Winchester, CA

Technician arrived to perform spring tune up -Condenser was thoroughly cleaned out and debris was removed -Refrigerant levels were within range -The Condenser fan motor and compressor are in bad condition. -The fan motor is maxed out amps (.93/1) and is rusted out, cracking, and leaking oil, which is a sign when the motor is dying -The compressor struggle to start up, it is maxed out on amps as well at (18/18) and is drawing a lot of power -The system is 23 years old and if the client wants to get the most out of it, the fan motor, a compressor saver kit, and a new secondary motor control are definitely recommended -The system is doing it job and cooling, but it is doing it very inefficiently and needs some repairs

Upon arrival started installing new fan motor and capacitor. Cut fan motor shaft to length. Wired with new connectors. Installed capacitor. Tested system and verified proper rotation. Unit is operational upon departure. 1 year parts/labor warranty.

Arrived on site to perform diagnostic on unit. Upstairs unit is not cooling. Everything is running but it is just not dropping in temperature. Cycled system for cooling. Unit kicked on. Unit is not producing any temperature split or cooling effect at all. Checked outdoor unit electrical and system components. Compressor is short cycling on and off, all electrical is in proper range. Gauged up to system and found system to be basically flat on refrigerant, low side is actually going into a vacuum mode. Compressor is short cycling due to no lubrication and running hot. Evaporator coil is completely sealed with pookie and pookie tape and cannot be opened without using extreme force to perform pressure check. No signs of oil or refrigerant leak at outdoor condenser. Went over findings and recommendations with homeowner. Also mentioned that at one point there was water leaking from ceiling but then stopped. It is more than likely that system iced up from being low on refrigerant and water l

Upon arrival, found a 6 year old condenser and 8 year old furnace. 3 ton single staged zoned system. Went to the condenser and checked electrical. The capacitor had been replaced. Charge is good. Compressor amps are okay. Fan motor amps are good. Cleaned condenser coils. Temp split was off. 13/20. Found static pressure to be off the charts high. Airflow is super restricted. Return ducts should be increased in sized or add another one. But, space is limited in attic. Informed client on options. Will look into more long term solutions with service manager. System is operational upon departure.

Performed AC maintenance on heat pump. Inspected unit and found transformer to be pitted. I highly recommend this component to be replaced. Tested capacitor as weak and should also be replaced. Washed condenser coils. Unable to check filter as it was inaccessible-tenants bed was under filter grill. This unit does not have surge protection. System is cooling and operational upon departure. Unable to get a hold of the homeowner for recommended repairs will follow up with homeowner in a few days

Performed city inspection via zoom with riverside county.

Upon arrival, client said original issue had gotten worse. Water was still coming out from the secondary line out the side of the house. First diagnostic seemed the drain lines were not installed right from the original install. This turned out to be wrong. Found the primary pan to be cracked. Informed client. Because of circumstances, credit back original repair towards the cost of the drain pan replacement.

Upon arrival started tune up on both systems. Systems are operational. Having same issues as previous visit but they are getting worse and affecting other components. Mainly the upstairs system. The condenser fan motor is failing. Will most likely fail with the summer heat. This stress is making the compressor fail. Both are using high motor amps. Cleaned both condenser coils and checked electrical. Found capacitor on upstairs system out of range. This will fail this summer. Recommend replacing it to avoid other electrical failures. Change is good on both systems. Made detailed recommendations. Systems are operational upon departure.

Arrived on site. Client said unit would drain out secondary drain. Found condensate line to be installed incorrectly, and it was clogged. Retrofitted drain line and cleaned it out. Cleaned out under the sink. Installed flood protection system. Clients signed up on maintenance program. Unit is operational upon departure.

Arrived on site and performed AC maintenance on two systems aireflo condensers from 2006. Upon arrival Ryan stated they just moved in in November and signed up on the maintenance plan to keep Up on maintenance and Keep system at standard. Performed fall maintenance on outdoor unit. Finds- Upstairs- 1. Outdoor condensing fan motor had significant oil leak is coming from its bearing which can result in at locking up or over heating. 2. Dual secondary motor control has become weak and out of range 3. Starter is significantly burned on contact points and can result on failure for start up. 4. System contained R22 refrigerant which was phased out 2020 5. Recommend compressor saver kit is installed to reduce startup amperage and increase longevity for compressor 6. System is not equipped with surge protection in the case of a power surge. 7. Indoor blower motor had oil leakage occurring as well and can result in failure and heating and cooling if this worsens Downstairs- 1. Starter was signi

Upon arrival performed maintenance on AC system. On brand new Xp20. Indoor motor and wheel in very good condition. Circuit board and electrical connections good. Ducting in very good condition. Condenser coils were cleaned completely. Amperage’s & voltages in range. System is operational upon completion.

