Menifee, CA

Arrived on site to perform diagnostic on a no cooling. 2013 carrier unit. Condenser located in back yard. Furnace located in attic.spoke to client he stated he think motor went bad. As he had past issues and the same issues happened today. They also had synergy come and install a new Honeywell. Unit was not calling for cooling. Jumped unit at board and found a low voltage short as fuse got popped. Removed condenser thermostat wires. Fuse did not pop. Put in a tester stater and it was pulling in due to command for cooling. Put thermostat back on wall to run it as it should. Found there as bad and not clicking over. Jumped now at the thermostat and unit was operational. Advised stater and thermostat are bad and would need replaced to continue. Got u it operational and checked pressure. Pressure looked as if unit was low and and had a refrigerant restriction. Inspected indoor and put. Found unit to be to different sizes units. Condenser is a 2.5 Ton and furnace is a 5 ton. Advised unit i

Arrived on site to perform spring tune up on. 10 year old unit. 2012 carrier. Condenser located in back yard. Furnace located in attic. Unit is 2 zones. Cycled both and operational. Washed condenser coil inside and out. Primary starter worn out and pitted from operation. Secondary motor control is good and in range. Fan motor has been replaced in past and is good. Checked start up on and found it at max pulling 104 and max at 109. Recommend adding compressor booster kit to prevent hard start up. Run amps are in range pulling 9 and max at 19.9. Unit is hold good charge and is r410-a and cooling at 20 degrees. No protection on unit and recommended adding. Inspected indoor unit filter are good and okay at this time as unit is not ran a lot. Found unit to be zoned and it is a single furnace and motor is 1 speed as well. Blower assembly and wheel dirty. Motor is leaking so much oil as a puddle under motor from really over working as it is not variable speed. Advised unit to run efficient s

Arrived on site to perform AC diagnostic on 2020 Rheem condensing unit. Upon arrival client stated that system is no longer cooling as of Saturday. Proceeded to outdoor unit and found that it was not operational found that low-voltage connection was not being sent to outdoor unit and adjusted loose wire on indoor circuitboard then unit fired up. Once the unit was energized I was able to measure the refrigerant pressures and found that it was 1 pound low on R410a refrigerant charge. This may have been low from installation in 2020 or possibly developed the leak on the indoor outdoor unit. Recommended to Client that leak dye is injected to help locate and pinpoint location of leak to give peace of mind or wait till next time it’s low when it will be required to inject dye. Lastly found an outdoor condenser motor has lost a significant amount of oil from its bearing which has led to it overheating and using more power than usual. Client authorized mid range repair in components were ins

Client is only responsible for $15,687 remaining $ 3000 is coming from clean tech California

Performed combo maintenance on a 2021 system. Heating sensors and switches were cleaned and tested. Heating temperature rise is in range. Filter was changed today with a merv 16 customer provider. The bathroom register was flipped today in order to be more adjustable. Another register was adjusted. Refrigerant levels are ok. System is operational.

Arrived on site to perform AC diagnostic on two systems comfort maker unit 2007. Upon arrival Tyler stated that the systems have been nonoperational for about a year and when they were working they didn’t work properly. Began diagnostic and found that low-voltage wire on both upstairs and downstairs unit were chewed off from dog. Rewired line And low-voltage connections was energized. Found that both dual secondary motor controls were defective. Starters were burnt up on contact points and outdoor condensing fan motors are both leaking oil. Measured refrigerant pressures and found that upstairs pressures were fine but downstairs system was slightly low. Both system contained a phase out refrigerant called R22 which is no longer manufactured as of 2020. Discussed full condition with Tyler and at this time he would like to just do the bare minimum repair and understands that it is only a Band-Aid and doesn’t Guarantee extra life for both units. Client plans to replace in the near fut

Upon arrival performed diagnostic. Found system non operational. Found secondary motor control to be completely flat. Replaced and got system up and going for client.

Upon arrival performed diagnostic. Found system non operational. Found secondary motor control to be completely flat. Replaced and got system up and going for client.

Upon arrival performed diagnostic. Found system non operational. Found secondary motor control to be completely flat. Replaced and got system up and going for client.

Upon arrival performed diagnostic. Found system non operational. Found secondary motor control to be completely flat. Replaced and got system up and going for client.

Relocation of existing R22 system from back of the home to the right side of home. Customer to provide own electrical and service disconnect at new location. System may require additional R22 to obtain proper charge not included in this estimate.

