Riverside, CA

Arrived on site to diagnose a thermostat issues on a goodman 2016 system. Furnace located in upstairs hall way. Client they were having issues connecting to WiFi on there thermostat and app on phone. It stated system would not turn on in heating mode. Found Honeywell T6 pro thermostat had a error code and would not let system turn on. Cleared thermostat as I pulled off 5e wall and reset and system was now operational and heating good. Now tired to set up WiFi on thermostat to be able to connect to phone. Over all found thermostat was not going to connect due to Honeywell connection. Client were interested in replacing with a WiFi nest thermostat. Installed and cycled heating and cooling to ensure system and thermostat is operational. Client cycled off system with phone to ensure WiFi is working on this thermostat. System is no operational upon departure. Would recommend adding surge protectors on high efficient systems to prevent system from gettin damaged from electrical surges and p

Arrived on site to perform fall tune up on a 2019 Lennox system. Furnace located in attic. Found filter dirty and long over due replacement. Recommend replacing to reduce dirt entering system. Found ducting to be metal ducts with layer of insulation over it which is falling apart in some areas. Blower wheel and assembly is accumulating dirty and debris. Motor is good and amp drawls are in range. Inducer is good and amp drawls are good. All safety switches are operational. Temperature rise is good and in range. Over recommendation adding a purifying system to better air quality over all in home due to client allergies. Evaporator coil is good. Heat exchanger is good at this time. Drain line have light dust due to the amount Of dirt that has entered system. Could risk clogging up drain lines if keeps accumulating over time. No protection on either unit. Found voltage at 122v. Recommend adding surge protectors to prevent system from getting damaged from electrical surges and power outage

Arrived on site to perform AC maintenance on 3 year old Lennox system. Had homeowner cycle system for cooling. Checked outdoor unit electrical and system components. Refrigerant pressures are within range and system is producing proper temperature split. Primary motor control is in good condition. Secondary motor control is within range. Amp draws for condenser fan motor and compressor are within range. Pulled off all panels as well as condenser fan motor and thoroughly washed out condenser coil inside and out. Compressor start amps are only slightly high, and system is not surge protected. Cycled system, system is fully operational upon departure.

Performed maintenance on 6 year old Lennox unit. Cycled system for heat. Verified proper heating sequence of operations. Checked indoor unit electrical and heating components. Cleaned blower assembly and heating compartment. Cleaned flame sensor. Checked and verified proper heating operations and components are working accordingly. Blower wheel and evap coil are clean. Blower motor looks healthy. Whole home air purification system is working properly. Merv filter is dirty, went ahead and replaced with approval. Ductwork is all properly sealed and in good condition. Called homeowner cheryl and renewed membership as well, Cheryl approved to run card that’s on file. Cycled system, system is fully operational upon departure.

Performed Fau maintenance on 6 year old Rheem system. Cycled system for heating. Verified proper heating sequence of operations. Temperature rise across heat exchanger is high but within range. Merv 11 filter is extremely clogged which can be why unit is operating a little hotter than usual. Checked and ensured all registers were open. Ran system through 20 point inspection checklist. Homeowner had no filters on hand and will be ordering and replacing himself. Went through findings and recommendations. Cycled system, system is operational upon departure.

Arrived on site to perform FAU maintenance on 16 year old Lennox furnace. Cycled system for heating. Verified proper heating sequence of operations. Temperature rise across heat exchanger is within range. Static pressure on unit is high, unit does not have any supply plenum and is operating on only 1 return. Indoor blower wheel is dirty. Indoor blower motor amp draws are in range, and secondary motor control tests good. Inducer motor amp draws are getting closer to allowed maximum range. Wiped down blower and heating compartment. Tested and verified heating components are working accordingly. Pulled off evap coil compartment to access and inspect heat exchanger. Heat exchanger has mild hot spots throughout chambers. Evaporator coil is dirty. System gas line does not have a sediment trap Before going Into unit. Unit also does not have any condensation safety switches for safety against condensation leaks in the AC mode. Homeowner just replaced his filter. Went over all findings and reco

Upon arrival performed furnace tune up. Cycled heating several times to make sure system is operating at 100%. proceeded to take amperage readings throughout motor and inducer. Cleaned and sanitized furnace cabinet. Home insulation is very low inside of attic. Ducting is in very good condition. System is an American standard 5 years old. Temp rise splits in range. Gas valve is in working operations. Burners are in good condition. Circuit board and electrical connections good. Safety switch in working order. 20x30x1 filter was replaced with maintenance. Signed client up for esa membership, took care of fall tune up for today, did not touch ac. System has been reset and is in working operations on departure of technician.

Upon arrival performed furnace tune up. Cycled heating several times to make sure system is operating at 100%. proceeded to take amperage readings throughout motor and inducer. Cleaned and sanitized furnace cabinet. Home insulation is very low inside of attic. Ducting is in very good condition. System is an American standard 5 years old. Temp rise splits in range. Gas valve is in working operations. Burners are in good condition. Circuit board and electrical connections good. Safety switch in working order. 20x30x1 filter was replaced with maintenance. Signed client up for esa membership, took care of fall tune up for today, did not touch ac. System has been reset and is in working operations on departure of technician.

