Vista, CA

Tested system for proper operation. Checked air filter and drain lines. Measured indoor temperatures. Verified refrigerant charge. Tested outdoor electrical equipment and controls. Measured motor amp draws. Cleaned outdoor coil.

Tested cooling equipment and measured indoor temperatures. Cleaned outdoor coil. Checked motor amp draws and supply voltages. Measured capacitor. Changed 1” filter. Checked condensate drain. Cleaned outdoor electrical panel. Verified refrigerant pressures.

Package unit performance quarterly maintenance. Checked system operation and monitored temp splits. Measured supply high voltage and transformer low voltage. Measured compressor motor and fan motor amp draws. Replaced air filters. Measured run battery capacitance. Cleaned outdoor coil. Replaced blower motor belt.

Diagnosed outdoor condenser and replaced electrical component. Tested system operations and verified pressures. Measured temperature splits and checked the filter. Cleaned the outdoor condenser bottom and washed coils.

Performed diagnostic on system. System consists of a 2015 condenser and a 2004 furnace. Homeowner states that it’s working,but it does not cool the house down the way that it should. Has had other companies out and they have told her that the unit is too small. Performed thorough diagnostic, concerns are as follows: 1. System is not matched correctly 2. Indoor unit is a 5 ton, outdoor unit is a 4 ton 3. Original evap coil was kept and switched over from R-22 to R-410A 4. Downstairs supply registers were basically all closed 5. Static pressure is fairly high on return side. 6. System does not have enough return air 7. System is operating on a piston rather than a TXV 8.System is cooling but not at correct capacity for this size of a home Went over complete findings and recommendations with homeowner. Ultimately they would like to replace the condenser and coil to match with the furnace. Turning call over to Darren, who will be coming out on Friday June 5th to go over options with

NO CHARGE. upon arrival performed diagnostic. This was not a diagnostic, answered customer questions and concerns. Recommended replacing duct work to get a full design of home. System is operational.

NO CHARGE. upon arrival performed diagnostic. This was not a diagnostic, answered customer questions and concerns. Recommended replacing duct work to get a full design of home. System is operational.

NO CHARGE. upon arrival performed diagnostic. This was not a diagnostic, answered customer questions and concerns. Recommended replacing duct work to get a full design of home. System is operational.

NO CHARGE. upon arrival performed diagnostic. This was not a diagnostic, answered customer questions and concerns. Recommended replacing duct work to get a full design of home. System is operational.

Arrived on site to diagnose a (2) 2000 year old system. Upstairs was not cooling or operating. Downstairs is not heating. Spoke with clients they advised heating has not been working since winter. Thermostat upstairs is not working and client can’t get set temperature to go up or down. Inspected upstairs unit. System would not turn on. Checked out connection, voltage and main circuit board. Eliminated thermostat and jumped system and system turn on. Cycled in heating and cooling. Both temp split and rise are good on upstairs unit. Recommend replacing thermostat to get system operating. Inspected downstairs unit. Heating mode would produce hot air. Checked for voltage, connections, Continuity, all good. Sequence of operation will start up till it got to gas value and not flames is created. Checked gas pressure on supply line and gas vale on manifold gas pressure. Was getting gas pressure on supply but valve would not open up. Cycled a few time and showed a gas pressure spike for a co

Upon arrival performed maintenance. Opened up and washed outdoor condensing coils. Amperages on compressor & fan motor in range. Refrigerant levels are in range. Pressure subcooling and superheat in range. Secondary control good. Primary motor control in excellent condition. Condenser fan motor good. Coils were washed. System was reset tested and fully functional upon departure. Filter was given to home owner.

Upon arrival performed maintenance. Opened up and washed outdoor condensing coils. Amperages on compressor & fan motor in range. Refrigerant levels are in range. Pressure subcooling and superheat in range. Secondary control good. Primary motor control in excellent condition. Condenser fan motor good. Coils were washed. System was reset tested and fully functional upon departure. Filter was given to home owner.

Upon arrival performed maintenance. Opened up and washed outdoor condensing coils. Amperages on compressor & fan motor in range. Refrigerant levels are in range. Pressure subcooling and superheat in range. Secondary control good. Primary motor control in excellent condition. Condenser fan motor good. Coils were washed. System was reset tested and fully functional upon departure. Filter was given to home owner.

Upon arrival performed maintenance. Opened up and washed outdoor condensing coils. Amperages on compressor & fan motor in range. Refrigerant levels are in range. Pressure subcooling and superheat in range. Secondary control good. Primary motor control in excellent condition. Condenser fan motor good. Coils were washed. System was reset tested and fully functional upon departure. Filter was given to home owner.

Condenser maintenance and service

Inspected the home for possible air conditioning

Ac/furnace inspection

Inspection of the outdoor system

Foam spray for lineset cover

Quality control check. We need to return to install a screen on the linset cover

We are adding registers at part of promo but not adding Merv 16 filter. Includes new return and supply plenum. We will straighten supply trunk ducting off the plenum as best as we can

Spring maintenance

Performed diagnostic on 2000 Carrier. System is not kicking on, error code on thermostat. I cycled system for heat. System initiated heating cycle, but fan never kicked on and system shut off. After carefully troubleshooting system, I found circuit board to be bad as well as indoor blower motor. Both would have to be replaced for it to operate. Went over findings and recommendations. Homeowners are Leaning more towards replacing the system as oppose to repairing it. Repair cost was given to homeowners. Darren will be coming out tomorrow morning to go over replacement options. System is not operational upon departure.

Replace existing furnace with below listed equipment. Unblock downstairs return air duct and fix low wall return duct. Install 5” filter rack and new Honeywell thermostat. Replace and redesign all existing ducting with new R-8 Class 1 ducting. Permits and HERS testing included. Asbestos abatement included. After rebate total $9,691.00

Replacement of ducting, return seal and supply can install