Corona, CA

Arrived on site to perform AC diagnostic on 1997 system. Upon arrival homeowner stated that system is still working but not blowing as hard. Begin diagnostic and immediately found that Two filters were in place of the return causing a air flow restriction which was reducing the cold air coming out of the vent. Once filter was taken out system began cooling in blowing much harder. Proceeded to upstairs and found that no airflow is coming out of any vents. At this time client would like to hold off on looking into replacement options and would like to just go through a diagnostic charge today. Advised clients due to the system being 24 years old efficiency will decline and Airflow will get worse. Upon departure system is operational and cooling

Performed an AC maintenance on two comfort pro systems. Both systems where chemically bathed and thoroughly washed. Checked pressures and temperature splits and both where in range. Checked all electrical components and everything was in range. The client had stated that his son’s room does not cool down that well. Adjusted damper to help son’s room cool down more effectively. Filters where changed out this visit. System was fully operational on time of departure.

Upon arrival performed tune up on 6 year old package unit. Performed deep cleaning of condenser coil fins and exterior unit. Checked all electrical components and found dual secondary motor control to be weak on compressor side. Replaced with new Turbo 200. While checking compressor start amps found to be high @ 69 amps, LRA is 79. Because of this I recommended a compressor saver kit. Julie and Gerry agreed that this would be a good option so I installed it and it dropped the start amps to 21. Did not install any filters as Julie replaces them herself on a monthly basis because of dusty conditions. Upon departure system is operational.

Upon arrival performed AC tune up on 3 year old Lennox unit. Replaced filter with owner supplied 20x25x5 merv 16 filter. Checked temperature split, it was 18 degrees. Performed total external static pressure test, found to be very high at 1.44”wc, data plate is 0.8. Cleaned in place blower compartment, blower sounds balanced. Found no leaks in ducts. Performed deep cleaning on condenser coil fins and exterior unit. Found electrical components to be within limits, dual secondary motor control is towards the lower end of limits @ 33.6, lower limit is 33.3. Inspected starter, it’s very clean and shows no signs of burns or pitting. Measured start amps @ 11, run was 9.6. These are both within limits. Checked refrigerant pressures, they looked normal, sub cool was slightly low @ 4 degrees, for conditions I was supposed to see 5 +/- 1 so this was within limits. I recommended surge protection for both the indoor and outdoor unit to Kim to protect their investment. Kim mentione

Client stated no cooling -Hot air coming out -Condenser fan motor was non operational upon arrival -Secondary motor control was completely dead, reading 0 MFD -The fan motor was rusted out and leaking a ton of oil -Secondary motor control and fan motor was replaced -System is cooling properly, refrigerant levels are within range -Compressor and fan motor are pulling power within range -Client joined out comfort club -System is currently on

Client will not be home for another month

10 year parts/labor

Found blockage in two of the supply ducts behind the vents. Removed the metal blocking the flow and measured supply temps.

Performed an AC maintenance on a 2021 comfort pro. System was chemically bathed and thoroughly washed. Pressures and temperatures splits were checked and both are in range. All electrical components were checked and are in range. Filters were swapped this visit. System is fully operational on time of departure.

Arrived on site to diagnose a no cooling 11 year old unit. This is client rental property. They stated unit is just not cooling. They hear the fan but see unit running but is not cooling home down. Had him cycled thermostat to cooling i door operational. Outside fan was on and compressor was not. Inspected electrical compartment and found primary stater pitted and showing wear from operation and age. Secondary motor control is out of range and bad. Had to replace to see if unit would turn on and if there is anything else. Unit did turn on and was operational and cooling home at 17 degrees. Pressure were steady and in range at this time. Fan motor has been leaking from operation and age of 11 years. Compressor was loud on start up and recommended compressor booster. No protection on unit. Cycled unit advised filters should be replaced to keep unit from getting High stress. Cycled unit and went over all findings and client just stated she wants to just do minimum repairs as this is her

Will hand deliver $1,020 spent on repairs upon installation.

Technician arrived to install fan motor and capacitor -Everything was installed smoothly -When I turned the system on, there was no refrigerant whatsoever -When I came out a month ago, there was, so the leak is definitely a large one -Parts are still installed, Mateo is coming out today to provide replacement options

Arrived on site to diagnose condensation leak coming from the ceiling. Cut and cleared line to remove restrictions. Primed condensation line with 1 gallon of water and no blockages remained. Discovered primary drain line thread on drain pan is cracked. Install will be coming out to replace evaporator under warranty. Upon departure system is not operational.

Increased the blower speed from 4 to 9, the system is on the max cfm speed setting. Cleared dust and hair from 4 small return vents in the home which were dramatically reducing the airflow to the system. Also opened a supply register in the master bedroom which was closed.

