Moreno Valley, CA

Club had questions about financing options to see if they should finance or pay for it.

When I arrived at house, I was told house wasn’t cooling anymore. I started at condenser and opened up cabinet of all electrical components. I had no power to condenser unit, so I went to breaker panel. Breaker panel had breaker inside In tripped position. I flipped breaker back on and went to do a amp draw. Hooked up my amp probe and system was working at 29 amps. Exceeding max amp draw of 27 amps. It’ll keep tripping breaker when compressor gets over worked. I showed issue to owner and he is aware of his compressor. Owner will reach out if he wants to continue with replacement. For today, I’m charging for diagnostic only.

Arrived on site to perform spring tune up on a 2 year old unit. Client stated no issues. Cycled cooling and is operational. Washed condenser coil inside and out. Checked electrical compartment and components. Primary stater is good. Secondary motor control is good and in range. Fan motor is good. Checked start up and run amps and both are good and in range. Checked pressure and pressure are good and cooling home. Filter was dirty and client stated they would order and replace themselves. Did recommend doing surge protectors to protect systems from electrical surges and power outages that can damage or even short out systems and components. Spoke to wife about how unit is running and she is aware and did hold off for husband to read repairs to see if they want to move forward. Cycled unit and u it is operational upon departure.

Arrived on site to perform diagnostic on 4 year old unit. States that unit is not working or reaching setpoint inside the house. Also noticed that pipe outside has been freezing over. Target setpoint in the house is 64 degrees. Advised that unit is realistically not designed to reach that temperature. Also, it is unclear if thermostat is reading the correct temperature. System still has all original Ducting, and unit is in the garage leaving little room for return air. Found that filter had not been changed since the day the unit was installed, which was causing a airflow and refrigeration restriction. This would cause the unit to run inefficiently all day and eventually ice up. Refrigerant pressures and all electrical components are within range. Went over findings and recommendations.

Upon arrival started cleaning ac. Checked and replaced filter as it was restricted. Cleaned condenser coil. Checked electrical. Unit is older and runs on obsolete refrigerant. Unit is working harder than normal. Pressures are okay and so is the temp split. Unit is operational upon departure.

Replaced the small strapping in attic with large strap. Added a strap for the flue pipe. Straightened ducts to remove harsh turns. Added a bolt to the pad for the outdoor system.

Power issue with the thermostats -Technician set the thermostats up so they are hardwired and do not require batteries -However on one of the systems, the common was not wired together on the wire splice -I put the right wires together so the thermostat has constant voltage as long as the package unit is energized, so no batteries are required any more

Collected $1000 deposit. Balance due upon completion

Arrived on site to diagnose a no working unit. Spoke to client upon arrival and he stated he was out of state and his son was home and a few days back they got a power outage and since the. Unit stopped working. Went to look at units and found he had opened up condenser completely from the electrical compartment to the condenser top with fan off. He stated he was trying to see if there was a test button but couldn’t fine anything and called us out. Tried to cycled unit and nothing happened. Advised had to put unit back together to try and trim on. Put it back and inspected compartment. Found start completely black from use and operational from age. Secondary motor control is out of range on compressor side. Fan motor has been leaking oil was unable to run unit. Found no power was going to condenser. Traced back power and found high voltage fuse to both be bad. Put ones ones in to try and turn unit on and cycled and unit created a big sparked and tripped break switches now. Started to

Arrived on site to diagnose a no cooling 2005 unit. Cloy stated she js 2 and only looking at upstairs. Client lived in home for 11 years. She stated upstairs used too cool now it’s not cooling at all. She stated she had issues in past and other companies just came and replaced parts and is happened again. Cycled unit and both was operational inside and out side. Inspected electrical compartment found it to be replaced in past as stater is burnt up. Secondary motor control is good and has added a compressor booster kit. Fan motor leaking oil. Compressor is on borrowed time as it’s pullin 14 amps out of 17. Unit on borrowed time. Checked pressure found unit to hold r-22. Found unit just about empty. Unit barley anything in unit as it has leaked out and why unit is not cooling. Did visual and couldn’t not find any visible leak. Advised. There is a couple different options to find a leak. Advised client of findings and went over all areas of concerns. Client is aware a leak present b

Arrived on site to perform maintenance on 8 year old unit. We recently replaced all ductwork. Cycled system for cooling. Checked indoor unit electrical and system components. Filter was extremely dirty. Homeowner was unaware there was a filter in the system to be replaced. There was an extra one went ahead and replaced it, as well as showed homeowner how to replace. No safety switch on condensation line. Checked outdoor unit electrical and system components. Amp draws are within range. Gauged up to system to verify proper refrigerant pressures. Primary motor control in good condition, secondary motor control is in range. Pulled condenser top and thoroughly washed out condenser coil inside and out as it was also extremely dirty. Went over findings and recommendations. Cycled system, system is operational upon departure.

