Vista, CA

Upon arrival unit was operational started at the furnace checked amps they were in range, temp splits were in range elect was secured and tight , filters are changed regularly by homeowner. Moved to the outdoor unit checked system pressures, amps were in range secondary motor control was in range, washed unit from the inside out closed it up and presented my finding. Combo tune up.

Arrived on site to perform condensation cut and clear. Upon arrival client stated that he cleared P-trap under sink but secondary still draining on side of house. Proceeded to evaporator coil and found the primary drain line coming off of coil is blocked up at P-trap. Cut both sections and vacuumed out all debris. Primed drain line to confirm water is draining out. Advised client that if system continues to leak due to the high amounts of rust inside the PVC line it is possible that the primary drain pan is damaged resulting in water leaking out past the PVC lines. Upon departure system is operational And draining

Performed blower wheel cleaning & light maintenance dusted off all electricals. Mechanicals in great condition. New filter on. System looks amazing. Brand new again.

Performed blower wheel cleaning & light maintenance dusted off all electricals. Mechanicals in great condition. New filter on. System looks amazing. Brand new again.

Performed blower wheel cleaning & light maintenance dusted off all electricals. Mechanicals in great condition. New filter on. System looks amazing. Brand new again.

Performed blower wheel cleaning & light maintenance dusted off all electricals. Mechanicals in great condition. New filter on. System looks amazing. Brand new again.

Upon arrival performed diagnostic/ maintenance. Client has 5 inch filter, took out 1 inch washable filter. Circuit board and electricals good. Ducting is extremely undersized, system is a 3 ton system and only has about 800 cfm of ducting supplied. Advised doing all duct replacement will help system breath better. Indoor motor and inducer motor are running extremely high, not over max amps but starting to get there, have a lot of strain done to motor due to Insufficient amount of air flow moving through. Ducts have no seals at joints. System is operational.

Upon arrival performed diagnostic/ maintenance. Client has 5 inch filter, took out 1 inch washable filter. Circuit board and electricals good. Ducting is extremely undersized, system is a 3 ton system and only has about 800 cfm of ducting supplied. Advised doing all duct replacement will help system breath better. Indoor motor and inducer motor are running extremely high, not over max amps but starting to get there, have a lot of strain done to motor due to Insufficient amount of air flow moving through. Ducts have no seals at joints. System is operational.

Upon arrival performed diagnostic/ maintenance. Client has 5 inch filter, took out 1 inch washable filter. Circuit board and electricals good. Ducting is extremely undersized, system is a 3 ton system and only has about 800 cfm of ducting supplied. Advised doing all duct replacement will help system breath better. Indoor motor and inducer motor are running extremely high, not over max amps but starting to get there, have a lot of strain done to motor due to Insufficient amount of air flow moving through. Ducts have no seals at joints. System is operational.

Upon arrival performed diagnostic/ maintenance. Client has 5 inch filter, took out 1 inch washable filter. Circuit board and electricals good. Ducting is extremely undersized, system is a 3 ton system and only has about 800 cfm of ducting supplied. Advised doing all duct replacement will help system breath better. Indoor motor and inducer motor are running extremely high, not over max amps but starting to get there, have a lot of strain done to motor due to Insufficient amount of air flow moving through. Ducts have no seals at joints. System is operational.

Arrived on site to perform mini split condensation diagnostic upon arrival Stacy is not home although housekeeper let me in. Called Stacy over phone and she stated the mini split has been leaking consistently and pours profusely from the louvers at the head unit. Verify that filters were clean scroll wheel is very dirty, evaporator coil is OK. Proceeded to outdoor condensing unit and found primary hose running off of head unit in living room. No water flow was present. After about five minutes head unit began pouring water profusely. Performed blowout on primary hose and clear restriction. Verified the mini split is draining properly. At this time client would like to hold off on maintenance plan and talk it over with her husband but will just go through with mandatory repair at this time. Client will give us a call when she talks to her husband upon departure unit is draining properly

During my twenty point heating inspection, I started with the thermostat. Giving a call for heating, and going to furnace to start maintenance. Temp rise of 35-65 needed, I got a temp rise of 38. House heats up to designated temperature. I checked out blower motor of any dirt or debris. It’s clean, only being a two year old system. Replaced air filter for new air filter. Owner had extra one, so just used his. Hot surface igniter not cracked or having white spots. Flame sensor still working good, no need to be cleaned. Ducting done correctly, and all runs intact. Inducer motor is working efficiently. House heats good and ready for winter.

