Riverside, CA

Upon arrival performed diagnostic. Found system to be icing up. Found indoor coil to be extremely covered and no air flow. Added 2 lbs of r22 and leak dye. Replaced secondary motor control and added booster kit to keep amperages low, compressor is kicking on hard. Cleaned entire system out, system was covered in dirt. Outdoor coils are completely damaged and no air flow, client is fully aware of how system is, does not wanna replace system wants to get system up and going today? Went over findings with client, spoke to husband and wife and decided to do repair options. Signed client up with membership. System is operational, advised client system is running, just advised there is a some damaged parts.

Upon arrival performed diagnostic. Found system to be icing up. Found indoor coil to be extremely covered and no air flow. Added 2 lbs of r22 and leak dye. Replaced secondary motor control and added booster kit to keep amperages low, compressor is kicking on hard. Cleaned entire system out, system was covered in dirt. Outdoor coils are completely damaged and no air flow, client is fully aware of how system is, does not wanna replace system wants to get system up and going today? Went over findings with client, spoke to husband and wife and decided to do repair options. Signed client up with membership. System is operational, advised client system is running, just advised there is a some damaged parts.

Upon arrival performed diagnostic. Found system to be icing up. Found indoor coil to be extremely covered and no air flow. Added 2 lbs of r22 and leak dye. Replaced secondary motor control and added booster kit to keep amperages low, compressor is kicking on hard. Cleaned entire system out, system was covered in dirt. Outdoor coils are completely damaged and no air flow, client is fully aware of how system is, does not wanna replace system wants to get system up and going today? Went over findings with client, spoke to husband and wife and decided to do repair options. Signed client up with membership. System is operational, advised client system is running, just advised there is a some damaged parts.

Performed AC maintenance on a Lennox XC25. Systems cooling temperature split is 21 degrees. Indoor blower is amping ok. Condensate lines are clear and functioning well. Outdoor coils were heavily dirty but cleaned up great with a chemical wash. Compressor and fan amps are in range at this time. Refrigerant levels are ok. Customer had surge protection installed today for the furnace and condenser. System was cycled before leaving.

Performed diagnostic on 3 year old unit. Homeowner states System isn’t cooling. Outdoor unit does not turn on. Cycled system for cooling. Outdoor unit is not turning over. Checked system electrical. No line voltage coming to unit. Found breaker in the off position. Turned breaker on and system came on and started cooling. Refrigerant pressures are ok, weather not fully ideal for refrigerant check but system is cooling. Signed homeowner up on monthly maintenance program. System is operational upon departure.

Performed AC maintenance on 2005 Lennox Condenser. I noticed a few things on this maintenance as well and brought them up to Charles. 1. Duel secondary motor control has become weak on hermetic side terminal reading at 55 µF this should be at 60 2. High voltage distributor showed signs of pitting on contact points due to amperage pull overtime 3. Condenser fan motor had significant oil leak is coming from bearing 4. Refrigerant pressures were in range although did contain a phased out refrigerant called R22 5. Compressor amperage is Exceeding manufacture specifications pulling at an actual of 28 A when it is really only for 26 please put the system in the danger zone of locking out from overheating. 6. Disconnect also was not equipped with surge protection or fuses Discuss full condition of system with Charles and he has recently replaced parts within the last couple years and will do it again once other components begin to go out. Advised him did the amperage is wearing the red zone

Tech arrived on site and did ac tune up. All system operations were good. Temp split and charge were good. Amps were good. Airflow is good. See checklist for details. Installed surge protector on the furnace to protect the IAQ items.

Performed AC diagnostic on 2004 Rheem condenser. Upon my diagnostic Joe stated that he had recently swapped out the condenser fan motor and capacitor but this didn’t fix it. I started off at the outdoor unit and found that the indoor blower motor was on and working properly but the outdoor unit was not present with 240 V. I then found out the 30 amp fuse on the disconnect was popped. Inserted a new fuse in system fired up with extremely high amps. Found that condenser coil was completely covered in in blanket of dust and hair along with extreme coil rot from the dogs urinating on it for the past years. Before cleaning the coil the compressor was pulling 18 amps and considering that the manufacture rating is set at 16 amps. Cleaned off condenser coil And amps went down slightly. Due to the major coil damage from the rot The system is not able to efficiently reject the heat from the coils which will ultimately lead to the fuses popping again once it gets dirty or really hot out. This i

Performed AC maintenance on a Lennox condenser. Cooling temperature split is 22 degreees. Condensate lines are clear. Static pressure is high. Indoor motor is amping high, leaking oil and not spinning freely. Outdoor coils were chemically cleaned. Compressor and fan amps are amping ok at this time. Refrigerant levels are ok. System was cycled before leaving.

