Lake Elsinore, CA

Checked system for functionality. Replaced filters. Tested thermostats. Inspected indoor unit and condensate drain line. Tested cooling and measured indoor temperatures. Measured outdoor system voltages and motor amp draws. Checked electrical controls. Replaced line set insulation. Cleaned outdoor condenser inside and coils. Verified refrigerant charge.

Replaced low voltage fuse in furnace circuit board. Helped customer with new thermostat, checked filters. Tested system on cooling and measured temperatures. Verified charge. Tested voltages and amp draws. Replaced line set wrap.

Performed AC maintenance on 2016 Lennox Package unit. Cycled system for cooling. Checked package unit electrical and system components. Indoor blower motor secondary motor control is within Range. Compressor and condenser fan motor secondary motor control is within range. Primary motor control is in good condition. Evaporator coil is starting to get dirty, recommended replacing filter more frequently. Pulled off condenser fan motor and thoroughly washed out condenser coil inside and out. Washed exterior of unit. Replaced 1 inch filter. System refrigerant pressures are in range and system is producing a perfect temperature split. Went over findings and recommendations with homeowner. They wanna hold off on the maintenance program for now, but will be calling us in the winter to have us come out and do the heater maintenance and sign up on the ESA Maintenance Program. Cycled system, system is operational upon departure.

Doing a repair out here in Lake Elsinore

Performed AC tuneup on 3 ton two system condenser. Upon maintenance found that downstairs system suction line was icing up due to indoor blower failing. Downstairs 3 ton aire-flo 1. Found the indoor blower failed causing suction line to ice up and form ice with an evaporator coil. 2. Hardstart no longer supplying proper micro reading to support Lock rotors on start up 3. High-voltage really responsible for starting system showing signs of pitting on contact point along with high ohms on low voltage coil which can lead to shorts or popping fuses in attic 4. System may be low on R22 refrigerant Not for sure until indoor blower is fixed to check pressures 5. Suction line insulation falling off 6. Disconnect did not contain any fuses or surge protection Upstairs 3 ton 1. Found the compressor failing on lock rotor start ups while under a load, Is causing compressor not start when called for this can be intermittent 2. Found that system was pulling 12 A on an 85° day this amperage will inc

Returning Friday at 10

Performance tune up and maintenance for the cooling system. Checked air handler and cleared the condensate drain, checked air filters, these were clean so I left replacements. Checked electrical at the outdoor unit including amp draws, voltages and capacitance. Checked the disconnect fuses. Checked the starter. Removed the fan motor and cleaned the condenser coil from the inside. Measured refrigerant pressures and recorded indoor temperature splits. Added a small amount of foam tape to the line set wrap.

System not working properly on arrival, inspected thermostat and found 0 volts at the backplate. Inspected the fau and system has no high voltage. Found that the indoor breaker was tripped, reset breaker and inspected outdoor system. The battery is low and needs replaced, also replaced both filters. The temperature splits were measured and the system is working at this time.

Post job walk

Performed diagnostic on 2004 system. Homeowner states that system is not cooling, not blowing any air. She had another company come out yesterday and they replaced the secondary motor control on the indoor blower motor, but also told her that she had a bad circuit board and she wanted us out to double check. I cycled system for cooling. Outdoor unit kicks on fine, but indoor motor is unresponsive. After thoroughly inspecting unit, original companies diagnostic was correct and circuit board is no longer operational. It is receiving fan command in, but it is not sending it out. Did advise Irene that it is possible there can be other underlying issues which will not be able to get tested until board is replaced. Quoted Irene to replace the circuit board, but company that came out yesterday was a lot cheaper. Spoke to Andrew and gave homeowner the best possible price we can give, other company was still significantly cheaper. She will be calling other company for the repair, but she want

Checked outdoor condenser for operation. Measured voltages and amp draws for both motors. Recorded starting load p for the compressor. Checked refrigerant pressures and line temperatures. Cleaned electrical panel of dust and webs. Checked outdoor motors running components. Checked the starter for pitting, this is mildly pitted. The top of he condenser had a fair amount of grease, cleaned this with simple green and a rag. Unable to enter home at this visit, could not check indoor system temperature splits, replace filters, check airflow or thermostat, could not clear condensate drain.

Found low-voltage short on outdoor condensing unit thermostat wiring

Performed AC maintenance on 12 year old 5 ton condenser

Did not touch system. System is not cooling. Temp splits are off. Low on charge.

Did not touch system. System is not cooling. Temp splits are off. Low on charge.

Did not touch system. System is not cooling. Temp splits are off. Low on charge.

Did not touch system. System is not cooling. Temp splits are off. Low on charge.

Air conditioning maintenance and check up

Condenser relocate estimate.

Condenser relocate estimate.

Condenser relocate estimate.

Condenser relocate estimate.

Upon arrival performed diagnostic. System is working and operational. Isis check air flow and working. System is over working itself and overheating. Highly recommend replacement on system due to age and efficiency and amount of repairs needed. Took isis out to unit to see what system was doing & overheating. System is non operational.

Upon arrival performed diagnostic. System is working and operational. Isis check air flow and working. System is over working itself and overheating. Highly recommend replacement on system due to age and efficiency and amount of repairs needed. Took isis out to unit to see what system was doing & overheating. System is non operational.

Upon arrival performed diagnostic. System is working and operational. Isis check air flow and working. System is over working itself and overheating. Highly recommend replacement on system due to age and efficiency and amount of repairs needed. Took isis out to unit to see what system was doing & overheating. System is non operational.