Arrived on site to perform spring tune up on a 2018 unit And a 2011 unit. Client stated no issues as we have been out for repairs in past. Both condenser are located in back yard. Client stated no issues and units are cooling good. Cycled both and good. Washed out condenser coils inside and out. Checked both electrical compartment. Found stater on older unit to be burnt up from operation and age of turning on and off. Bryan unit was good as it’s young. Both secondary motor controls are good and in range. Both fan motors are both good and in range of amps. Checked start up amps on compressor. Startup are in range. Recommend adding compressor booster kit to help preserve compressor from hard start up every time. Run amps on both are in range. Checked pressure on both h it’s and found them in range and holding charge. Both units are cooling home good. Found both units to not have surge protectors. Filters were good at this time. Both units are cooling in range. Found not protection s

18 month same as cash available

Arrived on site to perform diagnostic on 2008 Goodman unit. Homeowner states that system is not cooling. It will blow cold air for a bit,and then just blowing warm air and never cools. Homeowner stated he also noticed that the outdoor fan would stop spinning as well. Unit top was taken off when I arrived. Cycled system for cooling. Unit came on and started cooling, after a bit outdoor fan motor shut off. Inside return was extremely loud. Opened unit and found a completely clogged filter. Homeowners was unaware that there was filter in the unit, meaning it has not been changed out in atleast 1.5 years. Inside blower wheel was completely filthy, and indoor motor casing is extremely dirty as well and leaking oil. Outdoor fan motor is almost seized up and will more than likely keep causing issues, should be replaced. Went over findings and recommendations with homeowners. They want to hold off on repairs for now, husband mentioned they did not have the money at the moment. Advised that we

Arrived on site to perform maintenance on 2 Lennox systems. 1 system is 2 year old and other is 5 year old. Cycled Systems for cooling. Performed attic and ductwork inspection. Filters are still clean. Temperature split is in range for both units. Checked outdoor units electrical and system components. Primary motor controls in good condition. Secondary motor control within range. Amp draws within good range. Pulled condenser motors and panels and thoroughly washed out condenser coils inside and out. Cycled systems, systems are operational upon departure.

Arrived on site to diagnose a no cooling unit. Client stated unit is making a really loud noise when it run. Unit is operational but is concerned about the loud screeching noise. Furnace in garage and condenser in back yard. Client stated the last guy was out and he was not advised of any recommendations. When to. Ores and found where last tech out out that client didn’t want to go over recommendations and he wanted it just emailed. So he did and doing so client still did t see recommendations but client was told of areas of concerns. Opened up electrical components. Secondary motor control is good still so advised fan motor has failed and seized up. He is aware and went over other findings and recommendations so client is aware there is other issues then just the minimum repairs and these can fail in future. Client stated he just wanted to go forward with only just doing the fan motor. Replaced and installed new one on and is operational. Cycled unit and unit is operational upon de

During my 20 point diagnostic, I started off with hosing down condenser coil of any dirt and debris. Opened condenser cabinet and checked everything thoroughly. Starter (good), fuses (good), motherboard (good), dual secondary motor control (good), 24v (good), 120v (good), refrigerant levels sh 21, sc 0, osa 83, delta 20. Then went onto the furnace and checked furnace cabinet thoroughly. Blower motor (good), single secondary motor control (good), motherboard (good), 24v (good), 120v (good). House cools great and ready for summer. Changed air filter with new 16*25*5

Technician arrived to perform spring tune up -Condensers were cleaned out with water and debris was removed -Refrigerant levels are within range -Filters are clean -Blower motors are clean and not drawing too much power -Condenser fan motor and capacitor replacement for downstairs system was recommended -Systems are both cooling and ready for summer

Arrived on site to diagnose a no cooling 2005 carrier unit. Spoke over with client and he stated unit is not working and thermostat display is blank and unit hasn’t worked since. Client are currently remodeling home. Client stated he’s had some issues in past and think is can be the same just unsure. Advised would inspect and advised of any concerns. Checked indoor unit and electrical electrical compartment. Unit is original to home. Found flex ducting Used blower assembly dusty from dirt entering unit in past years. Found no power at all to furnace. Inspected low and nothing. Traced back at transformer and nothing still traced back to outlet in attic and found was gettin power there but was not going into heater. Opened up conjunction box and found that high voltage wires have melted and burned up from drawing to much power. Took photos and showed client issues. Advised at minimum that would be replaced and wires cleaned up and secured to be able to continue inspection of unit. Re

Technician arrived to perform spring tune up for 16 y/o system -Condenser was thoroughly cleaned out and debris was removed -Refrigerant levels are within range -Filter is clean -Ducting is in tact and not leaking air -Blower motor is working properly and not drawing too much current -The condenser fan motor was original and really struggling to keep up -It was drawing 2.39 out of 2.4 amps and was leaking oil -Replacement of motor was highly recommended to boost longevity of the system -System is currently cooling and ready for summer

Upon arrival, client said system was installed 2 years ago. They just put in a condenser and rigged a 410 txv in the evap coil. System is low on charge. Leaking from the evap coil. Customer is getting multiple second opinions.

Outdoor Txv replacement, full vacuum and recharge.