Installed LP kit for new furnace. Tested inWc for both heat stages.

Upon arrival client said there was a duct that needed a new cut in. Advised client on a couple different ways of doing the work and even advised client on ways to do it himself. Client decided to try it himself and then call if he needs assistance.

Collected $1000 deposit. Balance due will be 18902

Upon arrival u it was operational. Checked system amps, blower wheel was dirty and there wasn’t a condensation line.filter was fairly clean temp rise was slightly high. Ducts were falling off the supply plenum and was rated for R-2 and was being held on with duct tape and electrical tape .Charles expressed some interest in a system and would like to be contacted about a heat pump specifically. Upon departure u nit was operational but not as efficient as it could be.

When I arrived at house, I was told thermostat was blank. They couldn't set on cooling mode or heating. I noticed there wasn't any power to unit. I quickly opened up the box for direct power. I noticed one of my 120v legs were burnt and made no connection to system. I cut off old wiring and re wired into system. Thermostat on, furnace on and condenser unit all working great. Charging for diagnostic.

Upon arrival heater was operational. Checked system amps they were in range , temp split was in range. Made sure safety switches were operational and functioning how they should.tighten electrical and made sure burners were functioning normal. Filter was dirty. And homeowner provided another one. Upon departure unit was operational and heating.

Upon arrival unit was operational and cooling. Started at the indoor unit checked amps they were in range, blew condensation lines out, filter was dirty and blower wheel was clean, temp split was in range. Moved to the outdoor unit checked amps they were in range washed unit from the inside out and closed it up upon departure unit was cooling and operational.

Upon arrival performed diagnostic. Found water dripping through the coil straight down. Found water spots on circuit board that have already hit electrical, can be worse. Blower motor leaking oil. Heat exchanger has very gnarley heat spots on joints, that is never any good, can be producing CO. Coil does not have any safety switches. Client says there bill is over 1thoudNd Monthly. Filter extremely dirty and wet. System is operational but leaking tons of water, could not fill verify if drain was cracked. Darren to come out today for options .

Upon arrival performed diagnostic. Found water dripping through the coil straight down. Found water spots on circuit board that have already hit electrical, can be worse. Blower motor leaking oil. Heat exchanger has very gnarley heat spots on joints, that is never any good, can be producing CO. Coil does not have any safety switches. Client says there bill is over 1thoudNd Monthly. Filter extremely dirty and wet. System is operational but leaking tons of water, could not fill verify if drain was cracked. Darren to come out today for options .

Upon arrival performed diagnostic. Found water dripping through the coil straight down. Found water spots on circuit board that have already hit electrical, can be worse. Blower motor leaking oil. Heat exchanger has very gnarley heat spots on joints, that is never any good, can be producing CO. Coil does not have any safety switches. Client says there bill is over 1thoudNd Monthly. Filter extremely dirty and wet. System is operational but leaking tons of water, could not fill verify if drain was cracked. Darren to come out today for options .

Upon arrival performed diagnostic. Found water dripping through the coil straight down. Found water spots on circuit board that have already hit electrical, can be worse. Blower motor leaking oil. Heat exchanger has very gnarley heat spots on joints, that is never any good, can be producing CO. Coil does not have any safety switches. Client says there bill is over 1thoudNd Monthly. Filter extremely dirty and wet. System is operational but leaking tons of water, could not fill verify if drain was cracked. Darren to come out today for options .

Performed FAU maintenance on 17 year old Armstrong air unit. Checked static pressure and found it to be high. This can be remedied a bit by replacing the filters. Jeff said he would replace them on his own. Temp split was within limits. Inspected blower compartment and found blower wheel to be clean and it sounds balanced. Noticed the gas line does not have a sediment trap. Cleaned flame sensor. Checked igniter ohms. Tested pressure switch. Upon departure system is operational.

Performed AC tuneup on two half year old Lennox units. Temp split is normal on both units. Inspected blower compartments, blowers sound balanced. Cleaned condensate drain P traps. Inspected electrical components and connections. Cleaned upstairs outdoor unit, was unable to clean downstairs unit because there was no water access. Upon departure both systems are operational.