Hemet, CA

System does not have enough air flow on return ducting. Causing very little air flow to come out of supply venting. Mateo to get with client. Need more return air.

System does not have enough air flow on return ducting. Causing very little air flow to come out of supply venting. Mateo to get with client. Need more return air.

System does not have enough air flow on return ducting. Causing very little air flow to come out of supply venting. Mateo to get with client. Need more return air.

Arrived on site to diagnose a 2003 furnace and a 2017 condenser. Client stated she’s has issues in past and think it could be the same. She just had her dad change the filter and unit stopped cooling. Since then nothing was operational. Inspected electrical unit and board. Board looked okay but is still old and original. Found transformer burning up and really hot due to working and age. Found low voltage fuse popped. Replaced and cycled unit and unit is operational now. Cycled 5 times and unit did coil and operate. Advised client what they did when they replaced filter and they said nothing. Advised this only happened with a short is created. Found no lose wires or burn marks. Advised this could happen again due to age of furnace. Told her now I’d the time to consider furnace replacement due to the age and condition and how parts are working. Compared to replacement of heater. Client is aware but did have unexpected repairs done in home and is gunna hold off. She want to do minimu

Arrived on site to perform spring tune up on a 2005 unit. Condenser on side of home. Client stated no issues just old but running. Cycled unit and good. Found filter dirty. Washed condenser coil inside and out. Found stater to be burnt up and old. Secondary motor control is good. Fan motor has been replaced in past and pulling in range of amps. Checked start up and are high and recommended compressor booster to preserve compressor from hard start up due to age and condition. Run amps are pulling 24 and max rated at 27. Advised compressor can fail at some time In The future. Checked preamp are good and hold R-22. Advised they no longer make that type of refrigerant pressure. Inspected indoor un it and found blower assembly dirty. Motor has been leaking a lot of oil due to age and over working. Motor can fail at any time. Wheel is dirty due to 1 in filter. Drain lines are clear but due have debris due to dirt entering unit in past. Recommend adding a safety over flow switches to prevent

Perform AC diagnostic on 1996 system. Upon arrival Allen is present and states that multiple repairs of been done within the last few years and most recently the company has been out it has fix the heater and tried to get the AC to work properly as well also mentioned that R22 refrigerant was added into the system but unsure how much was put in. Began diagnostic at thermostat and found that system is not turning on. Immediately proceeded to furnace and found that power was present at the low-voltage wiring but was wired incorrectly as well. Rewired circuit board properly and got condensing unit to turn on in cooling mode all the furnace would not activate indoor blower indicating that the circuitboard is defective. Circuit board has previously been replaced and Allen Had me call Laura to go over my findings. At this time Laura is aware of the current condition of her 1996 system. Advised her any repairs done will not guarantee extra life Because it is only a Band-Aid and a short term f

Arrived on site to perform spring tune up on a 2 unit. On 3 years old and other 16. Both condenser on side of home. Cycled both washed both condenser coils inside and out. Checked both electrical compartment. Both primary starters are good. Both secondary motor controls are good and in range. New unit fan motor is good. Older on has been leaking oil in past and pulling high amps. Start up amps are good on both and run amps are good but high on the older unit as it’s getting older. Both units are cooling at 22 degrees. Filters were good as they were replaced. Client now stated he added whole house protection to protect the whole home instead. Cycled both units. Client is aware how units are running and condition. Both units are operational upon departure.

Arrived on site to perform maintenance on 8 year old carrier system. Cycled system for cooling. Checked indoor unit electrical and system components. Temperature split is within range. Homeowner replaces his own Aprilaire filters. System does not have any condensation safety switches on condensation lines. Checked outdoor unit electrical and system components. Primary motor control is in good condition and secondary motor control within range. Amp draws are within range. Pulled condenser fan motor off and thoroughly washed out condenser coil inside and out. Went over findings and recommendations with homeowner. Signed homeowners up on monthly ESA maintenance program, waived today’s maintenance fee. System is operational upon departure.

Returned to install healthy climate PCO kit and finish AC maintenance on Lennox system. Healthy climate kit that was sent is not the correct one, need to order correct one and have tech come back out and replace. Performed coil wash on outdoor condenser. Pulled off all panels and washed thoroughly. Checked electrical and system components. System is operational upon completion.

System Totals out to $30,579 - Client is only liable for payment $28,201 as Tech Clean California Rebate will cover remaining $3,000 balance

Collected 2510 by check number 3787. Balance due is 20000 through GoodLeap

Upon arrival, client said the air conditioning wasn’t operational. Inspection found the started - located inside the condenser- was not operational. Was able to manually/temporarily fix starter for duration of the diagnostic. Once the unit was energized, was able to text the operation of system. Condenser fan motor is operational, but it has rust stains and oil leakage. Compressor would not start. Installed a new compressor hard start kit to try and get it operational. It would not energize. Need to replace compressor and start components and refrigerant to get system operational again. Due to age and cost of repairs, the client wanted to explore replacement options. Grave quote for complete new AC and heating system. System is not operational upon departure.

Upon arrival performed diagnostic. Found thermostat to be completely blank, have voltages going to system but no thermostat. Jumped system got AC to kick on, but no fan motor running. Tested blower motor terminals, found system not giving any output for motor to kick on. Tested on heat, motor kicks on with power in terminals. Verified circuit board is bad. Advised adding 2 surge protectors to system to keep protected from any power outages. Client is having Mateo come over and give replacement options. Ordering parts if client doesn’t wanna move forward with system.

