Hemet, CA

Upon arrival client stated system kept tripping breaker. Found system to no be wired for 2 stage cooling. Wired for 2 stage cooling got system running on that mode. Breaker needs to be replaced to a 30 amp Max breaker currently at a 20 with 30 amp fuses. Sent picture to parts house so we can come replace breaker .

Upon arrival client stated system kept tripping breaker. Found system to no be wired for 2 stage cooling. Wired for 2 stage cooling got system running on that mode. Breaker needs to be replaced to a 30 amp Max breaker currently at a 20 with 30 amp fuses. Sent picture to parts house so we can come replace breaker .

Arrived on site to perform diagnostic on a 9 year old unit. Client out door unit is freezing over and had someone out and told him there issues was inside due to client and wife being sick couldn’t not go inside. Had him cycled unit and outdoor was operational. Indoor was not producing any airflow. Inspected attic unit. Found motor not operational. Found unit to be a high efficient unit. Checked for power and found motor to be getting high and low voltage. Board is good and sending power as condenser is operational. Advised motor is bad. Found unit to not have any protection and high recon adding ad else components are at with with surges and power outages and can damage or even short out systems components. Went over findings and client is aware what is the issues with unit. Client did want to go forward with replacing motor and adding surge protectors to unit. Will be ordering motor from sigler and once motor come will come back out to do all repairs. Cloy is aware and okay with s

Client stated air is not cold -Technician found the refrigerant levels to be a little bit low -Two lbs of 410a was added to the system to get that air as cold as possible -The condenser fan motor was having a very hard time keeping up -It was amping very high and needed to be replaced to boost efficiency and longevity -New condenser fan motor is installed -System is cooling the house properly

Performed an ax maintenance on a 2020 Lennox system. System was chemically bathed and thoroughly washed. Checked out the pressures and they where in range. Checked all electrical components and everything was in range. Filter was not swapped at this appointment. System was fully operational on time of departure.

Upon arrival replaced indoor Motor. System is operational. But refrigerant is really low. Client does not want to go refrigerant route. Would like someone to come out to give replacement options. System is now operational but no cooling coming out due to low refrigerant.

Upon arrival replaced indoor Motor. System is operational. But refrigerant is really low. Client does not want to go refrigerant route. Would like someone to come out to give replacement options. System is now operational but no cooling coming out due to low refrigerant.

Upon arrival replaced indoor Motor. System is operational. But refrigerant is really low. Client does not want to go refrigerant route. Would like someone to come out to give replacement options. System is now operational but no cooling coming out due to low refrigerant.

Upon arrival replaced indoor Motor. System is operational. But refrigerant is really low. Client does not want to go refrigerant route. Would like someone to come out to give replacement options. System is now operational but no cooling coming out due to low refrigerant.

Arrived on site to diagnose a 1995 carrier 3 phase package unit on a commercial building. Spoke to client and client stated he’s been renting place out. Past owners put in mini splits and those are being power from the the package unit. Client stated caliper days ago they didn’t turn off package unit but turned off minis splits. They came back the next day and unit was not operational. He went up on roof and saw what he think a line blew up as he see oil on roof top floor. He called us out to see if he can fix the issues or if compressor is bad to see what can be done. Went on roof too found unit. Opened up package unit found it to be a 3 phase R-22 unit. Unit is leaking refrigerant. Opened up compressor side and found compressor blew up as there is a hole on the compressor connections and has leaked out all refrigerant. Advised unit compressor needs to be replaced if one can be found as refrigerant has been phased out and equipment is phased out as well. Spoke over findings with

Increased the capacity for the outdoor unit from 4 ton to 5 ton. Set the system to strong mode, which will meet the controls temperature demand faster.

Arrived on site to perform spring tune up on a 1 year old unit. Client micheal had been out in past and did repair and charged up unit and added leak dye in unit. She wanted to see how unit was doing. Cycled unit in cooling and was operational. Washed condenser coil inside and out. Checked electrical compartment and components. Stater and secondary motor controls was good. Fan motor was good and in range. Compressor start up and run amps are good and in range. Checked pressure and found unit to be holding a steady charge but found unit slightly low. Inspected unit with bubbles and Uv lights on condition and welds. Found not trace in unit at this time advised could be a micro leak and these can be hard to find. Unable to find leak. Inspected indoor unit. Filter was replaced by client. Blower assembly and whee are good. Motor is good and in range. Drain lines are cleaner and found no dye in evaporator coil. Drain pump is operational. Unit was cooling at 18 degrees at This time. Cycled u

Performed diagnostic on indoor system. Client stated he had somewhat checked the system to see if anything was going on with it. Client has a buddy that owns hvac company & was helping with diagnose . Was sure that circuit board was bad but client just wanted to make sure. System is non operational.

Performed diagnostic on indoor system. Client stated he had somewhat checked the system to see if anything was going on with it. Client has a buddy that owns hvac company & was helping with diagnose . Was sure that circuit board was bad but client just wanted to make sure. System is non operational.

Performed diagnostic on indoor system. Client stated he had somewhat checked the system to see if anything was going on with it. Client has a buddy that owns hvac company & was helping with diagnose . Was sure that circuit board was bad but client just wanted to make sure. System is non operational.

Performed diagnostic on indoor system. Client stated he had somewhat checked the system to see if anything was going on with it. Client has a buddy that owns hvac company & was helping with diagnose . Was sure that circuit board was bad but client just wanted to make sure. System is non operational.

Upon arrival client wanted to add supply ducting to sun room. Informed client that the room was not insulated and we would need to run exposed ducting from the unit to sun room. Additionally the system was not sized properly for that extra CFM required to cool that space. Recommend insulating that sun room and adding a mini split to the space.

Upon arrival performed diagnostic. Client stated before his fuses popped, had a 30 amp fuse on circuit board. Added 3 amp fuse, outside air kicks but no indoor motor. Circuit board kicks for power. Indoor Motor burnt, will do a full evaluation on system when having it working. System is non operational.

Upon arrival performed diagnostic. Client stated before his fuses popped, had a 30 amp fuse on circuit board. Added 3 amp fuse, outside air kicks but no indoor motor. Circuit board kicks for power. Indoor Motor burnt, will do a full evaluation on system when having it working. System is non operational.

Upon arrival performed diagnostic. Client stated before his fuses popped, had a 30 amp fuse on circuit board. Added 3 amp fuse, outside air kicks but no indoor motor. Circuit board kicks for power. Indoor Motor burnt, will do a full evaluation on system when having it working. System is non operational.

Upon arrival performed diagnostic. Client stated before his fuses popped, had a 30 amp fuse on circuit board. Added 3 amp fuse, outside air kicks but no indoor motor. Circuit board kicks for power. Indoor Motor burnt, will do a full evaluation on system when having it working. System is non operational.

Y2 was not connected on outdoor system. Was only cooking at 69 degrees, now getting into the 50s 38 degree split right now. System is operational.

Y2 was not connected on outdoor system. Was only cooking at 69 degrees, now getting into the 50s 38 degree split right now. System is operational.

Y2 was not connected on outdoor system. Was only cooking at 69 degrees, now getting into the 50s 38 degree split right now. System is operational.

Y2 was not connected on outdoor system. Was only cooking at 69 degrees, now getting into the 50s 38 degree split right now. System is operational.