Upon arrival performed maintenance on AC system. On brand new Xp20. Indoor motor and wheel in very good condition. Circuit board and electrical connections good. Ducting in very good condition. Condenser coils were cleaned completely. Amperage’s & voltages in range. System is operational upon completion.

Upon arrival performed maintenance on AC system. On brand new Xp20. Indoor motor and wheel in very good condition. Circuit board and electrical connections good. Ducting in very good condition. Condenser coils were cleaned completely. Amperage’s & voltages in range. System is operational upon completion.

Upon arrival performed maintenance on AC system. On brand new Xp20. Indoor motor and wheel in very good condition. Circuit board and electrical connections good. Ducting in very good condition. Condenser coils were cleaned completely. Amperage’s & voltages in range. System is operational upon completion.

Perform for AC maintenance. Checked and tightened electrical components. Inspected ducting for proper airflow made sure everything was connected and they were No sinks in the ducting. Measure temperature split at 20°. System has zoning. Inspected proper balance of indoor blower wheel. Inspected condensate lines. Clean outdoor coil remove debris from the bottom of the unit. Tested capacitor it is within range. Inspected outdoor fan motor and measured amperage. Checked filters customer had just changed last week. System does not have search protection for float switch on drain pan. System is cooling and operational upon departure.

Arrived on site and found that jumper was placed between B And R causing the system to stay stuck in heating mode. Removed jumper and system is cooling properly upon departure.

Inspected the system for operation and diagnosed drain issue.

Arrived on site to perform AC diagnostic on 13-year-old Maytag condensing unit for manufactured home. Upon arrival Diana stated that her husband is in the hospital and needs to get the system working properly before he comes home. She states that the company that originally installed the system is not honoring their lifetime warranty and will no longer service the unit. Began diagnostic at thermostat and found that the Thermostat was defective. Proceeded to furnace and found a very strong propane smell admitting from the gas valve. Shut gas valve off for the meanwhile until this problem is addressed in the future. Filter was heavily caked and extremely restrictive which has resulted in the air mixing cabinet becoming covered in dust and debris. Indoor blower motor is leaking oil from its bearing and is moving less air capacity across the evaporator coil due to it overworking over the years. Proceeded to outdoor unit and found that it was operational although the duel secondary motor co

The total job in 17707. Customer will pay 14707 and cal tech California will pay 3000

1 - 3 and 1 - 4ton ton furnace coil and condensers x-series System totals out to $26,843.00.00- client is only liable for payment of $20,843.00as Tech clean California rebate will cover $6000.00 balance.

Arrived on site to perform AC maintenance on 2004 Bryant condensing unit. Upon arrival Shane states that he just moved in approximately two months ago and he’s doing this maintenance to verify the condition of his system. Performed full maintenance And discovered multiple faults within the system that will lead to failure. 1. Measured refrigerant pressures and found that there is a restriction within the unit. This is resulting in a pressure imbalance in the which Causing the compressor to overwork putting in at a very high risk of failing lack of efficiency. 2. Dual secondary motor control is Weak And causing the compressor to overwork. 3. Outdoor condensing fan motor and indoor blower above leaking oil from its bearing 4. Starter showed signs of pitting and burn marks on contact points. 5. Static pressure is lower than usual due to blower motor slowing down in speed from oil loss 6. System contains R22 which was completely phased out January 1, 2020 Discussed full maintenance with

System qualifies for promotional financing: Reduced apr at 102 per month or 18 months no payments no interest Total job is 12987. Amount to be collected will be 9984. Amount paid to us by the cal tech California rebate program will be $3000

Performed AC maintenance on a pair of Carrier Condensers. Customer Reports frequent usage of the system in the summertime. Both units started with no issue. System has had repairs done in the past. Condenser fan motors Are significantly leaking oil, this can cause interruption during heavy usage. Outdoor units were chemically cleaned. Starting components were measured and tested. Outdoor amp draws are in range on both units. Refrigerant levels are OK. Indoor amp draws are OK. Cooling temperature split are in range for both units. Customer is aware of the condition. Systems are operational.

Upon arrival performed maintenance on AC system. System is older and is running high in electrical but is still below manufactured specs. Secondary motor control is in range. Indoor blower wheel is extremely dirty . Primary drain was clogged at p trap and at bottom of sink. Re worked drains, and added safety switch. System is now draining correctly. Primed drain with half a gallon of water. Refrigerant levels in range. Client replaced his filter. No models or serials, rubbed off. Client has a big hole in ducting might have a rat problem.

Upon arrival performed maintenance on AC system. System is older and is running high in electrical but is still below manufactured specs. Secondary motor control is in range. Indoor blower wheel is extremely dirty . Primary drain was clogged at p trap and at bottom of sink. Re worked drains, and added safety switch. System is now draining correctly. Primed drain with half a gallon of water. Refrigerant levels in range. Client replaced his filter. No models or serials, rubbed off. Client has a big hole in ducting might have a rat problem.