Hemet, CA

Darren is here for a turn over, system had cracked heat exchangers, shut gas off again.

Arrived on site to perform heating tune up on a mobile home unit from 1988. Home only have heater client just wanted to it looked at. Cycled it and was operational. Gas was on. Unit had very minimal since it was heat only. Blower assembly wheel is dirty. Motor has been walking oil from pst and has dirt and oil build up. Unit is heating home. Advised unit may have lasted due to it being only heater and not used as much out here. Secondary motor control for blower motor was out of range. Advised no protection on unit. When cycled unit off it took a long time for shut off. Cycled unit and client stated he is not trying to spend money in old unit or replace as he may be planing to move in a couple years. Client just wanted maintenance and inspected. Unit is operational upon departure.

Upon arrival performed maintenance. Indoor motor & wheel are in good condition. Circuit board and electrical connections in range. Filter was replaced client provided. Temp rise in range. System cycled on & off. Gas valve in working order. Wiped system down. System is operational upon departure.

Upon arrival performed maintenance. Indoor motor & wheel are in good condition. Circuit board and electrical connections in range. Filter was replaced client provided. Temp rise in range. System cycled on & off. Gas valve in working order. Wiped system down. System is operational upon departure.

Upon arrival performed maintenance. Indoor motor & wheel are in good condition. Circuit board and electrical connections in range. Filter was replaced client provided. Temp rise in range. System cycled on & off. Gas valve in working order. Wiped system down. System is operational upon departure.

Upon arrival performed maintenance. Indoor motor & wheel are in good condition. Circuit board and electrical connections in range. Filter was replaced client provided. Temp rise in range. System cycled on & off. Gas valve in working order. Wiped system down. System is operational upon departure.

Technician arrived to perform ac tune up -Condenser was thoroughly cleaned out -Filter was replaced -Secondary motor control was reading low mfd, replacement was recommended -Starter chatters, very pitted contact points, replacement was recommended -Refrigerant levels within range -System currently cooling

During my twenty point heating inspection, I started with the thermostat. Giving a call for heating, and going to furnace to start maintenance. Temp rise of 40-80 needed, I got a temp rise of 53. House heats up to designated temperature. I checked out blower motor of any dirt or debris. It’s clean, only being a four year old system. Replaced air filter for new air filter. Owner had extra one, so just used his. Thermocouple needed to be lit, got long lighter and turned system on in heating. He never used Heater so he didn’t realize it didn’t work. Ducting done correctly, and all runs intact. Inducer motor is working efficiently. House heats good and ready for winter.

Added a common between indoor and outdoor systems, wired w1 to outdoor for defrost. Monitored operation and tested all modes.

Arrived on site to perform spring tune up on a 1 year old unit. Client stated no issues and is good and cooling. Cycled unit and was operational. Ac was only replaced. Unit is operational. Washed condenser coil inside and out and around and removed all the leave that were surrounding the unit. Advised should be cleaning around unit to keep leave away. Fan motor is good. All electrical components and connections are good. Boards are good. Compressor is good and in range. Unit is cooling good. Found no protection on unit. Inspected indoor unit. Filter was hammered clogged. Advised it should be getting replaced at-least 3 month. Cloy stated she will be going to the store right now to go buy some to put in. Drain lines are good and safety switch is operational. Unit is cooling. Furnace is older. Blower assembly and wheel are dusty from dusty that has entered in past. No protection inside as well. Cycled unit and went over how unit is running. She is aware Ac is new and heater is older. S

Performed diagnostic on 10 year old unit. Met with owner and daughter. System is not cooling, air coming out of the vents is warm. Cycled system for cooling. Indoor unit kicked on normally, outdoor unit is completely unresponsive. Checked system electrical and components. Found a bad primary motor control that was not allowing power to flow through keeping the unit from turning on. Also found that secondary motor is low and should be replaced. Went over findings and recommendations. With approval replaced primary and secondary motor controls. System came on and started cooling. Gauged up to verify proper refrigerant charge. Signed up on maintenance program, first visit will be for heat. Cycled system, system is operational upon departure.