Performed AC diagnostic on 2008 Comfortmaker Condenser. Tenant scheduled appointment and stated that system was not cooling On the right side of the home. He mentioned that there is a lot of rats and snakes in the area and could of potential chewed up the wiring. Started system up thermostat into cooling and outdoor condenser unit did not turn on. Found that low-voltage wiring was completely disconnected from rats crawling up the Flashing of the line set. Connected low-voltage wires back together and system energized. 5 ton condenser- 1. duel secondary motor control was becoming weak on hermetic side. 2. System Contained R22 refrigerant Which was completely face the January 1, 2020. 3. Measured refrigerant pressures found that the system was low. There is a leak somewhere within the system potentially. 4. High voltage distributor was about 85% pitted and burnt on contact points. Discussed full condition of system with tenet and he understands that with the system being low in the summ

Arrived on site to perform combo tune up on a 2018 AcPro system. Condenser located in back yard. Furnace and Evaporator coil located in attic. Client stated no issues as he just wanted filter replaced. Washed condenser coil inside and out as unit was clogged up. Inspected electrical compartment. Primary was good. Fan motor was good and in range on amps. Compressor start ups are good. Run amp are in range and cooling home good at 19 degrees. Inspected indoor unit. Client still uses 1 inch filter and advised client that he no longer needed standard filter any more as he has a 5 in filter but has not been replaced since last year. Filter has been letting dirt in unit. Advised we need to keep dirt form unit. Motor is good. Blower assembly collecting dust over dirt that has entered. Evaporator coil is good. Drain lines are clear at this time but Advised if dirt keeps entering system it could clog up drain lines over time. Recommend adding a whole house cleaning and purifying system to help

Arrived on site to perform spring tune up on a 2020 lennox system. Condenser located back yard. Furnace and Evaporator coil located in attic. Client stated no issues. Client has 2 systems but we only replaced one and came to perform combo tune up on upstairs unit only. Washed condenser inside and out. Unit was a bit dirty from outdoor debris. Primary and secondary motor controls are both good and in range. Fan motor is good and in range of amps. Compressor start up are good. Run amps are good as well. System pressure are good and cooling hole at 19 degrees. No protection on unit. Inspected indoor unit. Filter was really dirty as client also has about 4 cats. Replaced filter. Blower assembly is good has slight dust. Evaporator coil good. Inducer motors is good. Drain lines due have debri. Advised client to stay on top o filter and replace every 6 months as they do run fan all day cycling air in home. Is debris enters system it could clog up drain lines over time and client is aware. No

Arrived on site to perform spring tune on a 2018 acpro system. Condenser located in back of home. Furnace and Evaporator coil located in garage. Tenant stated no issues. Cycled unit. Last tech did not put door on properly and is good now.found system dose not have a reck for filter so nothing is holding filter secured and is getting lifted and allowing dirt to enter system. Reason why blower assembly is really dirty. Found filter dirty. Recommend replacing more often. Blower assembly is really dirty from dirt that has entered system in past. Dirt is creating weight on motor. Motor has oil leaking from over working. Would rexomAs it has lasted of oil and dirt building up. Motor could fail from conditions and over worked. Secondary control is good. Evaporator has light debris but due to the amount of dirt that could be entering system. Washed condenser inside and out. Fan motor is good and good amps. Primary and secondary are both good and in range. Start ups on compressor are high but

arrived on site to perform spring tune up on 2 units. 2018 Goodman unit. Client stated no issues. Both condenser located on side on home. Washed mini split inside and out. Would recommend adding a surge protector on unit to protect it. Washed condenser inside and out. Primary and secondary motor controls are good. Start ups are high and would recommend adding a compressor booster kit to help start up low and run easier. Run amps are good and cooling home at 22 degrees. Filter was replaced as client had her own and was replaced. Blower assembly is dirty from pst years. Would recommend replacing more often. Motor is good and amp draws are in range. Evaporator coil has light debris. Drain lines good no protection on unit. Recommend adding some. Went over all findings with client. Client is aware of how system is running and it’s condition. Client did declined recommended work at this. Both systems are operational and cooling upon departure.