Upon arrival performed maintenance on AC system. Indoor motor is in good condition. System overall is very efficient. Refrigerant levels are in range. Took entire system apart and cleaned condenser coils. Primary and secondary are in range. Amperage’s and voltages good. Circuit board & electrical connections. Client wants to sign up for membership but wants to pay in 2 weeks.

Upon arrival performed maintenance on AC system. Indoor motor is in good condition. System overall is very efficient. Refrigerant levels are in range. Took entire system apart and cleaned condenser coils. Primary and secondary are in range. Amperage’s and voltages good. Circuit board & electrical connections. Client wants to sign up for membership but wants to pay in 2 weeks.

Upon arrival performed maintenance on AC system. Indoor motor is in good condition. System overall is very efficient. Refrigerant levels are in range. Took entire system apart and cleaned condenser coils. Primary and secondary are in range. Amperage’s and voltages good. Circuit board & electrical connections. Client wants to sign up for membership but wants to pay in 2 weeks.

Upon arrival performed maintenance on AC system. Indoor motor is in good condition. System overall is very efficient. Refrigerant levels are in range. Took entire system apart and cleaned condenser coils. Primary and secondary are in range. Amperage’s and voltages good. Circuit board & electrical connections. Client wants to sign up for membership but wants to pay in 2 weeks.

Arrived on site to perform tune up on a 32 year old. Client stated unit is working and no issues. Just had new thermostat added on. He is aware unit is old and condition and just waiting for it to fail. Washed condenser coil. Checked electrical. Primary stater is older and original. Secondary motor control is out of range. Fan motor is working hard and starting to have a lot of play from over working. Checked compressor and is working hard due to condenser coil is missing a good are of it and causing really high stress on unit. Checked preamp unit is holding a charge but in accurate due to the condenser coil missing as it not able to reject out of unit. High side pressure got to 370. Unit is cooling at 17 degrees. Filter was replaced by client. Blower assembly is dusty due to age of unit as it’s pro to home. No protection on either unit. Cycled unit and went over findings. Client is well aware of how bad it’s running and conditions. He dose not want to do any repairs as he is just

Upon arrival performed maintenance on AC system. Everything checked out good. Install is immaculate. Filter is good. Cleaned out coils. System is operational upon completion.

Upon arrival performed maintenance on AC system. Everything checked out good. Install is immaculate. Filter is good. Cleaned out coils. System is operational upon completion.

Upon arrival performed maintenance on AC system. Everything checked out good. Install is immaculate. Filter is good. Cleaned out coils. System is operational upon completion.

Upon arrival performed maintenance on AC system. Everything checked out good. Install is immaculate. Filter is good. Cleaned out coils. System is operational upon completion.

Upon arrival performed maintenance on AC system. Refrigerant levels are in very good range. Temp split in range. Primary & secondary motor control in range. Washed condenser coils. Primary starter has some pitting on contacts from wear & tear. Filter is good & clean. Amperage’s & voltages good. Condenser fan motor is running in between max amps and down. Not going over max amps. System is operational upon completion

Upon arrival performed maintenance on AC system. Refrigerant levels are in very good range. Temp split in range. Primary & secondary motor control in range. Washed condenser coils. Primary starter has some pitting on contacts from wear & tear. Filter is good & clean. Amperage’s & voltages good. Condenser fan motor is running in between max amps and down. Not going over max amps. System is operational upon completion

Upon arrival performed maintenance on AC system. Refrigerant levels are in very good range. Temp split in range. Primary & secondary motor control in range. Washed condenser coils. Primary starter has some pitting on contacts from wear & tear. Filter is good & clean. Amperage’s & voltages good. Condenser fan motor is running in between max amps and down. Not going over max amps. System is operational upon completion

Upon arrival performed maintenance on AC system. Refrigerant levels are in very good range. Temp split in range. Primary & secondary motor control in range. Washed condenser coils. Primary starter has some pitting on contacts from wear & tear. Filter is good & clean. Amperage’s & voltages good. Condenser fan motor is running in between max amps and down. Not going over max amps. System is operational upon completion

Arrived on site. Performed ac tune up. Cleaned both condenser coils. Checked electrical. No issues with start components. Found compressor drawing LRA on compressor for downstairs. Found fan motor pulling over max amps on start up. Recommend adding hard start and new fan motor to system. Inspected drains for units. No safety switches attached. Refrigerant charge for downstairs was off. Still cooling. No other issues found. Systems are operational upon departure.