Wildomar, CA

Upon arrival found downstairs condensate lime clogged. Water was in secondary pan. Flushed out line from inside the evap coil. Tested drain system. System was draining properly. Did preventive flush on upstairs system as well. Client moved forward with maintenance plan.

Upon arrival began installing new parts. Inducer fan motor and safety switch. Cleaned out blower motor. Tested heating operation. Went to the condenser and checked condenser. Charge is okay. Condenser fan motor is rusting and almost amping at max. Would recommend replacing that motor. Cleaned condenser coil. Unit is operational upon departure.

Upon arrival performed maintenance on Lennox system. System is a bit older but is still operational. Compressor start amps are very close to max amps, system is about 3 amperage’s away from hitting max. Secondary motor controls are both out of range. Condenser fan motor is leaking oil but is running under max amps. Primary starter good. Thermostat in working order. Indoor secondary control is out of range. Ducting is a bit undersized losing about 200 cfm on supply & return. High electric bills on usage for system. Client states house stAys cools so don’t really use it. System was reset tested and functioning.

Upon arrival performed maintenance on Lennox system. System is a bit older but is still operational. Compressor start amps are very close to max amps, system is about 3 amperage’s away from hitting max. Secondary motor controls are both out of range. Condenser fan motor is leaking oil but is running under max amps. Primary starter good. Thermostat in working order. Indoor secondary control is out of range. Ducting is a bit undersized losing about 200 cfm on supply & return. High electric bills on usage for system. Client states house stAys cools so don’t really use it. System was reset tested and functioning.

Upon arrival performed maintenance on Lennox system. System is a bit older but is still operational. Compressor start amps are very close to max amps, system is about 3 amperage’s away from hitting max. Secondary motor controls are both out of range. Condenser fan motor is leaking oil but is running under max amps. Primary starter good. Thermostat in working order. Indoor secondary control is out of range. Ducting is a bit undersized losing about 200 cfm on supply & return. High electric bills on usage for system. Client states house stAys cools so don’t really use it. System was reset tested and functioning.

Upon arrival performed maintenance on Lennox system. System is a bit older but is still operational. Compressor start amps are very close to max amps, system is about 3 amperage’s away from hitting max. Secondary motor controls are both out of range. Condenser fan motor is leaking oil but is running under max amps. Primary starter good. Thermostat in working order. Indoor secondary control is out of range. Ducting is a bit undersized losing about 200 cfm on supply & return. High electric bills on usage for system. Client states house stAys cools so don’t really use it. System was reset tested and functioning.

Arrived on site to perform maintenance on 2 Bryant AC units. Cycled systems for cooling. Checked indoor units electrical and system components. Temperature splits in range. Ducts are properly sealed. Blower wheels are both have dirt build up. Replaced 1 inch filters. Checked outdoor unit electrical and system components. Compressor and condenser fan motor amperages are both high and working inefficiently. Condenser fan motors are both leaking oil. Right side unit has a low secondary motor control for compressor. Pulled condenser motor and thoroughly washed out condenser coil inside and out. Went over findings and recommendations with Levi. He is fully aware of the condition of the system and concerns. Wants to hold off on doing any work today until it gives out. Cycled system, system is operational upon departure.

Arrived on site to perform AC diagnostic on 2006 Goodman condensing unit. Upon arrival homeowner stated that they moved in Around April and Have had a ton of renovations done to the home and just on the weekend they noticed that it was no longer blowing any air out of the vents. They also stated that the inspector didn’t say anything and no maintenance has been done on the system. Started off at filter and found that it was heavily restricted with dog hair and debris. Removed filter and replaced with new one. Proceeded to outdoor unit and found that it was operational. Measured refrigerant pressures and found that it may have been slightly low but after about 10 to 20 minutes of running it began to fall In range. Although Condenser did contain a phased out refrigerant called R22 which is no longer manufactured as of 2020. Electrical components checked out properly on outdoor unit. Proceeded to Furnace inside of attic. Found indoor blower motor has lost a severe amount of oil from his

System totals out to $10,379 - Client is only liable for payment of $7,379 as Tech Clean California Rebate will cover remaining $3,000 balance.