Arrived on site to perform combo tune up on a 2020 lennox unit. Client was not home and had brother out visiting and was watching over home while owner was out for spring break. Brother stated no issues and good. Washed condenser unit inside and out. Unit was extremely dirty and clogged up restricting air flow. Cleaned coil good clear. Recommend signing up on maintenance plan to be coming out yearly and was unit out clean. Primary and secondary motor controls are good and in range. Checked amp draws on compressor and fan motor and are both good. System is cooling home good at 22 degrees. No protection equipped on unit. Inspected indoor unit. Found filter extremely dirty and clogged. Recommend replacing filter more often. Blower assembly is good. Motor is good and amp draws are good. Evaporator coil is good. Drain lines are clear and good very slight dust. All safety switches are operational. Temperature rise and temperature split is good. No protection on units and recommend adding sur

Performed furnace maintenance on 2 2008 York furnaces. Cycled furnaces for heat. Verified proper heating sequence of operations. Temperature rise across heat exchangers is within range. Cleaned furnaces exterior as well as blower assembly and heating compartments. Ran systems through 20 point inspection checklist. Went over findings and recommendations with homeowner. Homeowner wants to hold off on any repairs as she does want to replace the system soon. Asked if we work with Costco, advised that we do not work with Costco but we can price Match accordingly. Left replacement filters. Cycled system, system is operational upon departure.

Technician arrived on site to perform maintenance on 5 ton split system. Today’s visit is on furnace. Checked the following: -hot surface igniter ohms -flame sensor -temp split -inducer amps -blower amps -blower wheel -filter condition -gas piping -vent piping -safety switches Overall unit is in good health. Filter was bad but changed it out with a customer supplied one. Adjusted fan settings to circulate instead of “on”

Upon arrival performed install on surge protectors and replaced dirty merv 16 filter

Upon arrival performed install on surge protectors and replaced dirty merv 16 filter

Upon arrival performed install on surge protectors and replaced dirty merv 16 filter

Upon arrival performed install on surge protectors and replaced dirty merv 16 filter

Upon arrival performed maintenance on lennox system. Indoor motor and wheel good. Filter was completely dirty and ready for replacement, client wants to move forwards with surge protection to system. Coming back out Monday, client has no time has to be in Dr meetings. Circuit board and electrical connections good. Temp rise splits good. Ducting system is in good condition. Purged through drains. Amperages throughout system good. System was reset tested and fully functional upon departure. - dirty filter - installing surge protector - good amperages.

Upon arrival performed maintenance on lennox system. Indoor motor and wheel good. Filter was completely dirty and ready for replacement, client wants to move forwards with surge protection to system. Coming back out Monday, client has no time has to be in Dr meetings. Circuit board and electrical connections good. Temp rise splits good. Ducting system is in good condition. Purged through drains. Amperages throughout system good. System was reset tested and fully functional upon departure. - dirty filter - installing surge protector - good amperages.

Upon arrival performed maintenance on lennox system. Indoor motor and wheel good. Filter was completely dirty and ready for replacement, client wants to move forwards with surge protection to system. Coming back out Monday, client has no time has to be in Dr meetings. Circuit board and electrical connections good. Temp rise splits good. Ducting system is in good condition. Purged through drains. Amperages throughout system good. System was reset tested and fully functional upon departure. - dirty filter - installing surge protector - good amperages.

Upon arrival performed maintenance on lennox system. Indoor motor and wheel good. Filter was completely dirty and ready for replacement, client wants to move forwards with surge protection to system. Coming back out Monday, client has no time has to be in Dr meetings. Circuit board and electrical connections good. Temp rise splits good. Ducting system is in good condition. Purged through drains. Amperages throughout system good. System was reset tested and fully functional upon departure. - dirty filter - installing surge protector - good amperages.