Fallbrook, CA

System is not serviceable, client has a very big bush that is all around the entire system. Client needs to trip and keep away from system, this can really damage system. No charge

System is not serviceable, client has a very big bush that is all around the entire system. Client needs to trip and keep away from system, this can really damage system. No charge

Client is selling home, said he will let next home owners take care of thermostat. Would have replaced if labor was covered. Decided not to do it

Client is selling home, said he will let next home owners take care of thermostat. Would have replaced if labor was covered. Decided not to do it

Client is selling home, said he will let next home owners take care of thermostat. Would have replaced if labor was covered. Decided not to do it

Client is selling home, said he will let next home owners take care of thermostat. Would have replaced if labor was covered. Decided not to do it

Summer AC Maintenance Performed Upon arrival system is working and operational. I began my maintenance at the outdoor condenser by breaking it down and cleaning with water and coil solution, removing dirt and debris. I inspected electrical components for wear and tight connections. I checked refrigerant pressures and charge. I tested system amperages. I then proceeded to the indoor furnace unit. I measured temperature splits. I checked condensates for proper drainage and safety. Filter was changed. Inspected electrical to ensure tight connections and monitor wear. Inspected blower compartment for dust and dirt as well as proper balance. Upon departure system is working and operational.

Upon arrival performed diagnostic. Found compressor to not be up and running. Tested secondary motor control, found that secondary motor control was low. Replaced with a heavy duty control, started system. Found compressor starting at 70 amperages on the kick. Added booster kit to system and dropped it down to 9.8 amps. Refrigerant levels are in range. Filter is clean. Every register is open. System is operational upon departure.

Upon arrival performed diagnostic. Found compressor to not be up and running. Tested secondary motor control, found that secondary motor control was low. Replaced with a heavy duty control, started system. Found compressor starting at 70 amperages on the kick. Added booster kit to system and dropped it down to 9.8 amps. Refrigerant levels are in range. Filter is clean. Every register is open. System is operational upon departure.

Upon arrival performed diagnostic. Found compressor to not be up and running. Tested secondary motor control, found that secondary motor control was low. Replaced with a heavy duty control, started system. Found compressor starting at 70 amperages on the kick. Added booster kit to system and dropped it down to 9.8 amps. Refrigerant levels are in range. Filter is clean. Every register is open. System is operational upon departure.

Upon arrival performed diagnostic. Found compressor to not be up and running. Tested secondary motor control, found that secondary motor control was low. Replaced with a heavy duty control, started system. Found compressor starting at 70 amperages on the kick. Added booster kit to system and dropped it down to 9.8 amps. Refrigerant levels are in range. Filter is clean. Every register is open. System is operational upon departure.

Inspected both evaporator coil and condenser coil for any trace dye in the fins. Inspected the txv connections and the u-bends. Inspected the water in the primary drain pan for oil as well as the condensate vent. Found no evidence of dye on the welds inside or outside. Tested the shrader cores as well. There is a very slow leak that needs more time before the dye will become present. System still cooling well at this time.

System qualifies for 18 months no interest

Arrived on site to diagnose a no cooling 2000 unit condenser closeted in back yard. Spoke to client and they stated unit recently stopped working and they have lived in home for about 4 years. They noticed unit was not cooling home and fan was not spinning outside. Cycled unit and fan was not operational. Inspected electrical compartment and components. Found primary starter burnt up and work out. Secondary motor control was completely bad on both terminals and is why fan is not spinning. Advised motor could be going bad and causing secondary to fail. Replaced to test unit. Fan motor has oil leaking from past and advised could fail due to age and over all condition. Found condenser was covered in a oil and on copper line set. Advised client of findings and she stated they had refrigerant added last year and since then did coil until recently. Inspected unit and line set and found a leak was present and advised refrigerant had been slowly leaking over time since Last year. Would have to

System low on charge on arrival. Measured temperature splits and refrigerant pressures, inspected indoor system and verified txv metering device.

$1000 deposit taken - $7481 to be collected in check format from installation crew.