Arrived on site and performed AC maintenance on four-year-old system. Inspected indoor unit in attic did see signs of water leakage inspected condensate line for proper flow and make sure it was clear of debris and did not have any cracks system does have drain pan and float switch. Determined water was not from HVAC unit. Customer is aware. Inspected electrical components and tightened. Changed filter. Cleaned outdoor condenser coils and remove debris from bottom of unit. Tested capacitor it is within range. Inspected contactor and measures amp on fan. System is cooling in operational upon departure.

Replaced gas valve

We will collect 5000 on Tuesday and the balance of 12902 will be paid by financing

Customer said that the 2 rooms in the front, upstairs rooms are hot. I adjusted the airflow for cooling and fan only. Also i set the damper to only close 80% to those rooms and recommended to run the fan on every time the customer is in those rooms

Customer reports the fan is not running but system has been on the whole time since repair. I found the thermostat to be on “fan on” mode. Switched to auto and gave cusotmer brief overview of thermostat controls.

Performed service on a 22 year old comfort maker system. Customer reports system blowing warm air. Customer reports past company’s said system was low. The outdoor system was not operational on call for cool. I found the breaker to be tripped. I verified the system to be ok on charge. The start amps are way above amps at 160. Run amps are very high as well. Indoor system was reported to have capacitor a replaced. It was replaced but with an incorrect size. The original capacitor was also found to be ok. Customer was briefed on the poor condition of the system. A maintenance program was setup today. Outdoor unit was washed.

Upon arrival, started ac tune up. Filter and condenser are extremely dirty. Replaced filter with customer supplied filter. Cleaned outdoor coil. Flushed out drain lines and cleaned out electrical. Client said kids room are always hot. Explored zoning options and ductwork replacement. Unit is operational upon departure.

Customer reported system not cooling as it should. Found indoor blower not turning on during cool call. Outdoor unit is working as it should however amperage is high. Relay that was recently replaced is chattering, this is a result of weak transformer and outdoor contactor. Refrigerant levels are low. Wife was briefed on the condition. She is contacting her home warranty to resolve this issue.

Tested furnace for operation, diagnosed defective gas valve

Performed AC maintenance. Checked temperature split at 20°. Checked filters and changed customer provided. Inspected ducting. Checked and tightened electrical components. Inspected green pan and condenser coil system has float switch for protection. System is cooling and operational plan departure. Installed outdoor surge protection on unit.

Installed txv and filter drier. System was pressure tested and cycled before end of appointment. Financed with service finance loan #3379316. Service finance was having issues and was not letting him sign documents, we tried several times. Following up later to see if it will send it through.

System totals out to $10,002 - Client is only liable for payment of $7,002 as Tech Clean California Rebate will cover remaining $3,000 balance.

Performed service on a 8 year old Goodman system. System is unresponsive at a cooling call. Low pressure switch is activated due to the system being close to flat on charge. Leak detection found a leak inside the coil on the outdoor unit. Scheduled a equipment specialist to go over options with the customers on Monday. System is not operational at end of appointment.

Performed service on a 2017 Trane condenser. Condenser is tripping off within seconds. Standing pressure is 30 and 298. System is restricted. Returning to install txv and filter drier. System is non operational at end of appointment.

System totals out to $13,767 - Client Darryl Nanni is only responsible for the payment of $10,767 as Tech Clean California Rebate will cover remaining $3,000 balance.

Arrived on site to diagnose no cooling 1989 unit. Client stated unit is not cooling as good as it used too. Called us out and she replaced filter but unit still did not cool as good. Called us out. Cycled unit and found condenser fan on and compressor was not. inspected all electrical compartment. Found secondary motor control for compressor to have 2 small one and jumped out to make the right size one. Put a good one in to test unit and get it to turn on and run. Was able to check pressure porque and found unit just about empty. Advised client unit hold r-22 and is not longer in production and price per pound is really high. Due to it being flat advised would recommend minimum to do a leak dye or sealant if client wishes to repairs so refrigerant is not lost in future. Advised unit over all is running very inefficient and causing client to have really high electricity bills in the summer when Ac is ran. Advised client now to due to the age, condition, r-22 and leak as well as repairs