Upon arrival performed diagnostic. Found thermostat to be completely blank, have voltages going to system but no thermostat. Jumped system got AC to kick on, but no fan motor running. Tested blower motor terminals, found system not giving any output for motor to kick on. Tested on heat, motor kicks on with power in terminals. Verified circuit board is bad. Advised adding 2 surge protectors to system to keep protected from any power outages. Client is having Mateo come over and give replacement options. Ordering parts if client doesn’t wanna move forward with system.

Upon arrival performed diagnostic. Found thermostat to be completely blank, have voltages going to system but no thermostat. Jumped system got AC to kick on, but no fan motor running. Tested blower motor terminals, found system not giving any output for motor to kick on. Tested on heat, motor kicks on with power in terminals. Verified circuit board is bad. Advised adding 2 surge protectors to system to keep protected from any power outages. Client is having Mateo come over and give replacement options. Ordering parts if client doesn’t wanna move forward with system.

Upon arrival performed diagnostic. Found thermostat to be completely blank, have voltages going to system but no thermostat. Jumped system got AC to kick on, but no fan motor running. Tested blower motor terminals, found system not giving any output for motor to kick on. Tested on heat, motor kicks on with power in terminals. Verified circuit board is bad. Advised adding 2 surge protectors to system to keep protected from any power outages. Client is having Mateo come over and give replacement options. Ordering parts if client doesn’t wanna move forward with system.

Upon arrival, installed the limit switch. Turned on unit. Found fan to be operational when nit calling for heating or cooling. After extensive testing found the fan controller to be stuck closed. Advised client. Client wants to move forward with repairs in a week.

Arrived on site to perform diagnostic on 1983 unit homeowner states pilot is not staying lit. Homeowner had a handyman come out and shut the unit off as the pilot was not staying lit. Tested for proper voltage, unable to ignite pilot light although gas valve is receiving proper voltage. Handyman that had performed previous work has shut the gas off from the actual gas valve itself, which could have possibly caused it to get stuck closed. Gas valve will need to be replaced due to age of equipment gas valve is unavailable. Went over findings and recommendations with homeowner and daughter over the phone. They would like to go over replacement options. Turning call over to Darren to come out and give options. Collected diagnostic. System is not operational upon departure.

Arrived on site to perform heat pump diagnostic on 2010 trane system. Upon arrival Sylvia stated that the system has not worked for years and has never worked right ever since it was installed. She also stated that the system has had multiple issues and has been worked on previously by another company in Orange County although they are not around this time. It seems that every time it gets fixed it ends up breaking down but they Have recharged the unit multiple times and fuses keep popping. Began diagnostic at air handler in found that system was installed upside down and panels were unable to be opened. Thermostat has also been destroyed due to dogs chewing it up. At this point client is looking for a more long-term solution rather than continuing to fix a unit that was never installed properly. She also mentioned the ductwork has different areas that are damaged and will have a side man potentially repair it although we will give her options for ductwork repair as well. At this time

Upon arrival performed Tunenup on x series AC pro system. Indoor motor and wheel are in very good condition. Client has already replaced filter once. Advised keep on filter cause client has pets in home. Dusted off all electrical components. System is running very efficiently. Thermostat in working order. Purged through condensation lines. Tested t safety float switch. Circuit board and electrical connections in range. Washed outdoor coils. Tested voltages amperage’s. Advised adding surge protection to keep high efficiency units protected from any electrical faults. Offered client to join membership program. Had to leave to pick up grand daughter, will call after she thinks about it. System is operational and working good.

Upon arrival performed Tunenup on x series AC pro system. Indoor motor and wheel are in very good condition. Client has already replaced filter once. Advised keep on filter cause client has pets in home. Dusted off all electrical components. System is running very efficiently. Thermostat in working order. Purged through condensation lines. Tested t safety float switch. Circuit board and electrical connections in range. Washed outdoor coils. Tested voltages amperage’s. Advised adding surge protection to keep high efficiency units protected from any electrical faults. Offered client to join membership program. Had to leave to pick up grand daughter, will call after she thinks about it. System is operational and working good.

Upon arrival performed Tunenup on x series AC pro system. Indoor motor and wheel are in very good condition. Client has already replaced filter once. Advised keep on filter cause client has pets in home. Dusted off all electrical components. System is running very efficiently. Thermostat in working order. Purged through condensation lines. Tested t safety float switch. Circuit board and electrical connections in range. Washed outdoor coils. Tested voltages amperage’s. Advised adding surge protection to keep high efficiency units protected from any electrical faults. Offered client to join membership program. Had to leave to pick up grand daughter, will call after she thinks about it. System is operational and working good.

Upon arrival performed Tunenup on x series AC pro system. Indoor motor and wheel are in very good condition. Client has already replaced filter once. Advised keep on filter cause client has pets in home. Dusted off all electrical components. System is running very efficiently. Thermostat in working order. Purged through condensation lines. Tested t safety float switch. Circuit board and electrical connections in range. Washed outdoor coils. Tested voltages amperage’s. Advised adding surge protection to keep high efficiency units protected from any electrical faults. Offered client to join membership program. Had to leave to pick up grand daughter, will call after she thinks about it. System is operational and working good.

Upon arrival Performed heat pump tune up. Indoor filter is dirty, UV light is out. Circuit board and electrical connections are good, but there is no protection on system. It started raining outside, client said to please not do outside doesn’t wanna damage system. Will do rest when replacement of lights and UV.

Upon arrival Performed heat pump tune up. Indoor filter is dirty, UV light is out. Circuit board and electrical connections are good, but there is no protection on system. It started raining outside, client said to please not do outside doesn’t wanna damage system. Will do rest when replacement of lights and UV.