Arrived on site to perform spring tune up on a 7 year old unit. Condenser located in back yard. Client stated no issues. Cycled unit and operational. Washed condenser coil inside and out. Checked electrical compartment and components. Found primary start worn out and creating buzzing noise. Secondary motor control is good and in range. Found fan motor leaking oil. Leaking oil over time from over working is causing motor to seize up bearing name sling as efficiently. Motor coil be failing in future and recommend replacing. Start up amps o. Compressor are high but in range but recommended adding a compressor compressor booster kit to help keep start up low and preserve compressor life span. Run amps are good. Checked pressure and are good. Unit is cooling hole good. No surge protectors on either unit. Cycled system. Went over all findings and areas of concerns and client is aware of how unit is running and conditions. Client would like to hold off for now as husband is not home and is g

Performed maintenance on a Lennox Heat pump. System is cooling 20 degrees. Decent amount of mold buildup in the indoor coil and pan. Indoor amp draws are ok. Filter is clean, UV light is in good condition. Outdoor unit was chemically cleaned. Primary start component is very close to being out of range. Starter is ok. Refrigerant charge was checked . Compressor and fan amps are ok at thus time. Customer had questions about the operation if the thermostat which were answered today. System was running st end of appointment.

Performed AC maintenance on a Lennox system. Cooling temperature split is 20 degrees. Indoor blower is amping ok. Scroll wheel is caked in dust. No visual surge marks on any of the control board diodes. Filter was ok. Outdoor unit was chemically cleaned. Refrigerant levels are low. Compressor and fan start amps are ok at thus time . Starter and primary start motor are in range at this time. Customer wants to schedule a Phenomenal air install. System was running at end of appointment.

Performed diagnostic on 2004 Lennox system. Homeowner states that system is not cooling. The other day it cooled for a couple minutes and then started blowing room temperature air. Cycled system for cooling . Indoor unit kicked on, outdoor unit condenser fan motor is not turning over. After diagnosis found a bad secondary motor control that was not allowing fan motor to turn on. Also found a weak compressor secondary motor control as well. Put in a new secondary motor control and cycled system on to check unit. Further concerns showed that primary motor control is burnt and pitted. Amp draws on condenser fan motor are above range, compressor amp draws slightly high but within allowed range. Refrigerant levels are in range and system is producing proper temperature split. Went over findings and recommendations with homeowner. Spoke about possible replacement and repair options. Homeowner ultimately wants to see how much longer she can get out of system and wants to only do immediate rep

Upon arrival performed maintenance on carrier unit, opened up coil to look for refrigerant leak, was not able to find anything , added 5lbs of 410a, client just wants to top it off, not looking into replacements would like to see how long the refrigerant last. Client is not looking to replace in this time. Amperages on system are in range. Temp splits in range. Secondary and primary motor control in range. Washed out condenser coils. Condenser fan motor leaking oil. System is operational upon departure.

Upon arrival performed maintenance on carrier unit, opened up coil to look for refrigerant leak, was not able to find anything , added 5lbs of 410a, client just wants to top it off, not looking into replacements would like to see how long the refrigerant last. Client is not looking to replace in this time. Amperages on system are in range. Temp splits in range. Secondary and primary motor control in range. Washed out condenser coils. Condenser fan motor leaking oil. System is operational upon departure.

Upon arrival performed maintenance on carrier unit, opened up coil to look for refrigerant leak, was not able to find anything , added 5lbs of 410a, client just wants to top it off, not looking into replacements would like to see how long the refrigerant last. Client is not looking to replace in this time. Amperages on system are in range. Temp splits in range. Secondary and primary motor control in range. Washed out condenser coils. Condenser fan motor leaking oil. System is operational upon departure.

Upon arrival performed maintenance on carrier unit, opened up coil to look for refrigerant leak, was not able to find anything , added 5lbs of 410a, client just wants to top it off, not looking into replacements would like to see how long the refrigerant last. Client is not looking to replace in this time. Amperages on system are in range. Temp splits in range. Secondary and primary motor control in range. Washed out condenser coils. Condenser fan motor leaking oil. System is operational upon departure.

Arrived on site to perform spring tune up on a 1991 carrier unit. Condenser located in front yard. Furnace and Evaporator coil located in laundry room closet. Client stated no issues and knows it’s really old. Washed condenser coil inside and out. Checked electrical compartment and primary is worn out and burnt up on contact. Secondary motor control is good on both sides. Fan motor is leaking oil and is pulling max amps of .9. Motor may fail soon. Conor start up are hig. And recommend adding a compressor booster kit to help prolong and preserve compressor. Run amps are pulling 14 and ma x rated at 20. Advised compressor is on borrowed time. Checked pressure and found system to have a airflow issues. Possibly could be low o charge but is cooling at this time. But very inefficient due to age of unit. Client is aware. Went over all findings and areas of concerns with client and he did hold off for now as he gun. Look over some finances to see cause he is interested in replacing unit. Wa