit uses r-22 and is no longer in production. Pressure are okay but compressor is over working and is going bad from age and wear. Evaporator coil is dirty. Unable to open blower assembly but door is

Upon arrival performed diagnostic found system to be non operational. Found secondary motor control to be completely flat. Replaced with heavy duty replacement. System is now cooling.

Upon arrival performed diagnostic found system to be non operational. Found secondary motor control to be completely flat. Replaced with heavy duty replacement. System is now cooling.