Canyon Lake, CA

During my twenty point inspection, I started with downstairs unit. Took condenser lid off, to start hosing down condenser coil of any dirt and debris. Coil is starting to deteriorate on inside of coil. Opened condenser cabinet and checked everything thoroughly. Starter (good), fuses (good), dual secondary motor control (good), 24v (good), 120v (good), refrigerant levels sh 31, sc 22, osa 84, delta 24. Then went onto the furnace and checked furnace cabinet thoroughly. Blower motor (good), single secondary motor control (good), motherboard (good), 24v (good), 120v (good). House cools great and ready for summer. Went onto upstairs unit and took condenser lid off. Started hosing down condenser coil of any dirt and debris. Coil is starting to deteriorate on inside of coil. Opened condenser cabinet and checked everything thoroughly. Starter (good), fuses (good), dual secondary motor control (good), 24v (good), 120v (good), refrigerant levels sh 33, sc 18, osa 83, delta 22. Then went onto th

Arrived on site to perform diagnostic on upstairs unit not cooling. Client stated unit was running and was like 90 degrees in home and then unit stopped running and cooling home and started to get warmer. Inspected electrical compartment and found board bit color discoloration due to wear over time. Stater was burnt up from operation. Fan motor is okay slight oil but in range of amps. Checked pressure and pressure are good and cooling home. While cycling unit found compressor was really struggling to turn on every time. Unit already has a booster kit and is still struggling. Checked indoor unit. Found retune side leaking and is sucking i. Dirt from attic covered up with tape for now. Ducting is very bad and losing cooling in attic. Checked drain lines and found that unit only has one line going outside and they eliminated the secondary and put over flow switches. Found primary line clogged up and water was tripping safety switches. Advised can do a basic clear out for now but due to

Performed an AC maintenance on a 2021 Samsung system. Checked temperature splits as well as all electrical components and both of them where in range. Cleaned off condenser unit with no wash chemical spray. Checked filter and it was exceptionally dirty, filter was changed. Checked drain lines and there was a clog from the filter being completely caked. Used compressed air to clear out the drain line and is now unclogged. System was fully operational on time of departure.

During my AC maintenance I started off with hosing down condenser coil of any dirt and debris. Opened condenser cabinet and checked everything thoroughly. Starter (good), fuses (good), motherboard (good), dual secondary motor control (good), 24v (good), 120v (good), refrigerant levels sh 12, sc 4, osa 86, delta 20. Then went onto the furnace and checked furnace cabinet thoroughly. Blower motor (good), single secondary motor control (good), motherboard (good), 24v (good), 120v (good). House cools great and ready for summer.

Performed maintenance on a Lennox heat pump. Temperature split is in range. Filter is clean. Condensate lines are clear and flowing good. Indoor coil is clean. Indoor amp draws are in range. Condenser was chemically washed. Refrigerant levels are ok. Starting components are in range. Cycled system, system is operational upon departure.

Arrived on site to perform spring tune up on a 1 year old unit. Package unit on roof. Client stated no issues. But a platform had to be built for us to perform maintenance safety and not put her solar panels at risk. Platform was made performed tune up. Washed condenser coil inside and out. Electrical compartment was good and both motors are in range of amps. Checked safety switches and pressures and unit is holding steady charge and cooling home at 20 degrees. No protection on unit and recommended adding some. Cycled unit and went over how unit is running and recommendations. Client is aware but did hold off as she wanted her husband to be emailed it all over so he can read. Client did declined the maintenance plan for now. Client didn’t want to pay for the platform to be made and kept at her location so would be taking platform and advised with out it we will not be able to perform maintenance safety for us and her solar panels. She is aware. Unit is operational upon departure.

Arrived and performed spring tune up on 2 units. One 2013 heat pump and one 2005 package unit. Client stated no issues as unit do cool and they know one unit is older. Washed both condenser coils inside and. Checked electrical compartment on both units. Found secondary bad in package unit. Heat pump is in range. Starter is pitted on contact points. Heat pump stater is good. Fan motor is over amping on the package unit. Would recommend replacing but they stated they just waiting for it to fail and they are think of replacing package unit. Heat pump motor is good and in range. Checked start up amps and are in range just high. Recommend adding a compressor booster kit to package unit to help prevent hard start up older compressor. Both units hold R410-a checked pressure and both are good and cooling. Package unit just had ducting replaced in past and good. Inspected ducting in attic for heat pump and found gray flex ducting used and is falling apart and is losing cooling temperature in a

Diagnosed miswired condenser

Upon arrival performed maintenance on AC system. Washed condenser coils out compellty. Coils are nice and clean. Circuit board & all electrical is in good condition. Indoor motor & wheel good. Replaced filter client provided. Surge protector in working order. Thermostat & all zones in working order. System is operational upon completion.