Wired the system up to legacy terminals and tested both cooling stages. System is working properly and the error code is cleared,

Arrived on site to diagnose a no cooling 2016 Goodman unit. Client stated he replaced units in past. But is not having any air come out but condenser is operational. Advised inspected attic first. Checked electrical compartment and components. Found discoloration on board from burnt spots and advised is not good. Unit has no protection. Found second motor control completely bad. Found motor to be replaced and is really dirty. Replaced secondary and u it was operational. Cycled unit and inspected condenser. Primary starter okay. Secondary motor is in range. Fan motor has been leaking oil. Checked pressure and found unit low. Advised could be a leak present. Client did want to go forward charging up unit for now with no dye and second control. Charged up unit with 3 pounds and found pressure to get wired and found unit to have a restriction of refrigerant. Advised Txv could have failed as my low side has not went up and high side to have gone up 100 pgsi advised I don’t want to add no

Upon arrival performed maintenance, client just moved in a month ago. Wanted to see how system is performing. Found system to be running. Very high electrical usage on outdoor system. Compressor is almost hitting max amperage’s. This is a sign of lots of wear & tear & age. Coils are pretty damaged. Indoor blower wheel is extremely dirty. Dusted off electrical components. Client has high electricity bills and leaves thermostat at 78 degrees. Compressor is in its way out the way it is running. Can eventually start tripping breakers. Thermostat in working order. System is operational upon completion.

Upon arrival performed maintenance, client just moved in a month ago. Wanted to see how system is performing. Found system to be running. Very high electrical usage on outdoor system. Compressor is almost hitting max amperage’s. This is a sign of lots of wear & tear & age. Coils are pretty damaged. Indoor blower wheel is extremely dirty. Dusted off electrical components. Client has high electricity bills and leaves thermostat at 78 degrees. Compressor is in its way out the way it is running. Can eventually start tripping breakers. Thermostat in working order. System is operational upon completion.

Upon arrival performed maintenance, client just moved in a month ago. Wanted to see how system is performing. Found system to be running. Very high electrical usage on outdoor system. Compressor is almost hitting max amperage’s. This is a sign of lots of wear & tear & age. Coils are pretty damaged. Indoor blower wheel is extremely dirty. Dusted off electrical components. Client has high electricity bills and leaves thermostat at 78 degrees. Compressor is in its way out the way it is running. Can eventually start tripping breakers. Thermostat in working order. System is operational upon completion.

Upon arrival performed maintenance, client just moved in a month ago. Wanted to see how system is performing. Found system to be running. Very high electrical usage on outdoor system. Compressor is almost hitting max amperage’s. This is a sign of lots of wear & tear & age. Coils are pretty damaged. Indoor blower wheel is extremely dirty. Dusted off electrical components. Client has high electricity bills and leaves thermostat at 78 degrees. Compressor is in its way out the way it is running. Can eventually start tripping breakers. Thermostat in working order. System is operational upon completion.

Upon arrival replaced secondary motor control.

Upon arrival replaced secondary motor control.

Upon arrival replaced secondary motor control.

Upon arrival replaced secondary motor control.

Upon arrival performed maintenance on system. Temp splits are in range. System is cooling. Opened up coil and looked through outdoor system looking for a leak, did not find any leak present at the time. Will look again for furnace visit. Found secondary motor control low. Filter is good, not ready for replacement. Washed outdoor coils & inside of air conditioner caging. Sealed up Indoor coil back. Systek is operational upon completion.

Upon arrival performed maintenance on system. Temp splits are in range. System is cooling. Opened up coil and looked through outdoor system looking for a leak, did not find any leak present at the time. Will look again for furnace visit. Found secondary motor control low. Filter is good, not ready for replacement. Washed outdoor coils & inside of air conditioner caging. Sealed up Indoor coil back. Systek is operational upon completion.

Upon arrival performed maintenance on system. Temp splits are in range. System is cooling. Opened up coil and looked through outdoor system looking for a leak, did not find any leak present at the time. Will look again for furnace visit. Found secondary motor control low. Filter is good, not ready for replacement. Washed outdoor coils & inside of air conditioner caging. Sealed up Indoor coil back. Systek is operational upon completion.

Upon arrival performed maintenance on system. Temp splits are in range. System is cooling. Opened up coil and looked through outdoor system looking for a leak, did not find any leak present at the time. Will look again for furnace visit. Found secondary motor control low. Filter is good, not ready for replacement. Washed outdoor coils & inside of air conditioner caging. Sealed up Indoor coil back. Systek is operational upon completion.