Fallbrook, CA

Upon arrival performed maintenance on heating system. Opened up system and found filter to be extremely dirty. Advised we need to swap these out every 2 months. Indoor blower wheel is dirty, client is aware. Offered to have surgery protection installed in system to protect any electrical components. Client thinks it’s a good idea, wants me to get a hold of wife. Circuit board and electrical connections in range. Client will replace filters. Cycled system on and off. Thermostat in working order. System is operational upon completion.

Upon arrival performed maintenance on heating system. Opened up system and found filter to be extremely dirty. Advised we need to swap these out every 2 months. Indoor blower wheel is dirty, client is aware. Offered to have surgery protection installed in system to protect any electrical components. Client thinks it’s a good idea, wants me to get a hold of wife. Circuit board and electrical connections in range. Client will replace filters. Cycled system on and off. Thermostat in working order. System is operational upon completion.

Upon arrival performed maintenance on heating system. Opened up system and found filter to be extremely dirty. Advised we need to swap these out every 2 months. Indoor blower wheel is dirty, client is aware. Offered to have surgery protection installed in system to protect any electrical components. Client thinks it’s a good idea, wants me to get a hold of wife. Circuit board and electrical connections in range. Client will replace filters. Cycled system on and off. Thermostat in working order. System is operational upon completion.

Upon arrival found 1 18 year old Lennox furnace. The furnace is located under the house. Inspection found the following. Blower motor and wheel are failing. Wheel needs to be cleaned. Return was undersized and is leading to high static and temp rise. Was unable to inspect heat exchanger because blower motor access was blocked. Need help to shift the heater over to gain more access. Hot surface igniter is looking bad. Should be replaced soon. Better filtration would help keep the dirt out of the system. Went over recommendations on system. Client went forward with the blower capacitor. Talked about replacement options. System is operational upon departure.

Upon arrival started tune up of system. Motors are good and found no issues with ignition components. Heat rise is okay. Static is high. Airflow is okay. No gas filter installed on system. Blower wheel is dirty. Went over options on system. Unit is operational upon departure.

Arrived on site to perform furnace maintenance on 2006 high-efficiency carrier furnace. Upon arrival heather stated that the system has been working properly and They don’t use it too much. Performed for maintenance and safety inspection found a couple issues present 1. Previously it looked like water had leaked inside of the furnace although no water present at this time and drain lines were clear 2. System was not equipped with flood protection 3. Flame sensor was heavily oxidized and will lead to the furnace not being able to detect flames being present. 4. Filter was recently swapped out 5. Circuitboard did have burn marks and heat spots on it Discussed and informed the full condition of Heathers 2006 carrier furnace. At this time Heather would like to hold off on any repairs due to them not using the heater too much. Heather is fully aware of everything that was presented and everything will be emailed over. Upon departure system is fully operational

Performed furnace maintenance on three systems Rheem heaters. Upon arrival Susan stated that systems have been working fine and they only use the bedroom one at this time. Perform safety inspection and maintenance and only really found concerns for north side of house furnace. 1. Indoor blower motor is leaking oil and beginning to over amp 2. Duct work was disconnected on one run 3. Flame sensor was dirty 4. No drip leg on gas line Discussed full condition of all three systems and Susan is aware of how they are running at this time. She would like to hold off on repairs for the north side of house system Because the tenant is moving out of that side and no one will be using it. Client did renew maintenance plan and will continue to come out twice a year with filters included. Upon departure Systems are fully operational

arrived on site to perform fall tune up on a 9 year old u it down flow. Unit located in laundry room. Clients stated no issues and heater is good and operational. Client did want to replace filter. Cycled not and. Lower wheel is dirty. Filter was replaced as is was a washable and put a pleated filter. Motor are okay and in range of operation. Wheel is dust due to area. All safety switches are operational. Drain lines okay slight dust as dirt has entered unit. Advised to buy some filter on hand to replace as needed to keep dirt out. No protection on unit recommended adding surge protection to protect systems from electrical surges and power outages. Cycled unit and went over all findings and areas of concerns as well as recommendations. Client is aware of all and did hold off for now but will keep in mind. Advised not a problem and just wanted it all emailed over to her and she will read over it and let us know. Cycled unit to ensure system operational. Emailed her the recommendations.

Found ignitor broken inside the heat exchanger this was replaced. Upon tested found pressure switch stuck closed and unable to open. Replaced pressure switch as well. Tested system for operation and system is heating properly at his time.

Upon arrival performed maintenance, indoor motor and wheels are in range. Circuit boards and electrical connections in range. Systems are heating. Filters are good. Surge protectors in range. Insulation levels good. Ducting system good. Thermostats in working order. System is operational upon departure.

Upon arrival performed maintenance, indoor motor and wheels are in range. Circuit boards and electrical connections in range. Systems are heating. Filters are good. Surge protectors in range. Insulation levels good. Ducting system good. Thermostats in working order. System is operational upon departure.