Upon arrival performed maintenance on AC system. Washed condenser coils out compellty. Coils are nice and clean. Circuit board & all electrical is in good condition. Indoor motor & wheel good. Replaced filter client provided. Surge protector in working order. Thermostat & all zones in working order. System is operational upon completion.

Upon arrival performed maintenance on AC system. Washed condenser coils out compellty. Coils are nice and clean. Circuit board & all electrical is in good condition. Indoor motor & wheel good. Replaced filter client provided. Surge protector in working order. Thermostat & all zones in working order. System is operational upon completion.

Upon arrival performed maintenance on AC system. Washed condenser coils out compellty. Coils are nice and clean. Circuit board & all electrical is in good condition. Indoor motor & wheel good. Replaced filter client provided. Surge protector in working order. Thermostat & all zones in working order. System is operational upon completion.

Arrived on site to perform diagnostic on unit. Upon arrival, homeowner stated that unit is operating and is cooling and would just like it looked over. He does however plan to replace the unit in September. He is pulling out a major loan for a full house remodel, and is replacing the AC at that time. Basically just needs an estimate to replace the system to put it into loan, however I did mention that our price is good for 30 days, and anything past that we would have to come out and requote it.He will be calling us for an estimate closer to when they are ready.

Inspected the bedroom vent for airflow options

Installation of 25 SEER Full Variable Speed System + Full Duct remodel

Preformed ac maintenance on heatpump condenser.

Performed heating maintenance on a 2017 Lennox heat pump. Outdoor unit was chemically washed. Outdoor electrical components were tested measured and are in range. Heating temperature split is in range. Indoor coil is clean. Indoor sensors and switches were cleaned and tested. Condensate lines are clear. Thermostat was cycled. Filter is clean. System is operational at end of appointment.

Performed combo maintenance on a 2012 Bryant heat pump. Heating controls and temperature split is in range. Filter is clean at this time. Indoor coil is clean. Indoor blower motor is amping in range. Outdoor unit was chemically washed. Start amps are almost at max range, this will be higher once the temperature rises. Refrigerant levels are Ok. Customer was briefed on the condition. He has multiple homes and wants to just get maintenance done. System is operational.

Combo Tune Up Performed- performed maintenance on a Lennox system. Upon arrival system is working and operational. I began my maintenance at the outdoor unit by breaking it down and cleaning with water and solution. Removed heavy amounts of dirt and debris. I then inspected all electrical components for signs of wear and checked for tight connections. I measured amp draws and recorded refrigerant pressures. I then proceeded to the indoor furnace unit. Here I took temperature splits and measured static pressures. I inspected the condensate lines for proper drainage. I checked electrical components for tight connections and wear. Inspected the blower housing for balance and dust. Checked heating components for wear. Inspected heating components for proper operation. Filter has been changed at this time, cool air provided 20x25x5 merv 16 filter. Upon departure systems is working and operational.

Two system Lennox furnace tuneup. Tested heating systems and recorded temperatures. Cleaned flame sensors. Tested ignitors. Measured amp draws. Monitored ignition and checked ducting for leaks. Labeled equipment and logged all equipment models and filters.

Arrived on site to perform heatpump diagnostic on 2006 Neil system. Upon arrival Mike stated that he’s lived in the house for approximately five years and Has had no issues or maintenance done. He states now for a couple weeks that the system has been short cycling and not getting to temperature and the only way for him to get it to turn on is by shutting it on and off at the breaker but even after that it’s only runs for a short period of time also creating a extremely high electric bill due to this. Began troubleshooting at air handler and found that everything was operational at this area, proceeded to outdoor unit and did full inspection and found that system was low on R22 refrigerant which was completely phased out January 1, 2020. system was also over amping and exceeding 21 Amp for what it’s rated for using a total of 23 Amps and higher till it shuts off. Also checked other electrical components and found at that the high voltage distributor has burning and pitting marks

Upon arrival client stated system did not heat when turning on. Advised if temp is under sub40 degrees, heat pumps have trouble kicking on. System is on now, have a good temp split coming out of vents from intake. System is operational. Advised client what is going on. Son let me inside home.

Upon arrival client stated system did not heat when turning on. Advised if temp is under sub40 degrees, heat pumps have trouble kicking on. System is on now, have a good temp split coming out of vents from intake. System is operational. Advised client what is going on. Son let me inside home.

Upon arrival client stated system did not heat when turning on. Advised if temp is under sub40 degrees, heat pumps have trouble kicking on. System is on now, have a good temp split coming out of vents from intake. System is operational. Advised client what is going on. Son let me inside home.

Upon arrival client stated system did not heat when turning on. Advised if temp is under sub40 degrees, heat pumps have trouble kicking on. System is on now, have a good temp split coming out of vents from intake. System is operational. Advised client what is going on. Son let me inside home.