Added refrigerant got system cooling with a 20 degree temp split, added leak dye to system. Advised client 2-3 months for leak dye to run through system. If system starts cooling less by that time please give us a call. System is operational

Added refrigerant got system cooling with a 20 degree temp split, added leak dye to system. Advised client 2-3 months for leak dye to run through system. If system starts cooling less by that time please give us a call. System is operational

Added refrigerant got system cooling with a 20 degree temp split, added leak dye to system. Advised client 2-3 months for leak dye to run through system. If system starts cooling less by that time please give us a call. System is operational

Added refrigerant got system cooling with a 20 degree temp split, added leak dye to system. Advised client 2-3 months for leak dye to run through system. If system starts cooling less by that time please give us a call. System is operational

Arrived on site to perform a leak inspection ona. 9 year old unit. Client stated unit is still cooling. Checked pressure and unit a a bit low. Subcool was down to 3 and was left at 8 as u it was is called for. Inspected condenser and opened up evaporator coil. Found some dye on the I for coil tape but no leak in side the coil. Inspected all connections with bubble spray and inspected full unit with leak detector. Found leak detector going off on the high pressure switch and keeps running for a leak. Advised client and showed her the findings. Over found the switch to be leaking minimum would have to replace high pressure switch and keep an eye on the pressure after repair to ensure there is no other micro leak present. Advised due to age and repairs needed and other issues that can occur advised to consider just AC replacement to guarantee leak is fixed and can provide a 10 year warranty instead on the 1 year warranty on the repair made. Went over all findings with client and wife and

Client stated both package units are not operational -Technician found contactor chattering and not making a solid connection when energized, causing the compressor and fan motor to not stay consistent energized -Contactor was replaced -The nest thermostat was not working properly with that unit, I bypassed the thermostat with jumpers to see if it would kick on, and it did -That nest thermostat was replaced with a Sensi WiFi thermostat -The other unit was not operational because there was no thermostat -Another Sensi WiFi thermostat was installed -Both units are now operational and cooling the residence properly -Technician helped client register both thermostats to his phone so he can control them from wherever he is, both thermostats are locked in at 75°

Upon arrival performed diag. Client had we care install system. Found system to be low on charge. Gonna add leak dye & charge system up with a few pounds to get system going. Client wants system fixed, understands the process of finding the leak. Will be out Thursday.

Upon arrival performed diag. Client had we care install system. Found system to be low on charge. Gonna add leak dye & charge system up with a few pounds to get system going. Client wants system fixed, understands the process of finding the leak. Will be out Thursday.

Upon arrival performed diag. Client had we care install system. Found system to be low on charge. Gonna add leak dye & charge system up with a few pounds to get system going. Client wants system fixed, understands the process of finding the leak. Will be out Thursday.

Upon arrival performed diag. Client had we care install system. Found system to be low on charge. Gonna add leak dye & charge system up with a few pounds to get system going. Client wants system fixed, understands the process of finding the leak. Will be out Thursday.

Arrived on site to perform diagnostic on a 2005 airflow unit. Condenser in back yard and furnace located in garage. Client stated unit just stopped cooling and only got air is coming out. She has tried to get unit to cool but is not. Cycled cooling and found compressor not on. Che led electrical. Found secondary motor control completely bad. Primary starter is listed as well from use and age. Fan motor is leaking oil and is working at max. Advised is not good and can fail soon. Start up was above max on compressor. Run amps was high pulling 10 amps and max at 16. Unit hold r-22 and is no longer in production. Unit is hold a charge and cooling home at 20 degrees. New ducting used. Unit has a slab coil as well and is very bad design as they are not able to get cleaned or open up due to access. Oy one drain line am dis not good as no over flow switches are present. Cycled unit and went over all findings with client and she is aware of condition and how unit is running. She stated she is

Arrived on site to diagnose no cooling unit. Spoke to client and he stated unit is not cooling and think is refrigerant issues. Had him cycled and found out door unit not operating properly. Fan motor was not operational. Advised would inspect unit. Checked electrical found secondary motor control out of range and bad and fan is causing part to fail. Replaced to test unit and was operational. Primary starter Burnt up. Fan motor leak slight oil but okay in range of amps. Start up high but in range and recommended compressor booster kit to help prevent hard start and prolong life of unit. Unit hold r-22 and is no longer in production. Unit is hold a good charge. Unit is cooling hole now at 20 degrees. No protection on either unit. Inspected attic and found black flex ducting used. Blower assembly and wheel are dirty. Drain lines have no safety overflow on either unit and recommended adding some. Client are not change filter as they should recommended upgrading to a year long filter since

Arrived on site to perform tune up on a 1 year old package unit. Unit is new and client stated no issues. Cycled both heating and cooling. Filter was replaced by client. Washed condenser coil inside and out. Checked electrical compartment and components and all good. Blower motor and assembly is good. Both motor are in range in amps. Pressures are good and cooling home at 21 degrees. Advised filter needs to be replaced more often and they are going to do so. Cycled Heater and is operational. Temperature rise is in range and heating home good. No protection on unit. Client wanted to renew but stated she will do so Monday as I will call her to renew over phone. Cycled unit and is operational upon departure.

Arrive on n site to perform spring tune up on a 5 year old unit. Client stated no issues. Condenser in back yard. Furnace located in garage. Washed condenser coil inside and out. Checked electrical and and components. Primary starter is pitting out from operational. Secondary motor control is good. Fan motor is good. Checked pressure and are good and steady and cooling home at 21 degrees. No protection out side. Filter was good and replaced in past. Blower motor and whee is good. Motor is free of oil. Unit is cooling hole good. Drain line is good and clear. All safety switches are operational. No protection inside as well. Recommend adding protection to both unit to protect systems from electrical surges and power outages. Cycled unit and went over findings with client and he is aware but did hold off. Cycled unit and is operational upon departure.