Upon arrival performed maintenance, indoor motor and wheels are in range. Circuit boards and electrical connections in range. Systems are heating. Filters are good. Surge protectors in range. Insulation levels good. Ducting system good. Thermostats in working order. System is operational upon departure.

Upon arrival performed maintenance, indoor motor and wheels are in range. Circuit boards and electrical connections in range. Systems are heating. Filters are good. Surge protectors in range. Insulation levels good. Ducting system good. Thermostats in working order. System is operational upon departure.

Heating Maintenance Performed Upon arrival system is working and operational. I began my maintenance at the outdoor condenser unit. I checked electrical components and inspected wear. I tested amp draws and ensured tight connections. I checked pressures as well as broke down the unit and cleaned dirt and debris from the coil and housing. I then accessed the attic and checked for duct leaks or improper duct runs. I then proceeded to the furnace unit, I checked and tightened electrical connections. I inspected the heating components for proper operation and wear. Burners were inspected for proper operation. Flame sensor was cleaned. Condensates lines were inspected for proper drainage. Static pressures and temperature splits were taken. Filter has been checked, does not need to be changed at this time. Blower housing and wheel was inspected for balance and dust build up. Air supply was measured. Inspected safety switches as well as inspected home for fire and carbon monoxide detectors.

Found high limit switch open on arrival, wire disconnected from switch. Reconnected the wire and tested the equipment. System working properly at this time.

Performed furnace diagnostic on high efficiency Goodman heater. What arrival homeowners were not present although began diagnostic with authorization through Pamela. Furnace was located under home and immediately upon troubleshooting a profuse of smell of propane was present around the furnace. Found that gas lines were installed incorrectly and it’s causing the main shut off valve to disconnect and break resulting in propane leaking out. Shut off was left off at this time due to unsafe conditions for operation. Heating compartment of furnace door was missing door and is required for proper operation. Pigtail was also not installed and is directly hardwired into the breaker which Is not up to standard code. Neil arrived at the end of the diagnostic and explained that the system was donated Stop there a company that is no longer in business. Unfortunately system is not up to 100% code is not in proper running condition. Comfort adviser will be returning to go over system replacement o

Bled the zone dampers. Relocated the dats zone temp sensor. Adjusted the airflow settings for the zones. Tested equipment.

Arrived on site to perform fall tune up on 2 2019 lennox units. Client stated no issues and was all good. Cycled both heater and all heating. Filter were dirty but she stated she would order herself. But she has a purifying filtration system. She is aware and will hold off for now. Both blower blower assembly are good and motor as well. Both inducer motor are good. All safety switches are operational. Temperature rise is good on both. Drain lines are clear and draining at this time. Safety switches on secondary drain lines. No protection on units. Recommend adding surge protectors to protect systems from electrical surges and power outages that can damage or even damage or short out systems and components. Cycled both unit. Client so aware of how units are running and there conditions. Client did declined recommended work at this times. She is aware and will let us know when she is ready. Both systems are operational upon departure.

Upon arrival performed maintenance on on heating system. Indoor blower wheel dirty. Coil is dirty as well. 2 inch filter is completely dirty client provided new filter. UV light in working order. Ampergess are in range. Vacuumed return. Washed outdoor system. Checked refrigerant pressures. Dusted off electrical components.

Upon arrival performed maintenance on on heating system. Indoor blower wheel dirty. Coil is dirty as well. 2 inch filter is completely dirty client provided new filter. UV light in working order. Ampergess are in range. Vacuumed return. Washed outdoor system. Checked refrigerant pressures. Dusted off electrical components.

Upon arrival performed maintenance on on heating system. Indoor blower wheel dirty. Coil is dirty as well. 2 inch filter is completely dirty client provided new filter. UV light in working order. Ampergess are in range. Vacuumed return. Washed outdoor system. Checked refrigerant pressures. Dusted off electrical components.

Upon arrival performed maintenance on on heating system. Indoor blower wheel dirty. Coil is dirty as well. 2 inch filter is completely dirty client provided new filter. UV light in working order. Ampergess are in range. Vacuumed return. Washed outdoor system. Checked refrigerant pressures. Dusted off electrical components.

Preformed furnace maintenance on 2014 Lennox heater.

Tech arrived on site. Found unit in lock out. Found pressure switch to be not closing. Replaced with universal pressure switch. After that found the flame sensor not working as well. Replaced that and unit began to heat. Installed CO detector in master bedroom (customer supplied).

Performed AC maintenance on 2006 carrier package unit. Upon arrival Husband is at work and wife is present. Client stated that system has had no issues and is operational. Performed condenser coil cleaning and electrical inspection on unit, during the inspection I did find a few points of concern 1. circuit board had significant burn marks on resistor and may have been caused by power outages or from wear and tear over time. Recommend surge protection is installed to increase longevity 2. secondary motor control is becoming weak 3. Compressor is pulling high start up amps and recommend to reduce the power usage by installing a compressor saver kit to preserve the compressor. 4. System Contains R22 refrigerant which was completely Phased out January 1, 2020. Will be emailing over information and pictures of findings during the AC maintenance to Dan. Upon departure Filter was swapped and system is fully operational