Upon arrival performed furnace tune up. Cycled heating several times to make sure system is operating at 100%. proceeded to take amperage readings throughout motor and inducer. Cleaned and sanitized furnace cabinet. Home insulation is very low inside of attic. Ducting is in very good condition. System is an American standard 5 years old. Temp rise splits in range. Gas valve is in working operations. Burners are in good condition. Circuit board and electrical connections good. Safety switch in working order. 20x30x1 filter was replaced with maintenance. Signed client up for esa membership, took care of fall tune up for today, did not touch ac. System has been reset and is in working operations on departure of technician.

Upon arrival performed furnace tune up. Cycled heating several times to make sure system is operating at 100%. proceeded to take amperage readings throughout motor and inducer. Cleaned and sanitized furnace cabinet. Home insulation is very low inside of attic. Ducting is in very good condition. System is an American standard 5 years old. Temp rise splits in range. Gas valve is in working operations. Burners are in good condition. Circuit board and electrical connections good. Safety switch in working order. 20x30x1 filter was replaced with maintenance. Signed client up for esa membership, took care of fall tune up for today, did not touch ac. System has been reset and is in working operations on departure of technician.

Post job walk

Total after all the rebates would be 13283.

Performed diagnostic on 30 year old Rheem system. System is not cooling. Per homeowner, he had home warranty company come out and diagnose system, he has been waiting on them to come and do repairs for a couple weeks now and wants a second opinion on it. Cycled system for cooling. System kicks on normally, is only blowing warm air. Checked outdoor unit electrical and system components. System is recieving proper high voltage power as well as low voltage command. Compressor is kicking on, but is not compressing refrigerant. Refrigerant pressures are equalized with compressor off or with it on, only changes but a couple psi in pressure. Secondary motor control is in range for compressor, and it is recieving the proper voltage. System has a bad compressor. Went over findings and recommendations with homeowner. Discussed repair vs . Replacement and they are leaning towards replacing the system. Homeowners have to discuss it together as they are unsure of home warranty will replace the syst

Collected $1000 deposit by check. Balance due $10641 on the day of installation

Upon arrival performed diagnostic. Found system to be non operational. Condenser fan motor leaking excessive amounts of oil. Coils are complete covered without any breathing room. Indoor coil is completely covered in dirt and debree. Very low refrigerant. Secondary motor controls low. Return insulation falling into duct, very poor airflow. System has not ever been maintenanced. Darren came out as customers request to give replacement options. System is non operational.

Upon arrival performed diagnostic. Found system to be non operational. Condenser fan motor leaking excessive amounts of oil. Coils are complete covered without any breathing room. Indoor coil is completely covered in dirt and debree. Very low refrigerant. Secondary motor controls low. Return insulation falling into duct, very poor airflow. System has not ever been maintenanced. Darren came out as customers request to give replacement options. System is non operational.

Upon arrival performed diagnostic. Found system to be non operational. Condenser fan motor leaking excessive amounts of oil. Coils are complete covered without any breathing room. Indoor coil is completely covered in dirt and debree. Very low refrigerant. Secondary motor controls low. Return insulation falling into duct, very poor airflow. System has not ever been maintenanced. Darren came out as customers request to give replacement options. System is non operational.

Upon arrival performed diagnostic. Found system to be non operational. Condenser fan motor leaking excessive amounts of oil. Coils are complete covered without any breathing room. Indoor coil is completely covered in dirt and debree. Very low refrigerant. Secondary motor controls low. Return insulation falling into duct, very poor airflow. System has not ever been maintenanced. Darren came out as customers request to give replacement options. System is non operational.

Performed diagnostic on 2 2008 York systems. Homeowner states that she is having some issues with both of her units. She is good friends with Jay and will be signing up on ESA maintenance program today. Homeowner states that her system for the bedrooms feels like sometimes air is not coming out as cold as it used to. She also stated that her kitchen system is working periodically as well. Cycled both units for cooling. Indoor units both kicked on and are blowing air. Bedroom system kicked on normally. Refrigerant pressures are within range and system is producing proper temperature split. Checked all electrical and system components. Secondary motor control is within range as well as compressor hard start kit. Amp draws are within range for both compressor and condenser fan motor. Primary motor control is completely full of ants inside the contact points. Kitchen system compressor is not kicking on. Checked unit electrical and components. Primary motor control was also full of ants and

Performance tuneup and service. Cleaned condenser, cleared condensate drain, measured voltages and amp draws, checked battery cap. Checked filter, made sure living room duct was not disconnected. Verified charge.

Performed AC diagnostic on 20-year-old train condensing unit. Upon my diagnostic I found out the house was 86° upon arrival found that indoor blower was blowing air although hot air I then proceeded outside to find that the condensing unit was not on. Further investigation showed that the capacitor on the hermetic side was blown and this is why the compressor was not moving refrigerant up and down The System. Replaced run capacitor and system is up and operational although it was slightly low on R22 refrigerant charge. Added in approximately 1 pound of refrigerant in house had exactly a 20° split in home. Also cleaned off condensing coil’s outside to improve subcooling. Upon departure system is fully operational and cooling but may experience problems down the road the systems are only designed for 10 to 15 years after that failure is possible.

Post job walk

Checked new furnace for faults

Performed inspection of both system for faults and performance. Replaced defective part on the main system and the filter (provided by customer). Mini split in the guest house was tested and is working properly. The insulation is ch keeps these systems running consistently in the hottest days of the year.

Replace existing furnace with below listed equipment. Uninstall evaporator coil and seal supply plenum and re-install coil properly. Previous contractor didn’t seal it very well. Re-insulated closet plenum. Seal all supply cans and install new high flow register set. Re-insulate 2 attic duct runs and add secondary safety switch. $5,400 due upon completion.